coolant temperature AUDI A4 1998 B5 / 1.G AC System On Board Diagnostic Workshop Manual

01-29

VAG1551 scan tool display
Possible cause
Corrective action
00797 3241
Sunlight Photo Sensor G107

Open circuit/short circuit to positive /SP

Short circuit to ground /SP - Short circuit or open
circuit
between -G107- and -
E87-
- Connections to -
G107-
interchanged
- -G107- malfunction- Diagnose and repair short circuit or open circuit in
wiring using wiring diagram
- Confirm connection using wiring diagram

- Test G107 using function 08
(Read measuring value block) page 01
-63
- Replace -G107-
00799 3243
A/C Engine Coolant Temperature (ECT)
Sensor G1101)

Open circuit/short circuit to positive /SP

Short circuit to ground /SP - Short circuit or open
circuit
between -G110-1) and
-E87-
- -G110-1) malfunction- Diagnose and repair short circuit or open circuit in
wiring using wiring diagram
- Test -G110-1) using function 08
(Read measuring value block)
page 01
-63

1) Not on USA/CDN models.
Pa
ge 39 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-37

VAG1551 Scan Tool display
Possible cause
Corrective action
01582
Coolant Temperature Signal
Short circuit or open circuit between
instrument cluster and A/C control head -
E87- - Locate short circuit or open circuit
according to wiring diagram and repair
Short circuit to
Ground /SP
Open/Short circuit
to B+ /SP
Incorrect
Signal /SP Instrument cluster malfunctioning- Check signal from instrument cluster.
Note:
The DTC "Coolant Temperature Signal" is only recognized by A/C control heads -E87- with one display.
Pa
ge 50 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-38
Diagnostic Trouble Code (DTC) table, changes specific to vehicles 1997

Notes:
The following DTCs are no longer recognized beginning m.y. 1997:

00529 Speed info missing (sensor -G111- deleted).
00799 A/C engine coolant temperature (ECT) sensor -G110- (sensor deleted).
00801 A/C refrigerant high pressure switch -F118- (switch deleted).
01270 A/C clutch -N25- (Sensor -G111- deleted).
The following DTCs are new for 1997, or are current DTCs with additional references to 1997 changes. DTCs and component
references include various malfuction causes in the display below the DTC, etc.
VAG1551 scan tool display
Possible cause
Corrective action
00604
Back Pressure Flap Motor
Position Sensor -G113- in Air
Flow Flap Motor -V71-1)

Short circuit to ground /SP
Open circuit/short circuit to
positive /SP - Short circuit, open circuit in wiring or incorrect
terminal assignment (wires interchanged) of
connectors between -G113- and -E87-
- Air flow flap not operating freely
- -G113- in -V71- inoperative- Diagnose and repair short circuit,
open circuit in wiring or confirm
terminal assignment using wiring
diagram

- Check for free operation of air flow
flap3)
- Replace -V71-
Pa
ge 51 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-39

VAG1551 scan tool
display Possible cause
Corrective action
00792 3224
A/C Pressure Switch
-F129-

Short circuit to
ground /SP - Open circuit in wiring/connections between -F129-
and -E87-
- Malfunction in operation of coolant fan -V7- (stage 1)


- Condenser or radiator dirty.
- Malfunction in operation of coolant fan -V7- (stage 2)
by A/C pressure switch -F129-
- -F129- malfunction
- Excess or low refrigerant system pressure- Diagnose and repair short or open circuit
in wiring using wiring diagram.
- Test fan operation -V7- (stage 1) using
function 03 (Output DTM)
page 01
-42

- -V7- electrical test
page 01
-115
.
- Clean condenser and radiator.
- Test -V7- (stage 2) via A/C pressure
switch -F129- page 87
-67
).
- Test -F129- page 87
-67
.
- Check refrigerant system pressures
page 87
-192
.
Notes:

A/C pressure switch -F129- contains 2 switching elements. Via terminals 1 & 2, the compressor is shut off due to low or
excess refrigerant system pressure (switch open). Via terminals 3 & 4, the second speed coolant fan is switched on
(switch closed).
When -F129- terminals 1 & 2 open, excess refrigerant pressure is initially recognized by A/C control head -E87- and a
DTC is stored. If the measured outside temperature is between 0 C & 50 C (32 F & 122 F) and -F129- terminals 1 &
2 remain open for longer than 30 seconds, -E87- switches over from excess pressure to low pressure (Low pressure
switch function) page 01
-86
, Read measuring value block (Display group 01 compressor shut-off conditions).
Pa
ge 53 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-42

Output Diagnostic Test Mode (DTM)
(function 03)


Function
Output DTM allows functional checking of A/C
control head actuated components (DTM
components). Actuators receive output signals
generated by the control head via VAG1551
Scan Tool (ST) in sequence. Function is
confirmed in accordance with specified
responses.
The following components are tested in
sequence using Output DTM:

1 - A/C Clutch -N25-

2 - Fresh Air Blower -V2-

3 - Coolant Fan -V7-

4 - Fresh Air/Recirculating Flap Two-Way Valve
-N63-1)

5 - Temperature Regulator Flap Motor -V68-

6 - Central Air Flap Motor -V70-
Pa
ge 57 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-43
Notes:

During Output DTM on vehicles with Control Head (E87) Part Number 8D0 820 043 D, A/C Compressor Clutch (N25) DTC
"01270, mechanical malfunction SP" may be stored even though no malfunction is present. Corrective action: When
output DTM is complete, check DTC memory. If above DTC is present, erase DTC memory.
When starting Output DTM, temperature and air distribution flap flap motors move to pre-determined positions in
preparation for individual tests: Temperature Regulator Flap Motor V68: moves to "heat" position. Central Air Flap Motor -
V70- moves to "floor & defroster outlet" position. Footwell Defroster Flap Motor V85 moves to "defrost" position.
Output DTM can be repeated several times, if necessary.
During Output DTM, vehicle must not be moved and engine speed must be less than 3000 rpm.
During Output DTM, A/C system control is switched off and all segments in both A/C control head displays are actuated.
Interior temperature sensor fan -V42- is activated via an A/C control head:
with one display after activation of the coolant fan.
with two displays after activation of air flow flap motor.
Outside air temperature display -G106- is activated via an A/C control head
with one display after activation of air flow flap motor.
with two displays after activation of idle regulation.
Pa
ge 59 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1

01-54

Notes:

For m.y. 1996, because A/C engine coolant
temperature sensor G110 is not installed on
USA/CDN models, during basic setting, DTC
"00799 engine coolant temperature sensor
G110" is stored and must be erased.
For m.y. 1997 A/C engine coolant temperature
(ECT) sensor -G110- is deleted, and will no
longer load a DTC when checking DTC memory
after ending basic setting.

- Check DTC memory page 01
-18
.

- Erase DTC memory (function 05) and end
output (function 06) page 01
-55
.
Pa
ge 76 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1