lock BUICK PARK AVENUE 1993 Owner's Manual

3.
4.
5.
6.
7.
Use a jumper wire with alligator clips at both ends to
ground (Terminal
A) to program (Terminal G).
Grounding the program terminal erases the system
memory and causes the doors to lock and unlock
once. This means the system is ready to be matched
to the transmitter.
Keeping the program terminal grounded, press the
UNLOCK button on the first transmitter. The door
locks will lock and unlock again to indicate the
transmitter is now matched. If there is no response,
check the transmitter batteries. If you do not want to
match a second transmitter, proceed to Step
6.
Still keeping the program terminal grounded, repeat
Step
4 with the second transmitter. If you disconnect
the ground wire before completing this step, or if
you press the button
on the first transmitter more
than once, only the first transmitter is matched. If
you make a mistake, disconnect the jumper wire and
start over at Step
3.
Remove the jumper wire. (Note: The system will not
operate if the jumper wire is still connected.)
Test the operation of both transmitters with the
vehicle.
If the lock control does not work as it should, see your
Buick dealer.
Battery Replacement
Under normal use, the batteries in your key chain
transmitter should last about two years.
You can tell the batteries are weak if the transmitter
won’t work at the normal range in any location.
If you
have to get close to your vehicle before the transmitter
works, it’s probably time to change the wlerieg,
For battery replacement,
use two Duracells
batteries, type DL-2016, or
a similar type.
ProCarManuals.com

To replace the batteries: Rear Door Security Lock
f
2. Lift off the front cover, bottom half first.
3. Remove and replace the batteries. Put them in as the
instructions under the batteries indicate. Your
Buick is equipped with rear door security locks
that help prevent passengers from opening the rear doors
of your car from the inside. To ,use one of these locks:
,. . .. 1. Move the lever on
the door all the
ENGAGED
position.
SECURITY way up to the
REAR DOORS 2. Close the door.
4. Replace the front cover. Make sure the cover is on 3. Do the same thing to the other rear door lock.
tightly,
so water won’t get in. Replace the screw in
the back cover. The rear doors of your vehicle cannot be opened from
inside when this feature is in use.
If you want to open a
rear door when the security lock is on:
69
ProCarManuals.com

1. Unlock the door from the inside.
2. Then open the door from the outside.
If you don’t cancel the security lock feature, adults or
older children who ride in the rear won’t be able to open
the rear door from the inside.
You should let adults and
older children know how these security locks work, and
how to cancel the locks.
To cancel the rear door lock:
1. Unlock the door from the inside and open the door
from the outside.
CHILD
SECURITY LOCK
SET LEVER ON BOTH 1 REAR DOORS 1
1 2. Move the lever all
the way down.
Illuminated Entry System (Option)
3. Do the same for the other rear ( loor. You’ll be
able to see where to put the door key when it’s
dark, and
the lights inside your Buick will go on.
They’ll go off when you start your engine, or when 25
seconds have passed. If you have the Remote Keyless
Entry System option, it can make the illuminated entry
system work too. (See Remote Keyless Entry System in
the Index.)
If you have this option, your interior lights will
automatically shut
off after a 10 minute period if a door
is
left ajar. This feature is designed to help eliminate
battery wear down.
The rear door locks will now work normally.
70
ProCarManuals.com

Theft
Vehicle theft is big business, especially in some cities.
Although your Buick has a number of theft deterrent
features, we know that nothing we put on
it can make it
impossible to steal. However, there are ways you can
help.
Kev in the ignition: If you walk away from your
vehicle with the keys inside, it’s an easy target for joy
riders or professional thieves
-- so don’t do it.
When you park your Buick and open the driver’s door,
you’ll hear a tone reminding you to remove your key
from
the ignition and take it with you. Always do this.
Your steering wheel will be locked, and
so will your
ignition and transaxle. And remember to lock the doors.
Parking at Night: Park in a lighted spot, close all
windows and lock your vehicle. Remember
to keep your
valuables
out of sight. Put them in a storage area, or take
them with you.
Parking. Lots: If you park
in a lot where someone will
be watching your vehicle, it’s best to lock
it up and take
your keys. But what if you have
to leave your ignition
key? What if you have to leave something valuable
in
your vehicle?
Put your valuables in a storage area, like your trunk
Lock the glove box.
or glove
box.
0 Lock all the doors except the driver’s.
0 Then take the door key with you.
Universal Theft Deterrent (Option)
If your Buick has this option, it has a theft deterrent
alarm system. With this system, the “SECURITY’’ light
will flash as
you open the door (if your ignition is off).
This light reminds you
to arm the theft deterrent system.
Here’s how to do it:
1. Open the door.
2. Lock the door with the power door lock switch or
Remote Keyless Entry System. The “SECURITY”
light should come on
and stay on.
3. Close all doors. The “SECURITY” light should go
off.
If a door or the trunk is opened without the key or
Remote Keyless Entry System, the alarm will
go off. It
will also
go off if a door lock or the trunk lock is
damaged. Your vehicle’s lights will flash and the horn
71
ProCarManuals.com

