headlamp CADILLAC ELDORADO 1995 10.G Owners Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 1995, Model line: ELDORADO, Model: CADILLAC ELDORADO 1995 10.GPages: 395, PDF Size: 20.17 MB
Page 17 of 395
Downloaded from www.Manualslib.com manuals search engine These symbols have to do with your lights:
a
MASTER LIGHTING SWITCH
A
HAZARD WARNING
FLASHER TURN
SIGNALS
LAMPS OR
HIGH BEAM
pt
~~
PARKING LAMPS
#O
1 FOG LAMPS
These symbols are on some of your controls:
WINDSHIELD
WIPER 81 WASHER
REAR WINDOW
DEFOGGER WINDSHIELD
WASHER
dp
I VENTILATING FAN WINDSHIELD
DEFROSTER
HEADLAMP
WASHER WIPER
vi
Page 87 of 395
Downloaded from www.Manualslib.com manuals search engine If a door or the trunk is opened without the key or Keyless Entry System,
the alarm will
go off. It will also go off if the trunk lock is damaged. Your
vehicle’s lights will flash and the horn will sound
for three minutes and
then the alarm will
go off to save battery power.
Remember, the theft deterrent system won’t arm
if you lock the doors
with
a key or use the manual door lock. It arms only if you use a power
door lock switch or the Keyless Entry System.
Here’s how to avoid setting
off the alarm by accident:
If you don’t want to arm the theft deterrent system, the vehicle should
Always unlock a door with a key, or use the Keyless Entry System.
be locked with the door key after the doors are closed.
Unlocking
a door any other way will set off the alarm.
If you set off the alarm by accident, unlock any door with your key. You
can also turn
off the alarm by using the Keyless Entry System. The alarm
won’t stop
if you try to unlock a door any other way.
How to Test the Alarm
e From inside the vehicle roll down your window, then get out of your
vehicle, keeping the door open.
0 From outside the vehicle with the door open, lock the vehicle using the
Reach in and unlock the door using the manual lock and open the
power
door lock or the Keyless Entry System and close the door.
door. The horn will sound and your headlamps will flash.
If the alarm does not sound when it should, check to see if the horn
works. The horn fuse may be blown.
To replace the fuse, see “Fuses and
Circuit Breakers” in the Index.
If the fuse does not need to be replaced
you may need to have
your Cadillac serviced.
To reduce the possibility of theft, always arm the theft deterrent system
when leaving your vehicle.
2-16
Page 92 of 395
Downloaded from www.Manualslib.com manuals search engine 2. If it doesn’t start right away, hold your key in START for about three
seconds at a time until your engine starts. Wait about
15 seconds
between each try to help avoid draining your battery.
Your left headlamp and left taillamp may be on as you start your
engine, but the right headlamp and taillamp
won’t. This provides some
light as you start but doesn’t drain your battery as much.
flooded with too much gasoline.
Try pushing your accelerator pedal all
the way to the floor and holding it there as you hold the key in
START
for about three seconds. If the vehicle starts briefly but then stops
again, do the same thing.
3. If your engine still won’t start (or starts but then stops), it could be
NOTICE:
Your engine is designed to work with the electronics in your
vehicle.
If you add electrical parts or accessories, you could
change the way the fuel injection system operates. Before
adding electrical equipment, check with your dealer.
If you
, don’t, your engine might not perform properly.
1 If you ever have to have your vehicle towed, see the part of this
~ See “Towing Your Vehicle” in the Index.
I manual that tells how to do it without damaging your vehicle.
DmNG THROUGH DEEP STANDING
WATER
NOTICE:
If you drive too quickly through deep puddles or standing water,
water can come in through your engine’s air intake and badly
damage your engine. Never drive through water that is slightly
lower than the underbody of your vehicle.
If you can’t avoid
deep puddles
or standing water, drive through them very slowly.
2-2 1
Page 109 of 395
Downloaded from www.Manualslib.com manuals search engine TURN SIGNLIMULTIFUNCTION LEVER
The lever on the left side of the steering column includes your:
0 Turn Signal and Lane Change Indicator
0 Headlamp High-Low Beam
Flash-To-Pass Feature
0 Headlamp Washers (Export Only)
Windshield Wipers
Windshield Washer
0 Cruise Control
2-38
Page 111 of 395
Downloaded from www.Manualslib.com manuals search engine As you signal a turn or a lane change, if the arrows don’t flash but just stay on
a signal bulb may be burned
out and other drivers won’t see your turn signal.
If
a bulb is burned out, rcplacc it to help avoid an accident. If the green
arrows don’t go on at all when you signal
a turn, check the fuse (see
“Fuses’’ in
the Index) and for burned-out bulbs.
Wiper Activated Headlumps
This feature activates the headlamps and parking lamps after the
windshield wipers have been in use
for approximately 23 seconds.
In order
to operate the wiper activated headlamps, the twilight sentinel
must
be in the ON position. This feature lights the way in poor weather
and
it also makes your vehicle more visible to other drivers. If the wiper
activated headlamps are
on, and the ignition switch is turned off, the
wiper activated headlamps
will immediately turn off.
