change wheel AUDI A6 2020 Owner's Manual

Wheels

If the tire pressure monitoring indicator
appears
Applies to: vehicles with Tire Pressure Monitoring System in-
dicator
The tire pressure indicator in the instrument
cluster informs you if the tire pressure is too low
or if there is a system malfunction.
Using the ABS sensors, the tire pressure monitor-
ing system compares the tire tread circumference
and vibration characteristics of the individual
tires. If the pressure changes in one or more
tires, this is indicated in the instrument cluster
display with an indicator light (J and a message.
If only one tire is affected, the location of that
tire will be indicated.
The tire pressures must be stored again each
time you change the pressures (switching be-
tween partial and full load pressure) or after
changing or replacing a tire on your vehicle
= page 264. The tire pressure monitoring system
only monitors the tire pressure you have stored.
Refer to the tire pressure label for the recom-
mended tire pressure for your vehicle
=> page 255, fig. 165.
Tire tread circumference and vibration character-
istics can change and cause a tire pressure warn-
ing if:
— The tire pressure in one or more tires is too low
— The tires have structural damage
— The tire was replaced or the tire pressure was
changed and it was not stored > page 264
— Tires that are only partially used are replaced
with new tires
Indicator lights
If the @ indicator light turns on, there is a loss
of pressure in at least one tire .> A\ Check the
tires and replace or repair if necessary. Check and
correct
the pressures of all four tires and store
the pressure again > page 264.
ia Tire pressure: malfunction! See owner's
manual
if io appears after switching the ignition on or
while driving and the @ indicator light in the in-
strument cluster blinks for approximately one
264
minute and then stays on, there is system mal-
function. Try to store the correct tire pressures
= page 264. In some cases, you must drive for
several minutes after storing the pressures until
the indicator light turns off. If the indicator light
does turn off or turns on again after a short peri-
od of time, drive to an authorized Audi dealer or
authorized Audi Service Facility immediately to
have the malfunction corrected.

ZA\ WARNING
— If the tire pressure indicator appears in the
display, reduce your speed immediately and
avoid any hard steering or braking maneu-
vers. Stop as soon as possible and check the
tires and their pressure.
— The driver is responsible for maintaining the
correct tire pressure. You must check the
tire pressure regularly.
— Under certain conditions (such as a sporty
driving style, winter conditions, or unpaved
roads), the tire pressure monitoring system
indicator may be delayed.

G) Tips
—The tire pressure monitoring system can al-
so stop working when there is an ESC mal-
function.
— Using snow chains may result in a system
malfunction.
—The tire pressure monitoring system in your
Audi was calibrated with “Audi Original
Tires” > page 252. Using these tires is rec-
ommended.
Storing tire pressures
Applies to: vehicles with Tire Pressure Monitoring System in-
dicator
If the tire pressure changes or a tire is replaced,
it must be confirmed in the MMI.
> Before storing the tire pressures, make sure the
tire pressures in all four tires meet the speci-
fied values and are adapted to the load
=>page 255.
> Switch the ignition on.
> Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Tire pressure >

Emergency assistance

> Inflate the tire to between 29 psi (200 kPA)
and 36 psi (250 kPA) and read the pressure on
the gauge.
> If this tire pressure is not reached, remove the
filler hose. Drive slowly approximately 33 feet
(10 m) forward or in reverse so that the sealant
can be distributed in the tire. Inflate the tire
again > A\.

Z\ WARNING
— Read and follow the manufacturer's safety
precautions on the compressor and in the in-
structions on the bottle of sealant.
— Ifa tire pressure of 29 psi (200 kPA) cannot
reached after inflating for 6 minutes, then
the tire is too severely damaged. Do not con-
tinue driving.
— If the tire cannot be repaired with the tire
sealant, see an authorized Audi dealer or au-

thorized Audi Service Facility for assistance.

