heater AUDI S3 2015 User Guide

2 78 Fuses and bulbs
No . Equipment Ampere
Door/front passenger's side
F39 doors (for example, power 30
windows)
F40 Sockets 20
F41 Reversible front passenger·s
25
side safety belt tensioners
F42 Central locking components,
40
windshield washer system
F43 Headlights , light ing 30
F44 all wheel drive
15
F49 Starter, clutch sensor, head-
s light
relay coil
FS3 Rear window defogger
30
The power seats* are protected via
circuit
breakers
that automatically switch on after a
few seconds after the overload has been re­
duced.
@ Tips
Note that the following table was accurate
at the time of print ing and is subject to
change.
Left engine compartment fuse
assignment
Fig. 189 Engine compartment : fuse assignment
No.
Fl
F2
F3
F4
F5
F6
F7
F8
F9
FlO
Fll
Fl2
Fl3
Fl5 Fl6
Fl7
Fl8 Fl9
F20 F22
F23
F24
F3 1
F32
Equipment Ampere
ESC control modu le 40
ESC cont rol module 40
Engine control module (gas-
15/30
oline/diesel)
Engine cooling, engine com-
ponents, auxiliary heater 5/10
coil relay (1+2), secondary
air injection pump relay
Engine components, tank 7.5/10/
system 15
Brake light sensor
5
Engine components, water 7.5/10/
pumps 15
Oxygen sensor 10/15
Engine components, ex-
haust door, glow t ime con-
5/10/20
trol module, SU LEV valve
Fuel injectors, fuel control
15/20
module
Auxiliary heater heating ele-
40
ment2
Auxi lia ry heater heating ele-
40
ment 3
Automatic transmission con- 15/30
trol module
Horn 15
Ignit ion coil 5/20
ESC contro l module, engine
7.5
control module
T ermina l 30 (reference volt-
5
age)
Windshield wipers 30
Horn 10
Terminal SO diagnosis 5
Starter 30
Auxiliary heater heat ing ele-
40
ment 1
Vacuum pump 15
LED headlights 5

....,
N
0 > co
rl I.O
"'
@ Tips
The discharged battery must be pr operly
connected to the vehicle's electrical sys­
tem. When jump starting or charg ing the
battery, never connect the negative
ground cable to the batte ry negative post
because the ba ttery manager system must
be able to detect the battery's state of
charge. Always connec t the negative
g roun d cab le to t he negative ground pos t
of t he battery manager cont ro l unit.
Using jump start cables
Connect the jump start cables in the e xact or ­
der described below .
Fig . 190 Eng ine co mpar tment : connecto rs for jum p
star t cab le s an d a charger
Fig. 1 91 Jump start in g the batte ry w ith anot her ve hi­
cle: @-dra ined battery ,@ -starte r bat tery
The batte ry is located to the left in the eng ine
compartment.
Do not jump start a frozen or
thawed battery
¢ A in Starting with jumper
cables on page
280 ! Replace the battery. The
p rocedu re for connecting jump start cab les
that is descr ibed next is designed to he lp
jump sta rt your ve hicl e.
Vehicle with drained battery:
~ .. Read the following carefully ¢ page 280 rl
Emergency situ ation s 281
.. Set the parking brake and p lace the selector
lever in the P position.
.. Turn the ignition and e lectr ica l equ ipment
off in both vehicles.
Connecting the negati ve terminal (-) to
the negat ive terminal (- ) ( black )
.. To r each the battery term inals, flip the bat­
tery cover cap to the side ¢
fig. 190.
1. Clamp the end of the red jump start cable
to the terminal (!)¢
fig. 191 on the dead
battery @ ¢CI)
in Starting with jumper
cables on page 280 .
2. Clamp the othe r end of the red jump star t
c able to the termin al@ on t he charging
battery @.
Connect NEGATIVE (-) to NEGATIVE (-)
(black )
3. Clamp the blac k end of t he j ump sta rt ca­
ble
preferably at the ground point , or on
the nega tive terminal @ on the charging
batte ry @ .
