BMW 7 SERIES 1986 E23 Cruise Control
Manufacturer: BMW, Model Year: 1986, Model line: 7 SERIES, Model: BMW 7 SERIES 1986 E23Pages: 14, PDF Size: 3.46 MB
Page 11 of 14
CRUISE CONTROL ELECTRICAL SCHEMATIC 733IA
61-08/3
GN-green BR-brown
WS-white RT-red
BL-blue VI-violet
GE-yellow
1. Control Unit (ECU) 5. Adaptor 9. Fuses
2. Reed Switch 6. Trans. Lights (Instruments) 10. Relief Relay
3. Servo 7. Brake Switch 11. Ignition Switch
4. Control Switch 8. Brake Light 12. Battery
Page 12 of 14
CRUISE CONTROL SYSTEM TESTS - 633CSi (VACUUM SERVO)
A, Vacuum - Check fit and condition of all vacuum and vent lines.
B. Electrical
TEST AT ECU PLUG
COMPONENT/CIRCUIT
RESULT
1. Measure A/C voltage
across terms. 11-12.
Car on hoist in gear
and running.
Signal Generator and
wiring.
10 mph approx. 0.7 V A/C
20 mph approx. 1.4 V A/C
30 mph approx. 2.1 V A/C
40 mph approx. 2.8V A/C
2. Ignition on. Check
voltage at term. 5.
Power supply.
Voltage - 12V. If not,
check wiring.
3. Start car. Jumper
term. 5-3 and then
12-7 momentarily.
Servo.
Servo should activate and
raise engine speed. If
not, check wiring and Servo.
4a. Ignition on (not
running). Check
voltage at term. 6.
b. Ignition off. Check
resistance terminal
6 to ground.
System disconnect
circuit.
Adaptor ground.
No voltage. Push brake pedal
then voltage = 12V, or trans.
to 'N' and voltage = 12V. If
not, check wiring, switches,
and adaptor.
Reading approx 20 to 150 .
Now reverse leads and reading
must remain between 20 and 150
If reading is at oo with either
hook up check adaptor grounding
or replace adaptor.
5. Ignition on. Check
voltage at term. 8.
Control switch OFF.
Move lever to OFF. Voltage
drops from 12 -> 0 volts. If
not, check wiring and switch.
6. Ignition on. Check
voltage at term. 9.
Control switch CONST.
Move lever to CONST. Voltage
jumps 0 to 12 volts. If not,
check wiring and switch.
7. Ignition on. Check
voltage at term. 10.
Control switch RESUME.
Move lever to RESUME. Voltage
jumps 0 to 12 volts. If not,
check wiring and switch.
If these electrical tests are OK, then change the control unit if the system does not
operate correctly.
61-08/4
Page 13 of 14
CRUISE CONTROL ELECTRICAL SCHEMATIC 633CSiA
61-08/5
1. Control Unit (ECU) 5. Control Switch 9. Fuses
2. Signal Generator 6. Battery 10. Relief Relay
3. Ignition Switch 7. Adaptor 11. Brake Light
4. Servo 8. Trans. Lights 12. Brake Switch
GN-green BR-brown
WS-white RT-red
BL-blue VI-violet
GE-yellow
Page 14 of 14
CRUISE CONTROL VACUUM SERVO
THROTTLE LINKAGE
NIPPLE
l-2mm
VENT
VACUUM
ELECTRIC
SOLENOID