AUDI A6 2000 C5 / 2.G 01V Transmission Read Measuring Value Block E18/2 Service Manual

01-261

Display
group
number Display
field Description
Test requirements
Spec. value on
V.A.G1551
display Corrective actions
013
1)
1 CAN-bus
normalizing torque While standing with
ignition switched on Nm
2 CAN-bus engine
code
0 ... 63
- See DTC table, DTC
18157/P1749 and 18249 /
P1841 page 01
-45

3 CAN-bus
Transmission
code
1
- Check coding of Engine
Control Module (ECM)
4 CAN-bus software
version code
0 ... 63
- See DTC table, DTC 18263 /
P1855 page 01
-45

1) This display group number is not displayed until model year 2000 (May 1999)
Notes for display group number 013;
Display field 2 and 4: When replacing the ECM, the same indication that appeared for the old control module should
appear after installation. If this is not the case, the wrong ECM was installed, or it is wrongly coded.
Pa
ge 41 of 42 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E18/2-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.14

01-262

Display group
number Display
field Description
Test
requirements Spec. value on
V.A.G1551
display Corrective actions
125 1
Reception of an engine
message via the CAN-bus While driving
1)
Received 1
- See DTC table, DTC
18258 / P1850 page
01
-45



Not received
0
2)
- Perform electrical test
page 01
-273


2
Reception of an ABS
message via the CAN-bus While driving
1)
Received 1
- See DTC table, DTC
18259 / P1851 page
01
-45



Not received
0
2)
- Perform electrical test
page 01
-273

1) While driving, a second mechanic is required to read specifications. 2) If "0" is shown and there are no DTCs stored in memory, the relevant control module is not CAN capable (or is faulty).
Pa
ge 42 of 42 Read Measurin
g Value Block
(scan tool function 08
) for transmissions with h
ydraulic control -E18/2-
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.14