4. Clamp the other black end of the jump start cab le
onl y on the ground point@
on your vehicle @ ¢CI).
S. Route the jump start cab les so they can­
not get ca ugh t in the moving parts in the
engine compa rtment.
St arting the engine
6. Start the engine in the vehicle giving the
charge and let it run at idle.
7 . Start the eng ine in the vehicle with the
dead battery and wait two to three m i­
nu tes unti l it "runs smoothly".
8.
If t he engine does not s tart: Stop the
st art ing procedure afte r 10 seco nds and
then repeat it afte r approximately 30 sec­
onds.
9 . In the vehicle that is be ing jump started,
switch the heater fan and rear window de ­
froster on to reduce any voltage peaks
t hat may occur when disconnecting the
j u mper cables . The headlights must be
switched off .
10 . Wi th the e ngin es runn ing , remov e th e ca­
bles in
rever se orde r of the way t hey were ..,.

28 2 Em ergency sit uat ions
installed. Make sure the cables do not get
caught in moving engine components .
11. Sw itch the heater fan and rear window de-
froster
off.
12. Close the battery cover.
The battery is vented to the outside so that
not gases enter the passenger compartment.
Make sure that the connected positive termi­
nal clamps on the jump start cable have suffi­
cient contact with metal.
A WARNING
Follow the warn ings and instructions from
the jump start cable manufacturer to re­
duce the risk of ser ious injuries and vehicle
damage.
If you are uns ure about anyth ing,
call roadside assistance.
- T he jump start cables must be long
enough so that the vehicles do not
touch.
- Route the jump sta rt cab les so they can­
not get caught in the moving parts in the
engine compartment .
- Always read and follow the warn ings be­
fore checking anything in the engine compartment ¢
page 217.
([) Note
Correctly jump start cables incorrect ly can
destroy the a lternator .
- Always connect the positive terminal(+)
to the positive terminal( +) and the neg­
at ive termina l(- ) to the negative termi­
nal(-) on the body ground point, b ut not
the negative termina l on the battery.
- Make sure the screw plugs on the battery ce lls are insta lled securely.
If not, tig ht­
en the plugs before connecting the
clamps to the negat ive terminal on the
battery.
- Please note that the connecting process
described be low for the jump start ca­
bles is intended for when your vehicle is
being jump started . If you are jump
starting another vehicle, do not connect
the negat ive cab le to the negative termi­
nal (-) on the drained battery, but rathe r connect it to a
large metal component
that is bolted securely to the engine block, or to the engine block itsel f. If the
battery in the vehicle being jump started
is not vented to the outside, there is a
risk of explosion due to hydrogen gas .
- Make sure that the connected positive
terminal clamps have sufficient contact
w ith metal.
- Do not use the battery negative terminal
for jump start ing or a malfunct ion could
occur in the vehicle electrical system.
Emergency towing
with commercial tow
truck
General hints
Your Audi requires special handling for tow ­
ing .
The following information is to be used by
commerc ial tow truck operators who know
how to operate the ir equipm ent safely .
-Never tow your Aud i. Towing will cause
damage to the engine and transmission.
- Never wr ap the s afet y chains or winch ca ­
bles around the b rake lines.
- To p re v ent unnece ssary damage , your Aud i
must be transpo rted with a flat bed truck.
- To load the vehicle on to the fl at bed, u se
the towing loop found in the vehicle tools
and attach to the front or rea r ancho rage
c;,page 283 and c;,page 283.
A WARNING
A vehicle being towed is not safe for pas­
sengers . Never allow anyone to ride in a
vehicle be ing towed, fo r any reason.
