AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual A6 1998 C5 / 2.G AUDI AUDI https://www.carmanualsonline.info/img/6/1318/w960_1318-0.png AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual
88 100 319

Page 1 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-1
 
  
Shift control mechanism, 
servicing Part I
 
Notes: 
 
Grease bearings and sliding surfaces with 
polycarbamide grease, part nr. G 052 142 A2. 
 Adjusting shift control mechanism   Page 34
-

Page 2 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-2
 
  
8 - 
Nut, 8 Nm 
9 - 
Noise insulation cover 
10 - 
Shift control mechanism with shift 
housing 
11 - 
Nut, 10 Nm 
Pa
ge 2 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0

Page 3 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-3
 
  
Part II
 
1 - 
Shift control mechanism with shift 
housing 
2 - 
Tensioning ring 
3 - 
Boot Carefully pull over shift rod during removalSet onto marks of shift rod and pivot rod 
when instal

Page 4 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-4
 
  
7 - 
Nut, 25 Nm 
8 - 
Connecting rod 
Do not disconnect from shift rod; observe 
note  Page 34
-9 
9 - 
Bolt, 25 Nm 
10 - 
Washer 
11 - 
Socket head bolt, 25 Nm 
12 - 
Front shift rod 
With

Page 5 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-5
      
Selector mechanism, removing and 
installing
 
     
Removing  
     
-  Unscrew shift knob from shift lever.
     
Note:  
     Shift cover is removed together with the cover for 
center

Page 6 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-6
 
    
-  Remove noise insulation cover for shift mechanism housing (arrows).
    
-  Unscrew nuts securing shift mechanism housing (arrows).
Pa
ge 6 of 17 Shift control mechanism, servicin
g
11/

Page 7 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-7
 
    
 Repair Manual, 2.7 Liter V6 5V BiTurbo Engine Mechanical, Engine 
Code(s): APB, Repair Group 26
    -  Remove heat shield for left-hand inner joint -1- from transmission 
(arrows). 
-  Di

Page 8 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-8
 
    
-  Unscrew bolts -1- and -2- on left and right.
    
-  Lower subframe at the rear.
-a- = max. 50 mm
Pa
ge 8 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/aud

Page 9 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-9
      
Important notice for the following 
procedures:  
    
Under no circumstances may the ball head (arrow -A-) of connecting rod -
2- be pulled off shift rod -1- during removal of shift linka

Page 10 of 17

AUDI A6 1998 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual 34-10
 
    
Installing  
Installation is carried out in the reverse order, when doing this note the 
following:  
 Repair Manual, 2.7 Liter V6 5V BiTurbo Engine Mechanical, Engine Code(s): APB, Repai
Page:   1-10 11-20 next >