engine AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual A4 1997 B5 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1253/w960_1253-0.png AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual

Page 1 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-18
 
     
Transmission, removing and 
installing  
     
Special tools and equipment  
     
3282 transmission support
     3282/10 adjustment plate 
     3337 ring spanner 7-piece set
     VAG138

Page 3 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-19
      
4-cylinder engine 
    
-  Disconnect wires/and harness connectors as follows:
1 - At solenoid valve for wastegate bypass regulator valve -N75-
2 - At Evaporative Emission (EVAP) canister

Page 4 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-20
      
6-cylinder engine 
    
All models  -  Remove intake air duct -A- (arrows)
-  Unbolt coolant expansion tank -B- (arrows) and lay to one side.
-  Remove Heated Oxygen Sensors (HO2S) on lef

Page 5 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-21
 
    
4-cylinder engine  -  Remove bracket for noise insulation panel (arrow).
    
-  Remove heat shield (arrows -1- and -2-) above right drive axle.
Pa
ge 5 of 21 Transmission, removin
g and

Page 6 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-22
 
    
6-cylinder engine  -  Unbolt right transmission support together with bonded rubber mount 
(arrows). 
-  Loosen clamping sleeves of exhaust system and slide toward Three 
Way Catalytic Co

Page 7 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-23
      
All models  
    
Note:  
Take care not to damage protective coating on drive axles.  -  Remove engine speed (RPM) sensor -G28- on left of transmission 
(arrow) and move clear to side. 
-

Page 8 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-24
 
    
Notes:  
Starter cables do not have to be disconnected.  -  Remove starter from engine/transmission and secure if necessary   
Repair Manual, Electrical Equipment, Repair Group 27

Page 10 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-26
 
    
-  Remove bottom engine/transmission mounting bolts, except for bolts 
indicated by arrows -A- and -B-. 
    
Notes:  -  Set up 3282 transmission support for removing manual transmission

Page 12 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-28
      
4-cylinder engine 
    
-  Remove left transmission support from bonded rubber mount -2-.
    
6-cylinder engine 
-  Remove left and right transmission supports complete with bonded 
rubb

Page 13 of 21

AUDI A4 1997 B5 / 1.G 01A Transmission Remove And Install Workshop Manual 34-29
      
All models 
    
CAUTION! 
When lowering the transmission, make sure the hydraulic line/hose 
to clutch slave cylinder is not damaged.  -  Remove remaining engine/transmission mounting bo
Page:   1-10 11-20 next >