ignition BUICK REGAL 2017 Get To Know Guide

4
Remote Keyless Entry Transmitter (Key Fob)
Unlock
Press to unlock the driver’s door.
Press again to unlock all doors.
Lock
Press to lock all doors. The driver’s
door will not lock when open
if the Unlocked Door Anti-
Lockout feature is turned on.
Vehicle Locator/ Panic Alarm
Press and release to locate
your vehicle. The turn signal
lamps will flash and the horn
will sound.
Press and hold to activate the
alarm. The turn signal lamps will
flash and the horn will sound
until the button is pressed again or
the ignition is turned on.
Trunk
Press and hold to unlock the trunk.

Press the power door Unlock/ Lock button on the front doors to unlock or lock
all doors.
To open a locked door from the inside, pull the inside door handle to unlock the door
and then pull the handle again to open the door.
To prevent a rear door from opening from the inside, activate the Rear Door
Security Lock. See your Owner Manual for more information.
See Keys, Doors and Windows in your Owner Manual.
Remote Vehicle StartF
Press and release the Lock button and
then press and hold the button until
the turn signal lamps flash to start the engine from outside the vehicle. After entering the vehicle, turn the ignition to the ON position or press the ENGINE START/STOP button
F.
• During a remote start, the
engine will run for 10 minutes.
• Press and hold the
button
until the parking lamps turn
off to cancel a remote start.
Note: To change the remote lock,
unlock, and remote start settings, go
to Remote Lock, Unlock, Start in the Vehicle Settings menu.
If the remote start heated seat option
is selected, the heated seat button
indicators will not illuminate and the
temperature of the unoccupied heated seat may
be reduced during the remote start. The heated
seat turns off when the ignition is turned on.
See Keys, Doors and Windows in your Owner Manual.
F Optional equipment
Power Door Locks/Door Opening

5F Optional equipment
Keyless Access SystemF
The Keyless Access System enables operation of the doors and ignition without remov-ing the key fob from a pocket or purse. The key fob must be within three feet of the door
being unlocked or the trunk.
Keyless Unlocking
With the key fob within range:
Press the lock button on the driver’s door handle to unlock the driver’s door; press it again within five seconds to unlock all doors.
Press the lock button on a passenger door handle to unlock all doors.
Press the touchpad above the license plate to open the trunk.
Keyless Locking
With the ignition off, the key fob out of the vehicle, and all doors closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically after a short delay once
all doors are closed.
Note: To change the door lock and unlock settings, go to Remote Lock, Unlock, Start in the Vehicle
Settings menu.
See Keys, Doors and Windows in your Owner Manual.
Keyless Access StartF
Starting the Engine
With the vehicle in Park or Neutral, press
the brake pedal and then press and hold
the ENGINE START/STOP button to start
the engine.
Note: The key fob must be in the vehicle to turn on
the ignition. If the key fob battery is weak, place the
key fob in the pocket in the center console storage
compartment to enable the engine to start. Replace
the key fob battery as soon as possible.
Stopping the Engine
Shift to Park and press the ENGINE START/STOP button to turn off the engine.
Accessory
With the engine off and the brake pedal not applied, press the ENGINE START/STOP
button to place the ignition system in the accessory position.
See Driving and Operating in your Owner Manual.

16
Electric Parking Brake
To apply the parking brake, pull up the Parking Brake switch by the shift lever.
To release the parking brake, turn on
the ignition, press the brake pedal and
press down the
Parking Brake
switch.
See Driving and Operating in your Owner Manual.
Cruise Control
Adjusting Cruise Control
RES+ Resume/Accelerate
Press up to resume a set speed. When the system is active, press up to increase speed.
SET– Set/Coast
When the system is active, press down to decrease speed.
Follow Distance Gap (Adaptive Cruise ControlF only)
Press to select a setting of Far, Medium, or Near.
The system will maintain the set speed and following gap — the time between your
vehicle and a vehicle detected ahead — by accelerating or braking automatically.
Cancel
Press to cancel the cruise control without erasing the set speed from memory.
Pressing the brake pedal also will cancel the cruise control.
The cruise control set speed is erased when cruise control or the vehicle ignition is
turned off.
See Driving and Operating in your Owner Manual.
Setting Cruise Control
1. Press the
On/Off button (or button if equipped with
Adaptive Cruise ControlF). The
Cruise Control symbol will illuminate
in white on the instrument cluster.
2. When traveling at the desired speed,
press the switch down to the SET–
position to set the speed. The
symbol will illuminate in green on the
instrument cluster.