lock CHEVROLET BLAZER 1996 2.G User Guide

Downloaded from www.Manualslib.com manuals search engine 1 Rear Seat Passengers
I It’s very important for rear seat passengers to buckle up!
Accident statistics show that unbelted people in the rear
1 seat are hurt more often in crashes than those who are
! wearing safety belts.
Rear passengers who aren’t safety belted can be thrown
1 out of the vehicle in a crash. And they can strike others
i in the vehicle who are wearing safety belts.
j Rear Seat Outside Passenger Positions
1
I
:,i
l Lap-Shoulder Belt
1 The positions next to the windows have lap-shoulder
! belts. Here’s how to wear one properly.
i
1. Pick up the latch plate and pull the belt across you.
Don’t let it get twisted. On four-door models, the
shoulder belt may lock if you pull the belt across
you.
very quickly. If this happens, let the belt go back
slightly to unlock it. Then pull the belt across you
more slowly.

Downloaded from www.Manualslib.com manuals search engine 2. Push the latch plate into the buckle until it clicks.
Pull
up on the latch plate to make sure it is secure.
When
the shoulder belt is pulled out all the way, it
will lock. If it does, let
it go back all the way and
start again.
If the belt
is not long enough, see “Safety Belt
Extender” at the end of this section.
Make sure
the release button on the buckle is
positioned so you would be able to unbuckle the
safety belt quickly
if you ever had to.
3. To make the lap part tight, pull down on the buckle
end of the belt as you pull up on the shoulder part.
1-27

Downloaded from www.Manualslib.com manuals search engine The lap part of the belt should be worn low and snug on
the hips, just touching
the thighs. In a crash, this applies
force to the strong pelvic bones. And you’d be less likely
to slide under the lap
belt. If you slid under it, the
belt would apply force at your abdomen. This could
cause serious or even
fatal injuries. The shoulder belt
should
go over the shoulder and across the chest.
These parts of the body are best able to take belt
restraining forces.
The safety belt locks if there’s a sudden stop or a crash.
On four-door models, the safety belt also locks if
you
pull the belt very quickly out of the retractor.
A CAUTION:
You can be serious1 hurt if your shoulder belt is
too loose. In a crash, you would move forward
too much, which could increase injury. The
shoulder belt should fit against your body.
1-28

Downloaded from www.Manualslib.com manuals search engine 4. Buckle the belt. Make sure the release button is
positioned so you would be able to unbuckle the
safetv belt quickly if
you ever had to.
5. Pull the rest of the shoulder belt all the way out of
the retractor to set the lock.
1-37

Downloaded from www.Manualslib.com manuals search engine i b
j 4. Buckle the belt. Make sure the release button is 5. Pull the rest of the shoulder belt all the way out of
positioned so you would be able to unbuckle the the retractor to set the lock,.
safety belt quickly if
you ever had to.
1-40

Downloaded from www.Manualslib.com manuals search engine . This vehicle has one
double-sided key for
the ignition, endgate,
spare tire lock (two-door
vehicles) and door locks.
side up.
1 It will fit with either
When a new vehicle is delivered, the dealer provides the
owner with a pair
of identical keys and a bar-coded tag.
The bar-coded tag has a code on it that tells your dealer
or a qualified locksmith how to make extra keys. Keep
this tag
in a safe place. If you lose your keys, you’ll be
able to have new ones made easily using this tag.
I NOTICE:
Your vehicle has a number of new features that
can help prevent theft. But you can have a lot
of trouble getting into your vehicle if you ever
lock your keys inside.
You may even have to
damage your vehicle to get in.
So be sure you
have extra keys.
2-2

Downloaded from www.Manualslib.com manuals search engine Door Locks
A CAUTION: -1
Unlocked doors can be c---,xous.
Passengers
-- especially children -- can easily
open the doors and fall out. When a door is
locked, the inside handle won't open it.
Outsiders can easily enter through an unlocked
door when you slow down or stop your vehicle.
This may not be
so obvious: You increase the
chance of being thrown out of the vehicle in a
crash
if the doors aren't locked. Wear safety belts
properly, lock your doors, and you will be far
better off whenever you drive your vehicle. There
are several ways to lock and unlock your vehicle.
You can use the Keyless Entry system, if you have
this option.
You can
use your key to unlock your door from
the outside.
To unlock the door, slide the lever on your inside door
forward.
You will see a red area on the ,lever.
2-3

Downloaded from www.Manualslib.com manuals search engine Power Door Locks (Option)
r
If your vehicle has power
door locks,
the switch is
located on the armrest.
Press
LOCK to lock all
I
the doors at once.
Rear Door Security Lock
With this feature, you can
lock the rear doors
so they
can’t be opened from
the
inside by passengers.
Move the lock up to lock
the doors and down to
release the door locks.
To unlock the doors, press the raised area next to the
key symbol.
On four-door models, the lever
on each rear door works
only that door’s lock.
Leaving Your Vehicle
If you are leaving the vehicle, take your key, open your
door and set the locks from inside. Then get out and
close the door.
2-4

Downloaded from www.Manualslib.com manuals search engine Keyless Entry System (Option)
If your vehicle has this option, you can lock and unlock
your doors or unlock your rear endgate from up to
30 feet (9 m) away using the key chain transmitter
supplied with your vehicle.
Your Keyless Entry System operates
on a radio
frequency subject
to Federal Communications
Commission (FCC) Rules.
This device complies with Part 15 of the FCC Rules.
Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
Should interference to this system occur, try this:
Check to determine if battery replacement is
necessary. See the instructions on battery
replacement.
0 Check the distance. You may be too Far from your
vehicle. This product has
a maximum range.
0 Check the location. Other vehicles or objects may be
blocking the signal.
0 See your GM dealer or a qualified technician
for service.
Changes or modifications to this system by other than an
authorized service facility could void authorization to
use this equipment.
Operation
When you press UNLOCK, the driver’s door and
endgate
will unlock automatically. If you press
UNLOCK again within five seconds, all doors will
unlock. Press LOCK to lock all the doors.
Press the REAR button twice
within 3 1/2 seconds to
unlock and unlatch the endgate glass. If your vehicle has
an automatic transmission, the transmission must be
in
PARK (P) or NEUTRAL (N). If your vehicle has a
manual transmission, you must engage parking brake.
2-5

Downloaded from www.Manualslib.com manuals search engine Matching Transmitter(s) To Your Vehicle
Each key chain transmitter is coded to prevent another
transmitter from unlocking your vehicle.
If a transmitter
is lost or stolen, a replacement can be purchased through
your dealer. Remember
to bring any remaining
transmitters with
you when you go to your dealer. When
the dealer matches
the replacement transmitter to your
vehicle, any remaining transmitters must also be
matched. Once the new transmitter is coded,
the lost
transmitter will not unlock your vehicle. Each vehicle
can have only two transmitters matched to
it.
Battery Replacement
Under normal use, the batteries in your key chain
transmitter should last about two years.
You can tell the batteries are weak if the transmitter
won’t work at the normal range in any location. If you
have
to get close to your vehicle before the transmitter
works, it’s probably time
to change the batteries.
To replace the batteries in the Keyless Entry transmitter:
I. Insert a dime in the slot between the covers of the
transmitter housing near the key ring hole. Remove
the bottom by twisting the dime.
Duracell@-type batteries
(DL2016 or equivalent),
positive side down.
2. Remove and replace the batteries with two
3. Align the covers and snap them together.
4. Check the operation of the transmitter.
2-6