The wiper activated headlamps will deactivate if you turn off the twilight
sentinel
or if the windshield wipers have been turned off for a period of
one or two seconds.
Headlamp High-Low Beam
To change the
headlamps from low
beam
to high or high to
low, pull the turn signal
lever all
the way toward
you. Then releasc it.
When the high beams
are on, this blue
light
on thc instrument
panel
will also be on.
Flash-To-Pass Feature
This lets you use your high beam headlamps to signal a driver in front of
you that you want to pass. It works even if your headlamps are off.
2-40
Page 112 of 395
Downloaded from www.Manualslib.com manuals search engine To use it, pull the multifunction lever toward you. When you do:
0 If your headlamps are off your high beam headlamps will turn on.
They'll stay on as long as
you hold the lever there. Release the lever to
turn them
off.
0 If your headlamps are already on low beam, the system works
normally. Just pull the lever. Your headlamps
will shift to high beam
and stay there.
To return to low beam just pull the lever toward you.
If your headlamps are already on high beam, your headlamps will
switch to low beam. To get back to high beam pull the lever toward
you.
Windshield Wipers
WIPER: To control the wipers turn the band on the multifunction lever.
MIST: Turn the band toward you and then release it for a single wipe
cycle. For more cycles hold the band on
MIST longer.
LO or HI: Turn the band away from you to either LO (low speed) or to
HI (high speed), depending on the wiper speed you want.
DELAY: With this you can set the wiper speed for a long or short delay
between wipes. Move the band to the
DELAY position. The closer you
move it to
LO the shorter the delay.
2-4 1
Page 114 of 395
Downloaded from www.Manualslib.com manuals search engine NOTICE:
e When using concentrated washer fluid, follow the
manufacturer’s instructions for adding water.
e Don’t mix water with ready-to-use washer fluid. Water can
cause the solution to freeze and damage your washer fluid
tank and other parts
of the washer system. Also, water
doesn’t clean
as well as washer fluid.
I e Fill your washer fluid tank only 3/4 full when it’s very cold.
This allows
for expansion, which could damage the tank if it
is completely full.
Don’t use radiator antifreeze in your windshield washer. It
can damage your washer system and paint.
Headlamp Washer (Export Only)
If you have this feature, you will wash your headlamps while washing your
windshield at the same time. Just press the
PUSH paddle on the
multifunction lever.
2-43
Page 120 of 395
Downloaded from www.Manualslib.com manuals search engine c
LAMPS
You’ll find the control on the left side of the instrument panel.
It controls these lamp systems:
0
0
0
0
0
0
0
0
0
Headlamps
Taillamps Parking
Lamps
Underhood Lamp
Instrument Panel Lamps
License Plate Lamp
Interior Courtesy Lamps
Fog Lamps (ETC)
Rear
Fog Lamps (Export Only)
INTERtOR
Here’s how to manually work your lamp system:
Pull the switch out to the first stop to turn on your parking and
taillamps, sidemarker lamps and instrument panel lamps.
0 Pull the switch out all the way to turn on the headlamps.
2-49
Page 121 of 395
Downloaded from www.Manualslib.com manuals search engine You can brighten or dim your instrument cluster by rotating the
Press the switch all the way in to turn off your lamps.
Your Cadillac is also equipped with a feature that will automatically turn
your exterior lamps
on after about 25 seconds of wiper operation.
headlamp
switch.
La-mps On Reminder
If you open the door while leaving the lamps on, except when using
twilight sentinel,
you will hear a warning tone.
Interior Lamps
Turn the headlamp switch past HI to turn on the interior lamps.
Twilight Sentinel
The control is next to the headlamp switch. It automatically switches your
lamps
on and off by sensing how dark it is outside. To operate the twilight
sentinel, leave
the lamp switch off and move the control to any position
but
OFF.
If you move the control all the way to MAX, your lamps will remain on
for
1130 seconds after you turn your engine off. If you move the control so
it is just on, the lamps will go off quickly when you turn off your engine.
You can change this delay time from only a few seconds to 180 seconds.
Page 122 of 395
Downloaded from www.Manualslib.com manuals search engine Light Sensor
............ :,,r,.?,;,**;,~,.I ........ " I
Fog Lamps (ETC)
... ... LO Hi TWILIGHT SENTINEL
INTERIOR
dl
The lamp sensor for
the twilight sentinel is
located
in the center of
the front defogger
grille. If
you cover the
sensor,
it will read
"dark" and your lamps
will come on.
Use your fog lamps
for better vision
in
foggy or misty
conditions. When you
press the upper fog
lamp switch, a small
indicator light will
glow to tell
you the
fog lamps are on.
Press the switch again
to turn them
off.
If you switch on your high beam headlamps, your fog lamps will turn off.
They'll turn back on again when you switch to low beam headlamps.
When the twilight sentinel is
on and the fog lamp switch is activated, only
the headlamps will turn
off automatically. Your fog and parking lamps will
remain on.
When the twilight sentinel is on, only the headlamps will turn
off
automatically. Your fog and parking lamps will remain on.
2-5 1