belt CHEVROLET BLAZER 1993 Owner's Manual

Q: What’s wrong with this?
AM125002
A: The belt is twisted across the body.
I CAUTION
You can be seriously injured by a twisted belt, In a crash, you
wouldn’t have the full width of the belt to spread impad forces. If a
belt is twisted, make it straight so it can work properly, or ask your
1 dealer to fix a.
1
.- . r-
AN120123
To unlatch the belt, just push the button on the buckle. The belt should go
back out of the way.
1-25

Seats & Safety Belts
Before you close the door, be sure the belt is out of the way, If you slam
the door on it, you can damage both the belt and your vehicl\
e.
Safety Belt Use During Pregnancy
Safety belts work for everyone, including pregnant women. Like \
all occupants,
they are more likely to be seriously injured
if they don’t wear safety belts.
A pregnant woman should wear a lap-shoulder belt, and the lap po\
rtion
should be worn as
low as possible throughout the pregnancy.
The best way to protect the fetus
is to protect the mother. When a safety
belt is worn properly, it’s more likely that the fetus won’t be \
hurt in a crash.
For pregnant women, as for anyone, the key to making safety belts effective
is wearing them properly.
1-26

Right Front Passenger Position
K2426
The right front passenger’s safety belt works the same way \
as the driver’s safety belt.
See “Driver Position,” earlier in this section.
When the lap portion
of the belt is pulled out all the way, it will lock. If it
does, let it go back all the way and start again.
Center Passenger Position
(Except Wagon Models Second Seat)
If your vehicle has front and rear bench seats, someone can sit in the center
positions.
1-27

- Seats & Safety Belts
When you sit in the center seating position, (except in the second seat of the
Wagon Models) you have a lap safety belt, which has no retractor.
To make
the belt longer, tilt the latch plate and pull it along the \
belt.
I AN145041 AN145043
To make the belt shorter, pull its free end as shown until the belt is snug.
Buckle, position and release
it the same way as the lap part of a
lap-shoulder belt.
If the belt isn’t long enough, see “Safety Belt Extender’’\
at the end of this
section.
Make sure the release button on the buckle faces upward or ou\
tward
so you
would be able to unbuckle
it quickly if you ever had to.
1-28

Center Passenger Position (Wagon Models Second Seat)
K2437
When you sit in the center position of the wagon model second seat, you
have a lap safety belt which has a retractor.
r
.. .. .
AN145053
I. Pick up the latch plate and, in a single motion, pull the belt across you.
2. Push the latch plate into the buckle until it clicks. If the belt stops before
Don’t let
it get twisted.
it reaches the buckle, let it go back all the way and start again.
1-29

Seats & Safety Belts
3. Feed the lap belt into the retractor to tighten it.
4. Position and release it the same way as the lap part of a lap-shoulder
belt.
If the belt isn’t long enough, see “Safety Belt Extender” \
at the end of this
section. Make sure the release button on the buckle faces upwa\
rd or outward
so you would be able to unbuckle it quickly if you ever had to.
AN145054
Rear Seat Passengers
It’s very important for rear seat passengers to buckle up! Accident statistics
show that unbelted people in the rear seat are hurt more often in crashes
than those who are wearing safety belts.
Rear passengers who aren’t safety belted can be thrown out of the vehicle in
a crash. And they can strike others in the vehicle who are wearing safety
belts.
1-30

Rear Seat Outside Positions
Lap-Shoulder Belt
The positions next to the windows have lap-shoulder belts. Here’s how to
wear one properly.
1. Pick up the latch plate and pull the belt across you. Don’t let it get\

twisted.
AN14702
2. Push the latch plate into the buckle until it clicks.
If the belt stops before it reaches the buckle, tilt the latch plate and
keep pulling until you can buckle it.
1-31

If the belt is not long enough, see “Safety Belt Extender” at the end of
this section. Make
sure the release button on the buckle faces upward or outward so
you would be able to unbuckle it quickly if you ever had to.
AN147096
To make the lap part tight, pull down on the buckle end of the belt as
you pull up the shoulder part.
L
.
1
I1
AM1 20007
The lap part of the belt should be low and snug on the hips, just touching
the thighs. In a crash, this applies force
to the strong pelvic bones. And
you’d be less likely
to slide under the lap belt. If you slid under it, the belt
1-32

would apply force at your abdomen. This could cause serious or even fatal
injuries. The shoulder belt should go over the shoulder and across the chest.
These parts
of the body are best able to take belt restraining forces.
The safety belt locks
if there is a sudden stop or a crash.
You can be seriously hurt
if your shoulder belt is too loose. In a
The shoulder belt should fit against your body.
'b crash you would move forward too much, which could increase injury.
I L
I CAUTION
r
AN147030
To unlatch the belt, just push the button on the buckle.
1-33

Seats & Safety Belts
AN1 50036
Everyone in a vehicle needs protection! That includes infants and all children
smaller than adult size. In fact, the law in every state and Canadian province
says children up to some age must be restrained while in
a vehicle.
Smaller Children and Babies
CAUTION
I A Smaller children and babies should always be restrained in a child or
b infant restraint. The instructions for the restraint will say whether it is
the right
type and size for your child. A very young child's hip bones
are so small that a regular belt might not stay low on the hips, as it
should. Instead, the belt will likely be over the child's abdomen. In a
crash the belt would apply force right on the child's abdomen, which
could cause serious or fatal injuries. So, be sure that any child small
enough for one is always properly restrained in a child or infant
restraint.
I
134