light BUICK CENTURY 1993 User Guide

Parking Brake
The parking brake uses the brakes on the rear wheels.
I
To set the parking brake:
Hold the regular brake
pedal down with your right
foot. Push down the
parking brake pedal with
your left foot.
If the ignition
is on, the brake system
I warning light will come on.
L
I
To release the parking
brake:
Hold the regular
brake pedal down. Pull the
brake release lever.
NOTICE:
Driving with thiparl ‘g brake or )use
your rear brakesto oveFheat. ybu may have
-
replace them, and you could alse damage
other parts
of your vehicle.
If you are on a hill: See “Parking on Hills” in the Index.
That section shows
how to turn your front wheels.
If you are towing a trailer and are parking on any
hill: See “Towing a Trailer” in the Index. That section
shows what to do first to keep the trailer from
moving.
80
ProCarManuals.com

Horn
You can sound the horn by pressing the horn symbol on
your steering wheel.
Tilt Steering Wheel (Option)
b
-.
A tilt steering wheel allows
you
to adjust the steering
wheel before you drive. You
can
also raise it to the
highest level
to give your
legs more room when you
exit and enter the vehicle.
To tilt the wheel, hold the
steering wheel and pull the
lever. Move the steering
wheel to a comfortable
level, then release the lever
to lock the wheel in place.
The I’urn SignaUHeadlight Beam
Lever
The lever on the left side of the steering column includes
your:
Turn Signal and Lane Change Indicator
Headlight High-Low Beam
Windshield Wipers
Windshield Washer
Cruise Control (Option)
86
ProCarManuals.com

Headlight Highhw Beam Windshield Wipers
To change the headlights
from low beam to high, or
high to low, pull the
turn
signal lever all the way
toward
you. Then release
it. When the high beams
are on,
.this blue light on
the instrument panel also will be on.
i
I
You control the windshield wipers by turging the band
marked
“WIPERI’
For a single wiping cycle, turn the band to “MIST? Hold it there until the wipers
start, then let go. The wipers will
stop after one cycle.
If you want more cycles, hold the
band on “MIST” longer.
For steady wiping at low speed,
turn the band away from
YOU to the “LO” position. For high speed wiping, turn
the band further, to “HI? To stop the wipers, move the
band to “OFF?
88 .I
ProCarManuals.com

Low Speed Delay Wipers (Option)
You can set the wiper speed for a long or short delay
between wipes.
‘ms can be very useful in light rain or
snow.
Turn the band to choose the delay time. The closer
to
“LO:’ the shorter the delay.
If you push the paddle less than one second, washer fluid
will spray three to four times while the wiper blades
cycle.
If you push the paddle longer than one second,
washer fluid will spray as long
as the paddle is held.
When you release the paddle, the wiper blades will cycle
I
- .I - three to four more times. 1
A CAUTION:
I If you have the standard wipers, the wipers will keep
going
in “LO” until you turn the wiper control to -
“OFF.” Damaged wiper blades may prevent you’irom
seeing well enough to drive safely.
To avoid If you have the optional low speed delay wipers, the
damage, be sure to clear ice and snow from wipers will clear the window and then either stop or
the wiper blades before using them. If they’re
frozen to the windshield, carefully loosen or
thaw them.
If your blades do become b 1.
-
return to your preset speed.
I damaged, gefnew blades or blade inserts.
I
Heavy snow or ice can overload your wipers. A circuit
breaker in the motor will
stop them until the motor cools.
Clear away snow or ice to prevent an overload.
Windshield Washer
At the top of the turn signal/headlight beam lever there’s
a paddle with the word “PUSH”
on it. To spray washer
fluid on the windshield, push the paddle.
a Driving without washer fluid can be dangerous.
A bad mud splash can block your vislon. ybu
could hit another vehicle or go off the mad.
Check your washer fluid level often.
* In freezing weather, don’t use your washer
untll the windshield is warmed. Otherwim
the washer fluid
can form ice on the
windshield, blocking
put vision.
ProCarManuals.com

Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot
off the pedal, your vehicle will slow
down
to the Cruise Control speed you set earlier.
Using Cruise Control on Hills
How well your Cruise Control will work on hills
depends upon your speed, load, and the steepness
of the
hills. When going up steep hills, you may have
to step on
the accelerator
pedal to maintain your speed. When going
downhill, you may have to brake or shift
to a lower gear
to keep your speed down.
Of course, applying the brake
takes you out
of Cruise Control. Many drivers fmd this to
be too much trouble and don’t use Cruise Control on
steep hills.
To Get Out of Cruise Control
L
-.
There are two ways to turn
off the Cruise Control:
Step lightly on the brake
pedal;
OR
Move the Cruise switch
to
“OFF?
To Erase Cruise Speed Memory
When you turn off the Cruise Control or the ignition,
your Cruise Control set speed memory is erased.
94
ProCarManuals.com

