oil filter BMW Z4 COUPE 2008 E86 Service and warranty information
[x] Cancel search | Manufacturer: BMW, Model Year: 2008, Model line: Z4 COUPE, Model: BMW Z4 COUPE 2008 E86Pages: 54, PDF Size: 2.39 MB
Page 9 of 54
Engine Oil Service
Engine Compartment Z4 Roadster
3.0i, 3.0si
Z4 Coupe 3.0si
Change oil and oil filter while engine is at normal operating temperature. We
recommend BMW 5W-30 High Performance Synthetic Oil, p/n 07 51 0 017 866. •
Reset service interval indicator. •
Replace microfilter. •
Check overall thickness of front and rear disc brake pads using special tool. If
replacement is necessary: Examine brake disc surfaces. Clean brake pad contact
points in calipers. Grease wheel centering hubs. Check thickness of parking brake
linings only when replacing rear pads. •
Check parking brake actuation. Adjust if necessary. Burnish parking brakes. •
Inspect tires. Adjust tire pressure if needed. Reset Tire Pressure Monitor. •
5
Page 10 of 54
Inspection I
Only those items of inspection work which apply to your vehicle will be performed. This list is subject
to amendment.
Undercarriage Z4 Roadster
3.0i, 3.0si
Z4 Coupe 3.0si
Change oil and oil filter while engine is at normal operating temperature. We
recommend BMW 5W-30 High Performance Synthetic Oil, p/n 07 51 0 017 866. •
Check transmission for leaks. •
Check rear axle for leaks. •
Half-shafts: Check for leaks at flexible boots. •
Visually check fuel tank, lines and connections for leaks. •
Check condition, position, and mounting of exhaust system. Examine for leaks. •
Check steering for absence of play, condition of suspension track rods, front axle
joints, steering linkage and joint disc. •
Check overall thickness of front and rear disc brake pads using special tool. If
replacement is necessary: Examine brake disc surfaces. Clean brake pad contact
points in calipers. Grease wheel centering hubs. Check thickness of parking brake
linings only when replacing rear brake pads. Check brake system connections and
lines for leaks, damage and incorrect positioning. •
Check parking brake actuation. Adjust if necessary. Burnish parking brake. •
Check all tire pressures. Correct if necessary. Check condition of tires (outer surface
[left/right]), tread wear and pattern; in case of uneven tread wear, readjust wheel
alignment if requested (invoice separately). •
Inspect entire body according to terms of rust perforation limited warranty. (Must be
performed at least every two years). •
6
Page 13 of 54
Emission Control Maintenance Schedule: BMW Z4 Roadster 3.0i, 3.0si
and Z4 Coupe 3.0si
The maintenance schedule as shown is required
for the proper functioning of the emission con-
trol systems for optimum vehicle performance
and fuel economy.
Abbreviations:
I - Inspect
R - Replace part(s) and/or fluid listed
Basic Engine
Engine oil .........................
Engine oil filter .....................
Fuel System
Air filter ..........................
Ignition System
Spark plugs .......................
Emission Control Components
Oxygen sensor .....................
BMW Z4 Roadster
3.0i/3.0si
Z4 Coupe 3.0si
Oil Service
Inspection I
Oil Service
Inspection II
R
R R
R R
R R
R
R
Replace at intervals of 100,000 miles
Replace at intervals of 120,000 miles
Oxygen Sensor Service: The oxygen sensor deteriorates strictly on a mileage basis and must there-
fore be replaced to maximize vehicle fuel economy and minimize exhaust pollution.
The mileage interval varies according to individual driving conditions and is determined by the service
interval indicator.
9