tow BUICK RANDEZVOUS 2002 Owner's Manual

1-4 Manual Lumbar
The knob that controls
this feature is located
on the outboard sides
of the driver's and front
passenger's seats.
Turn the knob toward the front of the vehicle to increase
lumbar support. Turn the knob toward the rear of the
vehicle to decrease lumbar support.
Memory Seat (Option)
If your vehicle has this
feature, the controls are
located on the driver's
door panel and are used
to program and recall
the driver's seat position
and outside rearview
mirror position.
Adjust the driver's seat and the outside rearview mirrors
to the position you would like for driving. Then press
and hold memory button 1 for more than three seconds.
A double beep will sound when the memory seat and
mirrors are set.
To set the seat and outside rearview mirrors for a
second driver, follow the previous steps, but press
button 2 instead.
To recall your memory positions, your vehicle must
be in PARK (P). Push and release the memory button
(1 or 2) corresponding to the desired driving position.
The seat and the outside rearview mirrors will move to
the position previously stored for the identified driver.
You will hear one beep.

1-11
5. To release the front latches, squeeze the angled latch
release bar toward the straight crossbar.
6. Remove the seat by rocking it slightly toward the
rear of the vehicle and then pulling it out.
Repeat these steps for the other section of the split
bench seat.Replacing the Split Bench Sections
CAUTION:
If the seatback isn't locked, it could move forward
in a sudden stop or crash. That could cause injury
to the person sitting there. Always press rearward
on the seatback to be sure it is locked.
CAUTION:
A seat that isn't locked into place properly
can move around in a collision or sudden stop.
People in the vehicle could be injured. Be sure
to lock the seat into place properly when
installing it.

1-12
CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted won't provide
the protection needed in a crash. The person
wearing the belt could be seriously injured.
After installing the seat, always check to be
sure that the safety belts are properly routed
and attached, and are not twisted.
Make sure that the seatback is in the folded forward
position and that the safety belts are on the correct
section of the seat.
Don't put the sections of the bench seat in so that they
face rearward because they won't latch that way.
The split bench seat sections have seat position labels,
located on the back of each section, showing where
the section must go.
The seat must be placed in the proper location for
the legs to attach correctly.
1. Squeeze the angled latch release bar toward the
straight crossbar while placing the front hooks of
the bench seat onto the front two floor pins.

1-15
Removing the Captain's Chairs
1. Make sure that the seatback is in the
upright position.
2. Lift the seatback recliner lever to fold the
seatback forward.
3. Pull up on the lever, located at the base on the
outboard side of the seat, to release the rear latches
from the floor pins.
4. The seat can then be lifted off the front floor pins.
5. Remove the seat by rocking it slightly toward the
rear of the vehicle and then pulling it out.
Repeat these steps for the other captain's chair.

1-18 Stowable Seat (Option)
The optional stowable seat is a two passenger bench seat
and comes with the rear convenience center. See ªRear
Convenience Centerº in the Index for more information.
The stowable seat can be removed and replaced or,
with the seatback folded, it can lie flush with the
convenience center.Folding the SeatbackTo fold down the
seatback, pull up on
the lever located on
the back of the seat
and push the seatback
down until it is locked
into place.

1-19
Push and pull on the seatback to make sure that it is
locked into place.
To raise the seatback, do one of the following:

From the rear of the vehicle, pull up on the lever to
release the seatback, then pull the strap, located on
the right side of the seat, to pull the seatback up.
The seatback has a pocket to stow the strap on the
side of the seatback when not in use, or

from the passenger's side door, pull up on the lever
to release the seatback, then push up on the seatback
to raise the seat.
Push and pull on the seatback to make sure that it is
locked into the upright position.Removing the Stowable Seat
1. Remove the convenience center, if it is in the
vehicle. See ªRear Convenience Centerº in the
Index for more information.
2. Make sure all items are off of the stowable seat.
3. If the seatback is down, put the seatback in
its upright position before removing the seat.
See ªFolding the Seatbackº listed previously.
4. From in front of the bench seat, remove the two nuts
located on the floor on each side of the bench seat.
5. From behind the bench seat, fold the seatback down.
6. Remove the nuts located on the floor on each side
of the bench seat.
7. Remove the seat by rocking it slightly toward the rear
of the vehicle and then pulling it out through the rear
of the vehicle. This should be done in one motion.
8. Put the nuts back onto the screws so the nuts do
not get misplaced.

