catalytic converter AUDI A6 1995 C5 / 2.G 01E Transmission Remove And Install Workshop Manual

34-27


Note:
Avoid excessive bending of the flexible pipe connection (decoupling
element) on the front exhaust pipe. The angle between the catalytic
converter and the front exhaust pipe must not exceed 10 , otherwise the
flexible connection will be damaged. - Loosen clamp -3-, lift heat shield -2- slightly and unscrew remaining
nuts -5-.
- Lift heat shield -2- and pull out front exhaust pipe together with catalytic
converter -4-.
- Note that oxygen sensor -1- and oxygen sensor wire have to be guided
through opening in heat shield -2-.

A - Axle stand
B - V.A.G 1383A - Lift the transmission for access to the two lower bolts securing engine
to transmission ( A34-0173 below).
Pa
ge 10 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.2

34-37

Component

Nm
Clutch slave cylinder to transmission
1)
20
Transmission support to transmission 40
Engine speed sender -G28- 10
Drive axle to drive flange M8
M10 40
80
Heat shields above drive axles to
transmission 25
Push rod to transmission 40
Selector rod to transmission 23
Connecting rod for selector rod to
transmission 23
Catalytic converter to mounting lugs 25
Front exhaust pipe to turbocharger 30
Heat shield to turbocharger/exhaust pipe 10
Clamp for exhaust pipe 40
Bracket for noise insulation to subframe 10
Driveshaft to transmission
1)
55
Heat shield for driveshaft to Torsen
differential cover 25

1) Always replace bolts
Pa
ge 20 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.2