battery AUDI A4 1998 B5 / 1.G APB Engine Motronic Syst

01-9

Vehicle diagnostic, testing and
information system VAS5051 or
VAG1551, connecting and selecting
functions


Requirements

Fuses for engine electronics OK
Fuel pump relay OK
Battery voltage at least 11 V
Ground (GND) connection for engine and
transmission OK

- Switch ignition off.

Note:
The Data Link Connector (DLC) is located below the dash, to the left of
the steering column. - Connect vehicle diagnostic, testing and information system VAS5051
with VAS5051/1 diagnostic cable. As an alternative, connect VAG1551
scan tool with VAG1551/3B diagnostic cable.
Pa
ge 11 of 166 Motronic s
ystem, On Board Dia
gnostic
(OBD
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.01.1

01-19
Diagnostic Trouble Code (DTC) table

Notes:

If malfunctions occur in the sensors and components being monitored, they will be stored in the DTC memory together
with an indication of the type of malfunction. Notes on Engine Power Control (EPC) (drive by wire) Page 24
-139
.
Malfunctions relating to the electronic throttle are also indicated by the EPC (Electronic Power Control) warning light in the
instrument cluster.
Malfunction which decrease exhaust emissions are indicated by an Exhaust Malfunction Indicator Light (MIL), the MIL is
located in the instrument cluster. As soon as certain malfunction are recognized, the MIL is switched on immediately.
There are also malfunctions, were the MIL is switched on only after the engine is started again.
Sporadically occurring malfunctions (temporary malfunctions) will be indicated on the VAG1551 display as "SP."
The DTC table is arranged according to the 5-digit DTC in the left-hand column.
If a malfunction is stored in the DTC memory and then does not occur again during the next 40 engine warm-up phases,
the DTC will be automatically erased.
Components that are indicated as being faulty by the VAG1551 should not be replaced immediately. Always start by
checking the wiring, connectors and Ground (GND) connections for the component using the current wiring diagram. This
is particularly important in the case of sporadic malfunctions (indicated by the letters "SP"on the scan tool display).
If the connector for the engine control module is disconnected or if the battery is disconnected, all the learned values
(adaptation values) stored in the control module will be erased, although the contents of the DTC memory will remain
intact. The next time the engine is started the idling may be rough at first. In this case let the engine run at idle for a few
Pa
ge 22 of 166 Motronic s
ystem, On Board Dia
gnostic
(OBD
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.01.1

01-66

DTC
Description of malfunction
Corrective action
SAE
VAG


P1558 17966 Throttle Actuator
Electrical Malfunction
1)3)
- Check throttle valve control module Page 24
-145
P1559 17967 Idle Speed Contr. Throttle Pos.
Adaptation Malfunction
2) - Perform adaptation Page 24
-146
P1560 17968 Maximum Engine Speed Exceeded
- Repair mechanical damage
P1564 17972 Idle Speed Control Throttle Position
Low Voltage During Adaptation - Charge battery or repeat adaptation Page 24
-146
P1565 17973 Idle Speed Control Throttle Position
Lower Limit not Attained
1) 3)
- Check throttle valve control module Page 24
-145
P1568 17976 Idle Speed Control Throttle Position
Mechanical Malfunction
1) 3)

1) With this malfunction the EPC (Electronic Power Control) Malfunction Indicator Light (MIL) in the instrument cluster is
switched on by the ECM. Significance of EPC malfunction indicator light Page 24
-142
.
2) With this malfunction the exhaust Malfunction Indicator Light (MIL) is only switched on by the ECM, if the malfunction is
recognized after the engine has been restarted. Significance of MIL Page 01
-3 .
3) With this malfunction the exhaust Malfunction Indicator Light (MIL) is switched on by the ECM, immediately after the
Pa
ge 79 of 166 Motronic s
ystem, On Board Dia
gnostic
(OBD
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.01.1