1-20
Replacing the Stowable Seat
Do not put the stowable seat in so that it faces rearward.
The stowable seat has to go in before the rear
convenience center. See ªRear Convenience Centerº in
the Index for more information.
The stowable seat has seat position labels, located on the
back of the seat, showing where the seat must go.
The seat must be placed in the proper location for the
legs to attach correctly.Make sure that the seatback is folded forward before
beginning this procedure.
1. Remove the nuts from the screws.
2. Place the stowable seat on the floor so that the
brackets are placed over the screws.
3. Reinstall the nuts back onto the screws.
4. Try to raise the seat to make sure that it is
locked down.
5. Raise the seatback to its upright position.
Push and pull on the seatback to make sure that
it is locked into place.

1-43
How does an air bag restrain?
In moderate to severe frontal or near frontal collisions,
even belted occupants can contact the steering wheel
or the instrument panel. In moderate to severe side
collisions, even belted occupants can contact the inside
of the vehicle. The air bag supplements the protection
provided by safety belts. Air bags distribute the force of
the impact more evenly over the occupant's upper body,
stopping the occupant more gradually. But the frontal
air bags would not help you in many types of collisions,
including rollovers, rear impacts, and many side
impacts, primarily because an occupant's motion is
not toward the air bag. Side impact air bags would not
help you in many types of collisions, including frontal
or near frontal collisions, rollovers, and rear impacts,
primarily because an occupant's motion is not toward
those air bags. Air bags should never be regarded as
anything more than a supplement to safety belts, and
then only in moderate to severe frontal or near
-frontal
collisions for the driver's and right front passenger's
frontal air bags, and only in moderate to severe side
collisions for the driver's and right front passenger's
side impact air bags.What will you see after an air bag inflates?
After an air bag inflates, it quickly deflates, so quickly
that some people may not even realize the air bag
inflated. Some components of the air bag module
-- the
steering wheel hub for the driver's air bag, the instrument
panel for the right front passenger's bag, the side of the
seatback closest to the door for the driver and right front
passenger's side impact air bags
-- will be hot for a short
time. The parts of the bag that come into contact with you
may be warm, but not too hot to touch. There will be
some smoke and dust coming from the vents in the
deflated air bags. Air bag inflation doesn't prevent the
driver from seeing or being able to steer the vehicle,
nor does it stop people from leaving the vehicle.
CAUTION:
When an air bag inflates, there is dust in the
air. This dust could cause breathing problems
for people with a history of asthma or other
breathing trouble. To avoid this, everyone in the
vehicle should get out as soon as it is safe to do so.
If you have breathing problems but can't get out
of the vehicle after an air bag inflates, then get
fresh air by opening a window or a door.

1-46
Remove the shoulder belt from its stowage location in
the roof and pull it all the way down to the lap belt.Insert the metal knob on the shoulder belt into the
keyhole on the lap belt buckle as shown. Be sure to
slide the shoulder belt part into the keyhole until it
locks into place.

1-59
CAUTION:
The body structure of a young child is quite
unlike that of an adult or older child, for whom
the safety belts are designed. A young child's hip
bones are still so small that the vehicle's regular
safety belt may not remain low on the hip bones,
as it should. Instead, it may settle up around the
child's abdomen. In a crash, the belt would apply
force on a body area that's unprotected by any
bony structure. This alone could cause serious or
fatal injuries. Young children always should be
secured in appropriate child restraints.
Restraint Systems for Children
An infant car bed (A), a special bed made for use in a
motor vehicle, is an infant restraint system designed to
restrain or position a child on a continuous flat surface.
Make sure that the infant's head rests toward the center
of the vehicle.