wiring AUDI A6 1995 C5 / 2.G AEB ATW Engines Engine Assembly Workshop Manual

13-2


Repair Manual, Body Exterior, Repair Group 63
- Remove front bumper.
- Remove 3 quick-release screws on front of noise
insulation panel.
- Unbolt air guide between lock carrier and air filter
at lock carrier.
- If installed, remove retaining clamps for wiring
harness on left side of radiator frame.
- Remove bolt -2- and install 3369 support tool.
- Install 3369 support tool into left bore -5-.
- Remove bolts -1- and -3-.
- Remove bolts -4- and pull lock carrier out to
stop.
- To secure lock carrier, install appropriate M6
bolts into rear bored holes of lock carrier -6- and
fender -7-.
Pa
ge 2 of 38 En
gine, disassemblin
g and assemblin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.13.1

13-3


Repair Manual, Body Exterior, Repair Group 63
- After installing lock carrier, check wiring for
proper routing near coolant fan.
- Install front bumper.
Pa
ge 3 of 38 En
gine, disassemblin
g and assemblin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.13.1

13-7


Note:
For easier installation of generator into the bracket,
push back lower bolt bushing slightly. 17 -
Generator
Removing:
- Disconnect battery Ground (GND) strap.
- Loosen ribbed belt and remove from
generator Page 13
-15
.
- Remove air guide at throttle body.
- Remove upper and lower threaded
assemblies.
- Swing generator slightly to side and
remove lower bolt.
- Remove wiring from generator.
- Remove generator.
18 -
Bolt
40 Nm (30 ft lb)
19 -
Bolt 40 Nm (30 ft lb)
20 -
Brace To cylinder block
Pa
ge 7 of 38 En
gine, disassemblin
g and assemblin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.13.1