-

29 4 Index
Audi magnetic ride
refer to Adaptive dampers 106
Aud i Service Repa ir Ma nuals and Litera -
ture .. .. .... ............. .. .. .. .. . 289
AUTO Automatic climate control system ..... 70
Automatic headlights ......... .. .... 46
Auto Lock (centra l locking system) .... .. 36
Automatic belt retractor ............. 138
Automatic climate control system
refer to Climate control system (auto-
mat ic) ............................ 70
Automatic headlights ................. 46
Automatic post-collision braking system 190
Automatic transmission .............. 109
Driving t ips . .................. .... 111
E mergency mode .................. 115
H ill descent control ................ 113
I gnition key safety in terlock .. .. .... .. 74
Kick -down . .... . ...... ... ... ..... . 114
L aunch Contro l-Program ... .. .. .. .. . 1 15
malfunction . .. . ...... ... .. .. .... . 110
Selector lever emergency release . . . . . 116
Selector lever lock . . . . . . . . . . . . . . . . . 110
Selector lever posit ions ............. 109
Shifting manually . . . . . . . . . . . . . . . . . . 114
Steer ing whee l w ith shift paddles ..... 114
S t ron ic .. .. ..... ........ .. .. .. .. . 109
tiptronic . .. ............. .. .. .. .. . 114
Automatic wipe/wash system . . . . . . . . . . 50
Auto Safety Hotline ..... ... .. .. .... . 133
Auxiliary heater (vehicles w ith d iese l en-
g ines) .. .. .... ............. ...... .. 73
Average consumption ................. 28
Average speed . . . . . . . . . . . . . . . . . . . . . . . 28
B
Battery . .. .. ............. .. .. .. .. . 228
Charge level ... ... .... ... .. .. .... . 194
Charging . . . . . . . . . . . . . . . . . . . . . 20, 230
Energy management . ... .. .. .. .. .. . 194
Important warnings ............... 229
Indicator light . . . . . . . . . . . . . . . . . . . . . 20
Jump starting ............ .. .. .. .. . 280
Locat ion ... ... .... ...... ... ... .. . 229
Replacing the battery .............. 231 Winter operation
.... .. ..... .... . .. 228
Working on the battery . ..... ... .. .. 229
Before driving ..... ............. .... 125
Blended gasoline .. ............. .... 210
B lower
automatic Climate control system . ... . 71
Manua l climate control system ... .. .. . 69
Boos t .............................. 29
Booster seats . . . . . . . . . . . . . . . . . . . . . . 179
Boost p ressure indicator . ..... ... .. .. . 29
Brake fluid Changi ng the b ra ke fluid ........ .. .. 22 7
Checking the b rake fluid level ........ 22 7
What is the co rrect b rake fluid level? .. 2 2 7
What shou ld I do if the brake fluid warn -
ing light comes on? ..... .... ... .. .. 227
B rakes ..... .... .. .. ........... .... 191
B rake assist system . ........... .. .. 189
B rake booster ..................... 191
Indicator light ... .. ... ..... ... .. .. . 25
New brake pads . .... .. ..... ... .. .. 191
Brake system Brake fluid .... .. ............. .... 22 7
B rake fluid specifications fo r refill and re -
placement .... .. ... .. ..... ... .. .. 227
B rake pads . ..... .. .... .... ... .. .. 197
Fl uid reservoir ... .. ... ..... ... .. .. 227
Worn brake pads symbo l . . . . . . . . . . . . . 22
B rak ing
Emergency brak ing funct ion ... .. .. .. . 82
Indicator light ... ... .. ..... .... . .. . 18
Parking brake .... .. ... ..... ... .. .. . 80
Starting on inclines ............ .... . 82
B reak-in per iod ..................... 197
Brake pads . ..... ... .. ..... ... .. .. 197
T ires ... .. .... .. .. ... ..... ... .. .. 197
Bu lbs ......... ... .. .............. . 279
C
California Proposition 65 Warn ing .... . 218
Battery specific .................. . 230
Capacities AdBl ue ... .... .. ............. .... 215
Fuel tank .. .. .. .. ............. .. .. 288
Washe r fluid reservo ir .. ....... ... .. 288
Care ... .. .. .... .. .. .... . ..... ... .. 205
also refer to Cleaning .......... .. .. 205