Lights
Interior Lights/Instrument Panel Intensity Control
I+
Headlights
*P
I PF
You can brighten or dim the
instrument panel lights by
rotating the control up or
down. To turn on the
interior courtesy lights,
rotate the control all the
way up to
“HI:’
Press the switch marked “P” to
turn on:
Parking Lights
Side Marker Lights
Taillights
License Plate Lights
Instrument Panel Lights
-‘(J- Press the , switch to turn on the headlights,
together with:
Parking Lights
Side Marker Lights
Taillights
License Plate Lights
Instrument Panel Lights
Press
“OFF” to turn off the lights.
Operation of Lights
Although your vehicle’s lighting system (headlamps,
parking lamps, fog lamps, side marker lamps’and tail
lamps) meets
all applicable federal lighting requirements,
certain States and Provinces may apply their own lighting
regulations that may require special attention before you
operate these lamps. For example, some jurisdictions
may require that you operate your lower beam lamps
with fog lamps at
all times, or that headlamps be turned
on whenever you must use your windshield wipers.
In
addition, most jurisdictions prohibit driving solely with
parking lamps, especially at dawn or dusk.
It is
recommended that you check with your own State Or
Provincial highway authority for applicable lighting
regulations.
95
ProCarManuals.com

Headlight “On” Warning
If you open the door while leaving the lights on, you will
hear a warning chime.
Daytime Running Lights (Canada Only)
The Canadian Federal Government has decided that “Daytime Running Lights” (DRL)
are a useful feature, in
that DIU can make your vehicle more visible to
pedestrians and other drivers during daylight hours. DRL
are required on new vehicles sold in Canada.
Your DRL work with a light sensor on top
of the
instrument panel. Don’t cover it up. The low beam
headlights will come on at reduced brightness
in daylight
when:
The ignition is on
The headlight switch is off, and
The parking brake is released.
At dusk, the exterior. lights will come bn &.nomatically
and the low
beams will change to full brightness. At
dawn, the exterior lights will go out and the low beams
will change to
the reduced brightness of DRL (if the
headlight switch is off).
Of course, you may still turn on the headlights any time
you need to.
To idle your vehicle with DRL off, set the parking brake
while the ignition is in the
“Off’ or “Lock” position.
Then start the vehicle. The
DRL will stay off until you
release the parking brake.
Map Light
& Press the switch to turn the
map light on and
off.
MAP
ON
OFF
96
ProCarManuals.com

Front Seat Reading Lights (Option) Rear Reading Light (Wagon)
I
Press the switch to turn on the front seat reading lights.
To avoid drair.ing your vehicle battery's power,
be sure to
turn off all front and rear reading lights when leaving
your vehicle. This light will go
on when you open the liftgate. To turn
on
the light when the liftgate is closed, press the switch.
Interior Lights Delay
When you pull on the driver's outside door handle, the
dome and courtesy lights will go on and stay on for about
40 seconds, or until you turn the ignition on.
If you pull on the driver's inside door handle within 30
seconds of switching off the ignition, the interior lights
will go
on and stay on for about 5 seconds, to allow you
to unlock your door(s).
97
ProCarManuals.com

Inside Rearview Mirror with Reading Lights
(Option)
Courtesy Lights
When any door is opened, several lights go on. These
lights are under the instrument panel. Optional lights are on the rear doors. They make it easy for you to enter and
leave the vehicle.
You also can turn these lights on by
rotating the interior lights switch to
‘‘HI:’
Mirrors
Inside Mirror
--
To reduce glare from lights behind you, pull the lever
toward you to the night position.
To turn on the reading lights, press the switches on the - -_ front of the mirror.
To reduce glare from lights behind you, pull the lever
toward you to the night position.
98
ProCarManuals.com

Sun Visors Luggage Carrier (Option)
To block out glare, you can swing down the visors. If you have
the optional luggage carrier, you can load
Visor Vanity Mirrors vehicle. The luggage cairier has slats attached to the deck
things
on top of a wagon,
or on the deck lid of your
- . lid, a rear rail, and tiedowns. The wagon has slats
attached to the roof, side rails, and adjustable crossrails.
The crossrails can be adjusted by loosening the screws.
After moving the crossrails, be sure to tighten the screws
securely.
Standard Mirror: Open the cover to expose the vanity
mirror.
Lighted Mirrors: If your vehicle has the optional lighted
vanity mirrors, the lights come on when you open the
cover. These can even be used for reading. Close the
cover to
turn out the lights. Don’t exceed the maximum vehicle capacity when loading
your Buick. For more information on vehicle capacity and loading,
see “Loading Your Vehicle” in the Index.
100
ProCarManuals.com