buttons CHEVROLET TRACKER 1997 Owners Manual

NOTICE: (Continued)
Opening and Closing Your Sunroof
0
0
0
Don’t lower the top if it is damp or wet.
After the top
is down, the trapped water
can cause stains, mildew and damage to the
inside of your car. Be sure to dry
off the top
before you lower it.
Don’t lower the convertible top if the rear
flap
or side windows are dirty. Dirt could
scratch the side windows.
The convertible top isn’t designed to carry
weight. Never let anyone sit on the top? and
don’t put anything on top
of it when it is
up, or it could be damaged.
1. Lower your antenna and swing your sun
visors
down.
2. Squeeze the front top bow latch buttons and pull the
latch back.
2-45
ProCarManuals.com

4. Unfasten the snaps that secure the canvas top to the
roof piece. The snaps are located
on either side of the
dome lamp.
5. Lower the sun visors
and push both sides of
the lock buttons
on the
front latches.
2-51
ProCarManuals.com

AM-FM Stereo (If Equipr
Playing the Radio
ON-VOL: This knob turns the system on and off and
controls the volume.
To increase volume and turn the
radio on, turn the knob clockwise. Turn it
counterclockwise
to decrease volume.
RCL: Display the time with the ignition off by pressing
this button. When the radio is playing, press this button
to recall the station frequency.
Finding a Station
AM-FM: Press this button to switch between AM and
FM. The lighted display shows your selection.
TUNE: Press the right or left arrow to go to a higher or
lower station. Press and hold to continue tuning and
release when you find your station. The display will
show the frequency of each station tuned.
SEEK: Press the right or left arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS: The six numbered pushbuttons let
you return to your previously played stations. You can
set up to
12 stations (six AM and six FM). Just:
1. Turn the radio on.
2. Press AM-FM to select the band.
3. Tune in the desired station.
4. Press one of the six pushbuttons for at least
two seconds. The sound will mute and then return
when the station is stored. Whenever
you press that
numbered button, the station you set will return.
5. Repeat the steps for each pushbutton.
3-7
ProCarManuals.com

RCLFROG: Display the time with the ignition off by
pressing this button. When the radio
is playing, press
this button
to recall the station frequency.
Finding a Station
AM-FM: Press this button to switch between AM, FMl
and FM2. The display shows your selection.
TUNE: Press the right or left arrow to go to a higher or
lower station. Press and hold to continue tuning and
release when you find your station. The display will
show the frequency of each station tuned.
SEEK: Press the right or left arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS: The six numbered pushbuttons let you
return to your previously played stations.
You can set up to
18 stations (six AM, six FM1 and six FM2). Just:
1. Turn the radio on.
2. Press AM-FM to select the band.
3. Tune in the desired station.
4. Press one of the six pushbuttons for at least
two seconds. The sound
will mute and then return
when the station is stored. Whenever you press that
numbered button, the station you
set will return.
5. Repeat the steps for each pushbutton.
PRESET SCAN: Press this button to hear each of your
favorite stations stored on your pushbuttons for
a few
seconds. When you want to stop at
a chosen station.
press PRESET
SCAN again.
Setting the Tone
BASS:
Turn the control behind the TREB knob
clockwise to increase bass. Turn it counterclockwise to
decrease bass.
TREB: Turn this knob clockwise to increase treble.
Turn it counterclockwise to decrease treble. If a station
is weak or noisy, you may want to decrease the treble.
Treble and bass cannot be adjusted manually when
TONE SELECT
is on.
TONE SELECT Press this button to choose preset bass
and treble equalization settings designed for ROCK,
NEWS, POP, JAZZ and CLASSICAL. ROCK will
appear when you first press TONE SELECT. Each time
you press it, another setting will appear on the display. If
you press it one more time, after CLASSICAL appears
on the display, tone control will be back to
the BASS and
TREB knob.
3-9
I
ProCarManuals.com

Adjusting the Speakers
BAL: Turn this control behind the FADE knob to move
the sound between
the right and left speakers. The middle
position balances the sound between the speakers.
FADE: Turn this knob to move the sound between the
front and rear speakers. The middle position balances
the sound between the speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that
are so thin they may not work well in this player.
The longer side with the tape visible should face to the
right. If you hear nothing or hear just a garbled sound,
it
may not be in squarely. Press EJECT to remove the tape
and start over.
Once the tape is playing, use the
knobs for VOL, FADE,
TREB, BASS and BAL just as
you do for the radio. The
lighted arrows show which side of the tape is playing.
REW (1): Press this button to reverse the tape rapidly.
Press REW or RCLPROG to return to playing speed. If
you press RCLPROG, the tape will also change sides.
R-M (2): Press this button to hear the radio when you
are fast forwarding or reversing a cassette tape.
You can
use the TUNE, SEEK and PRESET SCAN buttons
while
in the radio monitor mode. The six preset buttons
cannot be used while
in this mode.
FF (3): Press this button to advance rapidly to another
part of the tape. Press
FF, RCLPROG or EJECT to
return to playing speed.
PREV (4): Press this button to go back to the beginning
of the last selection. Press PREV again or press
RCLPROG or EJECT to cancel this function.
01 (5): Press this button to reduce background noise
from tapes encoded with Dolby NR.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
NEXT (6): Press this button to go forward to the
beginning
of the next selection. Press the button again or
press RCL/PROG or EJECT to cancel this function.
For NEXT to work properly, your tape must
have at
least three or four seconds
of silence between each
selection. If you press RCLPROG,
the tape will also
change sides.
3-10
ProCarManuals.com

