AUDI A4 1997 B5 / 1.G Brakes Read Mesure Value Block Manual PDF
Manufacturer: AUDI, Model Year: 1997, Model line: A4, Model: AUDI A4 1997 B5 / 1.GPages: 79, PDF Size: 0.24 MB
Page 71 of 79

01-112
Output on printer of
VAG1551 Scan Tool (ST) Possible cause
Corrective action
DTC
00597
Varying wheel speed impulse
ABS wheel speed sensor rotor dirty or
damaged.
Repair Manual, Brake System,
Repair Group 45
- Check rotor.
Excessive wheel bearing play.
Repair Manual, Brake System,
Repair Group 45
- Check wheel bearing
ABS wheel speed sensors -G44-, -G45-, -G46-,
and -G47- installed incorrectly. ABS wheel speed sensors -G44-, -G45-, -G46-,
and -G47- malfunctioning Repair Manual, Brake System,
Repair Group 45
- Check ABS wheel speed sensors.
- Carry out "electrical test", steps 7
through 10 page 01
-68
.
Wheel or tire sizes not the same on all four
wheels. - Check wheel and tire sizes.
Pa
ge 71 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 72 of 79

01-113
Output on printer of
VAG1551 Scan Tool (ST) Possible cause
Corrective action
DTC
00623
ABS / transmission electrical
connection Manual transmission:
This malfunction only
occurs if vehicle is
equipped with ASR.
ABS/EDL/ASR control module -J104- incorrectly
coded. Short circuit to B+ at terminal 45
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations - Check coding of
ABS/EDL/ASR control module -
J104- page 01
-56
.
- Locate and repair short circuit.
Automatic transmission:
Open circuit or short circuit to Ground (GND) in wiring
between ABS/EDL/ASR control module -J104- and
Transmission Control Module (TCM) -J217-. ABS/EDL/ASR control module -J104- incorrectly
coded.
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations - Check coding of
ABS/EDL/ASR control module -
J104- page 01
-56
.
- Locate and repair open circuit
or short circuit.
Pa
ge 72 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 73 of 79

01-114
Output on printer of
VAG1551 Scan Tool
(ST) Possible cause
Corrective action
DTC
00642
Right front traction
control switch-over
valve -N166-
Open circuit, short circuit to B+ or Ground (GND)
in wiring between ABS hydraulic unit -N55- and
ABS control module -J104-.
Right front traction control switch-over valve -
N166- malfunctioning. - Carry out "electrical test", steps 5 +18
page 01
-68
.
- If the electrical test does not reveal any
malfunctions, check all wiring and
connectors for loose contacts.
- If no problems are found after
implementing the specified steps, replace
the control module.
00643
Right front traction
control outlet valve -
N167-
Open circuit, short circuit to B+ or Ground (GND)
in wiring between ABS hydraulic unit -N55- and
ABS control module -J104-.
Right front traction control outlet valve -N167-
malfunctioning. - Carry out "electrical test", steps 6 +18
page 01
-68
.
- If the electrical test does not reveal any
malfunctions, check all wiring and
connectors for loose contacts.
- If no problems are found after
implementing the specified steps, replace
the control module.
Pa
ge 73 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 74 of 79

01-115
Output on printer of
VAG1551 Scan Tool
(ST) Possible cause
Corrective action
DTC
00644
Left front traction
control switch-over
valve -N168-
Open circuit, short circuit to B+ or Ground (GND)
in wiring between ABS hydraulic unit -N55- and
ABS control module -J104-.
Left front traction control switch-over valve -N168-
malfunctioning. - Carry out "electrical test", steps 5 +17
page 01
-68
.
- If the electrical test does not reveal any
malfunctions, check all wiring and
connectors for loose contacts.
- If no problems are found after
implementing the specified steps, replace
the control module.
00645
Left front traction
control outlet valve -
N169-
Open circuit, short circuit to B+ or Ground (GND)
in wiring between ABS hydraulic unit -N55- and
ABS control module -J104-.
Left front traction control outlet valve -N169-
malfunctioning. - Carry out "electrical test", steps 6 +17
page 01
-68
.
- If the electrical test does not reveal any
malfunctions, check all wiring and
connectors for loose contacts.
- If no problems are found after
implementing the specified steps, replace
the control module.
Pa
ge 74 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 75 of 79

01-116
Output on printer of VAG1551 Scan
Tool (ST) Possible cause
Corrective action
DTC
00646
ABS-ASR motor electrical connection 1
Open circuit or short circuit to B+ or Ground
(GND) in wiring between ABS control module
-J104- terminal 18 and Engine Control
Module (ECM).
Electrical Wiring
Diagrams, Troubleshooting &
Component Locations - Locate and repair open
circuit or short circuit.
Note:
The following signals are sent from the
ABS control module (w/EDL) -J104- to the
Engine Control Module (ECM) via this
connection:
MMD signal (Masked Misfire
Diagnostic) for On Board Diagnostic
(OBD)
SET signal (Specified Engine Torque)
ABS control module -J104- malfunctioningEngine Control Module (ECM)
malfunctioning.
- Replace ABS control
module (w/EDL) -J104-.
- Replace Engine Control
Module (ECM).
Pa
ge 75 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 76 of 79

01-117
Output on printer of VAG1551 Scan
Tool (ST) Possible cause
Corrective action
DTC
00647
ABS-ASR motor electrical connection 2
Open circuit or short circuit to B+ or Ground
(GND) in wiring between ABS control module -
J104- terminal 47 and Engine Control Module
(ECM).
Electrical Wiring Diagrams,
Troubleshooting &
Component Locations - "Read measuring value
block", display group 3
page 01
-67
.
- Locate and repair open
circuit or short circuit.
Note:
The following signal is sent from the
Engine Control Module (ECM) to the
ABS control module (w/EDL) -J104- via
this connection:
AET signal (Actual Engine Torque)
Engine Control Module (ECM) malfunctioning.
- Replace Engine Control
Module (ECM).
Pa
ge 76 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 77 of 79

ABS/EDL/ASR control module -J104-
malfunctioning. - Replace ABS/EDL/ASR
control module -J104-.
Pa
ge 77 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 78 of 79

01-118
Output on printer of VAG1551 Scan Tool (ST)
Possible cause
Corrective action
DTC
00668
Vehicle voltage terminal 30, open circuit
When equipped with EDL, the ABS control module
-J104- requires this voltage supply after ignition is
switched off in order to calculate the drop in brake
temperature; page 01
-39
.
Voltage supply to ABS control
module (w/EDL) -J104- (terminal
50) has an open circuit or short
circuit to Ground (GND). Electrical Wiring
Diagrams, Troubleshooting
& Component Locations - Check wire connection.
Pa
ge 78 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8
Page 79 of 79

01-119
Output on printer of
VAG1551 Scan Tool
(ST) Possible cause
Corrective action
DTC
00761
DTC stored in Engine
Control Module (ECM)
This malfunction only
occurs if vehicle is
equipped with ASR.
A DTC was stored in the Engine
Control Module (ECM). The Engine
Control Module (ECM) is not able to
reduce engine torque. - Repair the engine management malfunction using
the appropriate engine repair manual and erase
DTC memory of the Engine Control Module (ECM).
65535
Control module
malfunctioning ABS control module -J104-
malfunctioning
Note:
Do not erase DTC memory in this case. The data
stored in the DTC memory provides information
about the cause of the malfunction. This information
helps to continually improve the product. - Replace ABS control module (w/EDL) -J104-.
Pa
ge 79 of 79 Read Measurin
g Value Block
(function 08
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.8