@ Tips
Do not operate the compressor for more than
six minutes continuously, or it can overheat.
Once the compressor has cooled, you can con-
tinue to use it.
Completing
Applies to: vehicles with tire mobility kit
> Affix the sticker that says "max. 50 mph (max.
80 km/h)" that is provided with the tire mobili-
ty kit within the driver's field of vision.
> Stop the vehicle after driving for about 10 mi-
nutes and check the tire pressure.
> If the tire pressure is lower than 19 psi (130
kPA), then the tire is too severely damaged. Do
not continue driving.

ZX WARNING
Pay attention to the following after repairing
the tire:
— Do not drive faster than 50 mph (80 km/h).
— Avoid hard acceleration or braking and driv-
ing fast around curves.
— The vehicle may become more difficult to
control.

274

— If the tire is too severely damaged, see an
authorized Audi dealer or authorized Audi
Service Facility for assistance.

(@) For the sake of the environment
You can give the used tire sealant bottle to an
authorized Audi dealer or authorized Audi
Service Facility for disposal.
G) Tips
Remember to obtain a new bottle of sealant
from an authorized Audi dealer or authorized
Audi Service Facility after repairing a tire.
Replacing wheels
You must complete the preparation before
changing a tire.
> Read and follow the important safety precau-
tions > page 272.
> Set the parking brake.
> Select the “P” position.
> When towing a trailer: disconnect the trailer
from your vehicle.
> Lay out the vehicle tool kit > page 272 and the
spare tire > page 278.
> Applies to: vehicles with air suspension: Select
on the home screen: VEHICLE > Settings &
Service > Air suspension: wheel change.
> Switch the ignition off.

ZA\ WARNING
The vehicle must also be secured to prevent it
from rolling when using the vehicle jack*. Use
suitable objects to block the front and back of
the wheel that is diagonal from the wheel
with the flat tire.

Emergency assistance

Raising the vehicle
Applies to: vehicles with vehicle jack





Fig. 174 Sill: positioning the vehicle jack
> Place the vehicle jack from the vehicle tool kit
ona firm surface. Use a flat, stable support if
necessary. On a slippery surface such as tile,
you should use a non-slip pad such as a rubber
mat > /\.
> Find the marking on the sill that is closest to
the tire that will be changed > fig. 173. Behind
the marking, there is a lifting point on the side
sill for the vehicle jack.
> Raise the vehicle jack under the lifting point on
the side sill until the bracket on the jack @)
completely covers the notch on your vehicle.
> Align the vehicle jack so the bracket @) covers
the notch and the base (2) is flat on the ground.
The base @) must be directly under the mount-
ing point @.
> Mount the crank on the vehicle jack: insert the
crank into the opening on the handwheel. Turn
the crank to the left or right to secure it.
> Continue raising the vehicle jack with the crank
until the wheel lifts off the ground slightly.
276

Z\ WARNING
—To reduce the risk of injury, make sure no
one is in the vehicle before raising it.
— Make sure the vehicle jack is stable. The risk
of injury is increased when the ground is
slippery or soft, because the vehicle jack
could slide or sink.
— Only raise your vehicle with the vehicle jack
provided by the factory. If you use a vehicle
jack designed for another vehicle, your vehi-
cle could slip and cause injury.
— Position the vehicle jack only at the desig-
nated mounting points on the side sill and
align the jack. Otherwise, the vehicle jack
could slip and cause an injury if it does not
have sufficient hold on the vehicle.
—To reduce the risk of injury, do not raise any
other vehicles or other loads using the vehi-
cle jack provided by the factory.
— Applies to: vehicles with air suspension:
Changes in temperature or load can affect
the height of the stopped vehicle.
—To reduce the risk of an accident, never start
the engine when the vehicle is raised.
—To reduce the risk of injury, no work should
be performed under the vehicle while it is
raised.

() Note
Do not lift the vehicle by the sill. Position the
vehicle jack only at the designated mounting
points on the side sill. Otherwise, your vehicle
could be damaged.