will sound for several minutes, then will go off to save
battery power.
Remember, the theft deterrent system won’t arm if you
lock
the doors with a key or manual door lock. It arms
only if you use
a power door lock switch or Remote
Keyless Entry System. You should also remember that
you can start your vehicle with the correct ignition key
if the alarm has been set
off. You must still shut off the
alarm by inserting the key’in the door lock.
Here’s how to avoid setting
off the alarm by accident:
0
0
If you don’t want to arm the theft deterrent system,
the vehicle should be locked after the doors are
closed.
Always unlock a door with’a key, or use the Remote
Keyless Entry System. Unlocking a door any other
way will set
off the alarm. If
you set
off the alarm by accident, unlock any door
with your
key.
You can also turn off the alarm by using the Remote
Keyless Entry System,
if you have it. The alarm won’t
stop
if you try to unlock a door any other way.
How to Test The Alarm
The alarm can be tested by first having the driver’s
window down. Arm
the system by locking the doors
with the power door lock switch or the Remote Keyless
Entry System. Get out
of the car and close the door, wait
for the security light to go out, then reach in through the
window, unlock the door with the manual door lock,
then open the door. This should set the alarm off.
If the alarm does not sound when
it should, check to see
if the horn works. The horn fuse may be blown. To
replace the fuse, see “Fuses and Circuit Breakers” in the
Index.
72
ProCarManuals.com

PASS-Key I1 TM
Your vehicle is equipped with the PASS-Key I1 TM
(Personalized Automotive Security System) theft
deterrent system. PASS-Key
I1 TM is a passive theft
deterrent system. This means you don’t have to do
anything different to arm or disarm the system. It works
when you insert or remove the key from the ignition.
PASS-Key
TM uses a resistor pellet in the ignition key
that matches a decoder in your vehicle. When the PASS-Key
I1 system senses that someone
using the wrong key, it shuts down the vehicle’s starter
and
fuel systems. For about three minutes, the starter
won’t work and fuel won’t go to the engine. If someonl
tries to start your vehicle again or uses another key
during this time, the vehicle will not start. This
discourages someone from randomly trying different
is
e
keys with different resistor pellets in an attempt to make
a match.
The ignition
key must be clean and dry before it’s
inserted in the ignition or the engine may not start. If the
engine does not start and the “SECURITY” light comes
on, the key may be dirty or wet. Turn the ignition
off.
Clean and dry the key. Wait about three minutes and try
again. The security light will remain on during this time.
If the starter still won’t work, and the key appears to be
clean and dry, wait about three minutes and try the other
ignition key.
At this time, you may also want to check
the fuse (see “Fuses and Circuit Breakers” in the Index).
If the starter won’t work with the other key, your vehicle
needs service. If your vehicle does start, the first ignition
key may
be faulty. See your Buick dealer or a locksmith
who can service the PASS-Key I1
TM .
If you accidentally use a key that has a damaged or
missing resistor pellet, the starter won’t work and the
ProCarManuals.com

security light will flash. But you don’t have to wait three
minutes before trying one of the other ignition keys.
See your Buick dealer or a locksmith who can service
the Pass-Key I1
TM to have a new key made.
If you’re ever driving and the “SECURITY” light comes
on for one minute and stays on, you will be able to
restart your engine if
you turn it off. Your PASS-Key
I1
TM system, however, is not working properly and must
be serviced by your Buick dealer. Your vehicle
is not
protected by the PASS-Key I1
TM system.
If you
lose or damage a PASS-Key I1 ignition key, see
your Buick dealer or a locksmith who can service
PASS-Key
I1 TM to have a new key made.
New Vehicle “Break-In”
74
ProCarManuals.com

Ignition Key Positions
Your square-headed key
operates your ignition lock.
ACC
1
I
This lock gives you five different positions.
Before
you put the key in, your ignition will be in the
“Lock” position. This position locks your ignition,
steering wheel and transaxle. It’s a
theft deterrent
feature.
The other positions let you perform these functions:
ACC: Accessory lets you use things like the radio and
the windshield wipers when the engine is off. To get into
“Acc”, push in the key and turn it toward
you. Your
ProCarManuals.com

steering wheel will remain locked, just as it was before
you inserted the key.
OFF: This position lets you turn off the engine but still
turn the steering wheel.
It doesn’t lock the steering
wheel like “Lock.” Use “Off’ if
you must have your car
in motion while the engine is off (for example, if your
car is being pushed).
RUN: This is the position for driving.
START This position starts your engine.
NOTICE:
If your key seems stuck in “Lock” and you can’t
turn
it, be sure it is all the way in. If it is, then turn
the steering wheel left and right while you turn
the key hard. But turn the key only with your
hand. Using a tool to force
it could break the key
or the ignition switch. If none of this works, then
your vehicle needs service.
p’
Retained Accessory Power (Option)
After the ignition is turned off, and before any door is
opened, the following systems will work for ten
minutes:
0 Fuel Filler Door Release
Trunk Release
0 Power Windows
Radio
0 Brake Transaxle Shift Interlock
0 Optional Astroroof
Starting Your Engine
Engines start differently. The 8th digit of your Vehicle
Identification Number
(VIN) shows the code letter or
number for your engine. You will find the
VIN at the top
left of your instrument panel. (See “Vehicle
Identification Number” in the Index.) Follow the proper
steps to start the engine.
ProCarManuals.com

Driving Through Deep Standing
Water
standing water, water can come in through your
engine's air intake and badly damage your
engine.
If you can't avoid deep puddles or
standing water, drive through them very
s
Engine Block Heater (Canada Only)
In very cold weather, 0 " F (- 18 "C) or colder, the engine
block heater can help. You'll get easier starting and
better fuel economy during engine warm-up.
To use the block heater:
1. Turn off the engine.
2. Open the hood and unwrap the electrical cord.
3. Plug it into a normal, grounded 110-volt outlet.
ProCarManuals.com