ESP CHEVROLET TRACKER 1995 Owner's Manual

Temperature - A, B, C
The temperature grades are A (the highest), B, and C,
representing the tire’s resistance to the generation of
heat and its ability to dissipate heat when tested under
controlled conditions on a specified indoor laboratory
test wheel. Sustained high temperature can cause the
material
of the tire to degenerate and reduce tire life,
and excessive temperature can lead to sudden tire
failure. The grade
C corresponds to a level of
performance which all passenger car tires must meet
under the Federal Motor Vehicle Safety Standard
No. 109. Grades B and A represent higher levels of
performance
on the laboratory test wheel than the
minimum required by law.
Warning: The temperature grade for this tire is
established for a tire
that is properly inflated and not
overloaded. Excessive speed, underinflation, or
excessive loading, either separately or in combination,
can cause heat buildup and possible tire failure. These
grades are molded
on the sidewalls of passenger
car tires.
While the tires available as standard or optional
equipment on General Motors vehicles may vary with
respect to these grades, all such tires meet General
Motors performance standards and have been approved
for use on General Motors vehicles. All passenger type
(P Metric) tires must conform to Federal safety
requirements
in addition to these grades.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced
carefully at the factory to give you the longest tire life
and best overall performance.
In most cases, you will
not need to have your wheels
aligned again. However, if you notice unusual tire wear
or your vehicle pulling one way or the other, the
alignment may need to be reset.
If you notice your
vehicle vibrating when driving on
a smooth road, your
wheels may need to be rebalanced.
ProCarManuals.com

Gem Section 8 Customer Assistance Information
Here you will find out how to contact Chevrolet/Geo if
you need assistance. This section also tells you how to
obtain service publications and how
to report any safety
defects
.
This section includes information on: The Customer
Satisfaction Procedure, Customer Assistance for Hearing
or Speech Impaired,
BBB Autoline - Alternative Dispute
Resolution Program, Reporting Safety Defects, and
Service and Owner Publications.
Customer Satisfaction Procedure
Your satisfaction and goodwill are important to your
dealer and Chevrolet/Geo. Normally, any concern with
the sales transaction or the operation
of your vehicle will
be resolved by your dealer’s Sales
or Service
Departments. Sometimes, however, despite the best
intentions
of all concerned, misunderstandings can
occur.
If your concern has not been resolved to your
satisfaction, the following steps should
be taken:
STEP ONE -- Discuss your concern with a member
of dealership management. Normally, concerns can be
quickly resolved at that level. If the matter has already been\

reviewed with the Sales, Service,
or Parts Manager, contact
the owner
of the dealership or the General Manager.
STEP TWO -- If after contacting a member of
dealership management,
it appears your concern cannot
be resolved by the dealer without further help, contact
the Chevrolet/Geo Customer Assistance Center by
calling 1-800-222-1020.
In Canada, contact GM of
Canada Customer Assistance Center in Oshawa by
calling
1 -8OO-263-3777 (English) or I -800-263-7854
(French).
In Mexico, call (525) 254-3777. In Puerto Rico, call
1-800-496-9992 (English) or 1-800-496-9993
(Spanish).
In the U.S. Virgin Islands, call
1-800-496-9994.
In other overseas locations, contact
GM North American Export Sales in Canada by calling
1-905-644-4112.
ProCarManuals.com