Finding a Station
AM-FM:
Press this button to get AM, FMl or FM2.
The display shows your selection.
TUNE: Press the right or left arrow to go to a higher or
lower station. Press and hold to continue tuning and
release when you find your station. The display will
show the frequency of each statior! tuned.
SEEK: Press the right or left arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS: The six numbered pushbuttons let you
return
to your previously played stations. You can set up to
18 stations (six AM, six FM1 and six FM2). Just:
1.
2.
3.
4.
5.
Turn the radio on.
Press AM-FM to select the band.
Tune
in the desired station.
Press one of
the six pushbuttons, for at least two
seconds. The sound will mute and then return when
the station is stored. Whenever
you press that
numbered button, the station you
set will return.
Repeat the steps for each pushbutton.
PSCAN: Press this button to listen to each of your
favorite stations stored on your pushbuttons for a few
seconds. The radio will scan through each
of the stations
stored
on your pushbuttons. When you want to stop at a
chosen station, press PSCAN aeain.
Setting the Tone
BASS:
Turn the control behind the TREB knob
clockwise to increase bass. Turn it counterclockwise to
decrease bass.
TREB: Turn this knob clockwise to increase treble.
Turn it counterclockwise to decrease treble.
If a station
is weak or noisy, you may want to decrease the treble.
Treble and bass cannot be adjusted manually when
TONE SELECT is on.
TONE SELECT Press this button to choose preset
bass and treble equalization settings designed for
ROCK, NEWS,
POP, JAZZ and CLASSICAL. ROCK
will appear when you first press TONE SELECT. Each
time you press it, another setting will appear on the
display. If you press it one more time, after
CLASSICAL appears on the display, tone control will
be back to the BASS and TREB knob.
LOUD: To increase bass at low volumes, press this
button. LOUD
will appear in the display.
3-12
ProCarManuals.com

RDM (5): Press this button to hear the tracks in random,
rather than sequential, order. Press RDM or RPT again
to turn off random play.
NXT (6): Press this button to go to the next track. If you
hold the button, or press it more than once, the player
will continue moving forward through the disc.
COMP: Press this button to make soft and loud
passages more nearly equal in volume.
RCL: Press this button to see which track is playing.
Press RCL again, within five seconds, to see how long
it has been playing (elapsed time). The track number
also appears when the disc
is inserted or you change
the volume.
CD-TP: Press this button to switch between playing a
tape and a CD when both are inserted.
STOP: Press this button or AM-FM to stop playing the
disc and switch to radio. Press STOP again
to restart the
disc at the point where it stopped.
EJECT Press this button to remove the disc. The radio
will play. The disc will start at the first track when you
reinsert it. If you leave a compact disc in the player
while listening to the radio, it may become warm.
Theft-Deterrent Feature
The theft-deterrent feature for the AM-FM stereo with
cassette tape or compact disc player can be used or
ignored.
If ignored, the system plays normally. If it is
used, your system won’t be usable if it’s ever stolen
because it will
go into LOC mode.
If your vehicle loses battery power for any reason, you
must enter your secret code again before the system will
turn on.
Activating the Theft-Deterrent Feature
The following instructions will tell you how to enter a
security code into
the system.
NOTE: If you allow more than 15 seconds to elapse
between any steps, the radio automatically reverts to
time and you must start the procedure over at Step
4.
1. Write down any four-digit number and keep it in a
safe place.
2. Turn the ignition switch to ACC or ON.
3. Turn the radio off.
4. Press the 1 and 4 buttons together. Hold them down
until
---- shows on the display.
ProCarManuals.com

5. Press the SEEK right or left arrow, or the TUNE
right or left arrow and
0000 will appear on
the display.
6, Press the SEEK left arrow and hold it until the first
digit of your code appears. Release the button.
7. Press the SEEK right arrow and hold it until the
second digit of your code appears. Release
the button.
8. Press the TUNE left arrow and hold it until the third
digit
of your code appears. Release the button.
9. Press the TUNE right arrow and hold it until the
fourth digit of your code appears. Release
the button.
10. Press AM-FM after you have checked that the code
you entered
is the one you wrote down. Then, REP
will appear on the display which means you need to
repeat Steps
5 through 9.
11. Press AM-FM again and the display will now
show SEC.
Disabling the Theft-Deterrent Feature
If your radio is secured (SEC shows on the display) and
you wish to disable it, enter your security code as follows,
pausing no more than
15 seconds between steps.
1.
2.
3.
4.
5.
6.
i.
Press the 1 and 4 buttons together. Hold them down
until SEC shows on the display. You are now ready
to enter your security code.
Press the SEEK left arrow and hold it until the first
digit of your code appears.
Press the SEEK right arrow and hold
it until the
second digit of your code appears.
Press the TUNE left arrow and hold it until the third
digit of your code appears.
Press the TUNE right arrow and hold it until the
fourth digit
of your code appears.
Press AM-FM after you have checked that the code
you entered matches the one you wrote down and
0000 should now appear on the display. You will
need to repeat the above procedure.
If the code is correct, the radio will now operate. If
the code is wrong, ERR will appear on the display.
3-16
ProCarManuals.com