AUDI A4 1999 B5 / 1.G Door Mirrors Workshop Manual

66-14


Door mirrors Door mirrors, removing and installing

Note:
On vehicles with seat memory, door trim must be
removed before removing mirror adjustor. 1 -
Mirror housing
Can be removed from door without
removing mirror completely page 66
-16

2 -
Mirror adjustor
Before removing, remove mirror from door
- To remove, pry off mirror glass,
disconnect harness connectors for mirror
heating, remove phillips head screws -6-
and take mirror adjustor -1- out of mirror
housing.
3 -
Door component carrier
4 -
Socket head screw 12 Nm (9 ft lb)
5 -
Seal Check for correct fit during installation.
Pa
ge 1 of 4 Door mirrors
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD01.66.8

66-15


6 -
Phillips head screw
1 Nm (9 in. lb)
7 -
Mirror glass
- To remove, use special tool 80-200
(assembly lever). Use fabric reinforced adhesive tape at top
and bottom to protect mirror housing from
paint damage
- Pry mirror out at bottom first, then top.
- To install, first insert mirror lens into
guide stud and friction finger in friction
spring, then press on. Apply pressure only to center of lens;
always wear protective gloves
8 -
Friction finger Friction finger -8- must be pushed into
friction spring -9- when inserting mirror
glass in housing
9 -
Friction spring
Pa
ge 2 of 4 Door mirrors
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD01.66.8

66-16

Door mirror housing, replacing


- Remove mirror glass.

- Remove screws -4- (2x).
- Press back retainers -2- and take off cover -3- downward.
- Remove screws -1- at mirror adjusting unit (3x).
- Lift up housing -5- and remove.
Pa
ge 3 of 4 Door mirrors
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD01.66.8

66-17

Power mirror adjuster, replacing


- Disconnect battery.

- Remove mirror glass.

Note:
For mirror adjusting units with soldered wires, these should be separated
individually directly at the housing.
Note:
Transfer wire routing from old power mirror adjuster using correct wiring
diagram. - Remove screws -1- (3x)
Tightening torque: 1 Nm (9 in. lb)
- For mirror adjusting units with harness connectors, these should be
removed before disassembly.
- Install wiring into connector housing enclosed with replacement unit.
Pa
ge 4 of 4 Door mirrors
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD01.66.8