4K0012721BD

TAROS csscors 3 ceesens «wma ¥ aoe ¥ ROME wo eee 245
Loose wheel warning...............008 260
Low-profile tires ..... 06.0.0 cece ee eee 262
REpaitiSetbi. s wean vs eseweue © mamas sv memes ay oe 272
Replacing. ......... 00. c eee eee eee 274
Service lif@iin « s wemy ¢ » sees 2 eae & Meee & 254
THEPreSSUFGtins 6 a ese ¥ 6 sees 6 wea © wee 255
Tire pressure monitoring system .... 263, 264
Tite pressure table: ¢.cs% : veces reams ee 257
Tire pressure (trailer mode)............ 115
Treadwear indicators...............00- 254
Unidirectional................004 247,277
Uniform tire quality grading............ 262
Tires and wheels
Glossary of tire and loading terminology.. 248
Tires and vehicle load limits............ 258
Tool... eee 272
Tooltips. ...... 0... eee eee eee eee 20
Top tether anchor (securing the child safety
Seat)... eee 78
Touch display
Adjusting feedback...............00005 20
OPerating « & ssi so seve 3 0 meee + BOI nv RE 18
TOWING’: » ¢ ews sy eewe © 6 pew gs eee 5 eae 281
TOWING LOOP wsses + ¢ exes 2 o eeaw ce ews 282, 283
Towing protection monitoring............. 35
TPMS
Tire pressure monitoring system........ 264
Traffic (Nforination = cess = x aes « sees 4 2 nox 197
Traffic light information................ 125
Traffic sign recognition................. 123
Traffic SIGNS... ee eee ee 126
Trailer mode
Airsuspension...............2..0-00- 115
Trailer mode (navigation) .............. 199
Trall@C HOWiNG iss + © seme = & wees 2 o eee 2 nae 115
Tongue Weights. « sissies o ese ao aenvne © # arene L115
Trailer load... 2... eee eee eee eee ee 115
Turn assist... 2.0... e eee eee eee 148
Turn signals ........ 0.0.00 eee eee eee 50
U
Uniform tire quality grading............. 262
Unlocking and locking. ...............005 32
By remote control..............-..00-- 37
Using the lock cylinder..............-.. 35
With the central locking switch.......... 34
With the convenience key............... 37
Update (software) ..............22-000. 224
Updating stations (radio)................ 201
USB
Adapter... 0.2... 0 cece cee 166
USB charging port......... 0. eee 80
USB stick
refer to Audi music interface........... 212
Using residual heat... ..... 2... e cece eee 90
V
Valet parking.......... 0. cece eee eee 46
Vanity iP ccs 2 samen © esaneas a 2 mere © 8 vennaes © 55
Vehicle
Angle... .. cece cece cece eee 106
Care/cleaning = wes: sv see = vee ¢ = wees es 266
DIMENSIONS ese 2 2 sae 2 omen 3s eee 2 8 298
Identification data................00. 298
QUEGRSENVICE was 2 x ueme x x cee 5 ewe 8 2 271
Raising). « essen 5 % ese ¥ 2 emuas 6 6 amenens a & sure 276
Starting. ..... 0.2... eee 93
TANSPONE sass = 5 woee 5 Bae8 Bs HU Ek 109
Vehicle care... 2. eee eee eee eee 266
Vehicle control services.............0-5- 179
Vehicle data label..... 0... 2. eee eee eee 298
Vehicle identification number............ 298
Vehicle jack. « vccscie a x anecnce a o areata xu axon @ as 272
Lifting points... ......... 2... eee eee 276
Tire change mode...........-..-+-05- 274
Vehicle key... 2.0.0... cece eee eee 32, 36
Vehicle start system ........0...000 000s 102
Vehicle tool kit.......... 00... eee eee eee 272
Ventilation. . . crc a 0 senoe eu neon» 6 sonmpes a8 88
VIEW DUE OM ies « « sxccns © 2 omens « 6 ise = em 13
Voicemail. «5 css 2 2 wae so mern «2 ewe a 2 170
Voice recognition system..........-....-5 27
Extterimall sisson so ssnmce « oxenens oo seein oo someone 28
Operating................0.00.00.0000. 27
Ww
Warning lights
refer to Indicator lights.................. 7
Washing matte finish paint.............. 266
Weights ............ 0c eee eee eee eee 299