lock AUDI A4 1995 B5 / 1.G Engine Oil Level Checking User Guide
[x] Cancel search | Manufacturer: AUDI, Model Year: 1995, Model line: A4, Model: AUDI A4 1995 B5 / 1.GPages: 111, PDF Size: 1.26 MB
Page 60 of 111

60
Lock cylinders, lubricating
- Lubricate with lock cylinder lubricant spray G
000 400 01.
Pa
ge 60 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 62 of 111

62
Door locks, locking buttons, child safety
lock - checking operation
WARNING!
Remove, clean, and grease all door locks
which do not operate freely.
Door locks and locking buttons:
- Open and close driver and front passenger door.
Check whether locking buttons move up and
down, respectively, when this is done.
- Press locking button on front passenger door
and rear doors down, close doors. Doors must
be locked.
It must not be possible to press down locking
button on driver door so long as door is open.
Child safety lock (rear doors):
- Move lever on door lock down in direction of
arrow (see marking on door lock). Door lever on
inside must be blocked and locking button must
be pulled up.
Pa
ge 62 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 70 of 111

- Loosening hand-wheel that locks column in
place.
- Sighting down through the slit in the Broad-band
sight and rotating Beamsetter box and column
until two similar points on vehicle are aligned.
Pa
ge 70 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 78 of 111

77
Checking wiper arm angle
- Bring wiper arms into park position.
- Remove wiper blade.
Specified values for angle of wiper arm to windshield - Insert wiper arm -2- into 3358 B windshield wiper adjuster and lock in
place with stop screw -3-.
- Compare displayed angle with specified value.
Driver's side
-3 Passenger side
-3 Tolerance
0
Pa
ge 78 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 79 of 111

78
Adjusting wiper arms
- Bring wiper arms into park position.
- Remove wiper blade.
- Place wiper arm -2- in 3358 B windshield wiper adjuster and lock in
place with stop screw -3-.
- Place 24 mm open end wrench -1- onto adjusting device as shown and
set wiper arm -2- to specified value (arrow)
Specified values Page 77
.
- Loosen stop screw -3- and remove wiper arm -2- from adjusting device.
- Again place wiper arm -2- into windshield wiper adjuster and again lock
in place with stop screw -3-.
- Compare displayed angle with specified value.
Specified values Page 77
.
- If necessary, repeat setting and checking procedure until specified
value is attained.
- Remove adjusting device and install wiper blade.
Pa
ge 79 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 89 of 111

88
Resetting service interval display
Vehicles from model year 1998 The service interval display must be reset as part
of the Pre-Delivery Inspection and also after
every Oil Change Service and Inspection
Service.
Delivery inspection
The service interval display can be reset using
one of two methods:
Using the adjustment buttons for the trip
recorder and clock on the instrument cluster
- Reset "service OIL" and "service INSP" Page 92
or
Using VAG 1551 Scan Tool
- Select adaptation channel 02 and enter
adaptation value "00000" Page 89
Pa
ge 89 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 94 of 111

92
Resetting service interval display with
adjustment buttons for trip recorder and
clock.
- Switch ignition off.
The trip recorder display -3- will read "service OIL".
Note:
Depending on the make of the instrument cluster, the display on the trip
recorder will either continue to read "service OIL" (Nippon Seiki) or
change to "- - -" (VDO).
The trip recorder display -3- will read "service INSP". - Press trip recorder reset button -2- on instrument cluster and at same
time switch ignition on.
- Release button.
- Pull clock adjuster button -1- on instrument cluster and hold for approx.
2 seconds. This resets "service OIL" display.
- Press trip recorder reset button -2- again to advance to next type of
service.
- Release button.
Pa
ge 94 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 95 of 111

93
Note:
Depending on the make of the instrument cluster, the display on the trip
recorder will either continue to read "service INSP" (Nippon Seiki) or
change to "- - -" (VDO). - Pull clock adjuster button -1- on instrument cluster and hold for approx.
2 seconds. This resets "service INSP" display.
- Switch ignition off.
Pa
ge 95 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 96 of 111

94
Clock, setting
Clock is included in tachometer display. To set
time, pull out instrument panel light dimmer
switch.
When switch is pulled out briefly, hands will
advance a minute at a time. Pulled out and held,
hands will advance slowly at first, then rapidly.
Pa
ge 96 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6