check engine CHEVROLET TRACKER 1998 1.G Manual PDF

Downloaded from www.Manualslib.com manuals search engine Long Tripmighway Maintenance Schedule
The services shown in this schedule up to 100,000 miles
(166 000 km) should be performed after 100,000 miles
(166
000 km) at the same intervals.
See “Owner Checks and Services” and “Periodic
Maintenance Inspections” following.
Footnotes
‘f The U.S. Environmental Protection Agency or the
California Air Resources Board has determined that the
failure to perform this maintenance item will not nullify
the emission warranty or limit recall liability prior to the
completion of the vehicle’s useful life. We, however,
urge that all recommended maintenance services be
performed at the indicated intervals and the maintenance
be recorded.
+ A good time to check your brakes is during tire
rotation. See “Brake System Inspection” under “Periodic
Maintenance Inspections” in
Part C of this schedule.

Downloaded from www.Manualslib.com manuals search engine 1 Long Trip/Highway Maintenance Schedule I
Inspect the locking front hubs (if equipped) for correct operation (or every
3 months, whichever occurs first). Repair or replace if necessary.
0 Inspect the valve lash and adjust if necessary.
An Emission Control Service.
0 Check engine idle speed and adjust it to underhood label specifications.
0 Inspect propeller shafts and u-joints for looseness and damage (or every
An Emission Control Service. (See footnote?.)
15 months, whichever occurs first). Inspect more frequently if used off-road
or for pulling a trailer. Tighten u-joint flange bolts if necessary.
22,500 Miles (37 500 km)
0 Change engine oil and filter (or every 7.5 months, whichever occurs first).
Rotate tires. See “Tire Inspection and Rotation” in the Index for proper
0 Inspect the locking front hubs (if equipped) for correct operation (or every
An Emission Control Service.
rotation pattern and additional information. (See footnote +.)
3 months, whichever occurs first). Repair or replace if necessary\
.
I DATE I
30,000 Miles (50 000 km)
0 Change engine oil and filter (or every 7.5 months, whichever occurs first).
An Emission Control Service.
7-33

Downloaded from www.Manualslib.com manuals search engine Long Tripmighway Maintenance Schedule
0 Replace spark plugs. An Emission Control Service.
0 Replace air cleaner filter.
An Emission Control Service.
0 Inspect fuel tank, cap and lines for damage or leaks. Inspect fuel cap gasket
for any damage. Replace parts as needed.
An Emission Control Service. (See footnote?.)
0 Change manual transmission fluid.
0 Change transfer case fluid.
0 Change differential fluid.
0 Replace fuel filter (or every 30 months, whichever occurs first, or sooner if
filter is clogged).
An Emission Control Service. (See footnote "f)
3 months, whichever occurs first). Repair or replace if necessary.
0 Inspect the locking front hubs (if equipped) for correct operation (or every
0 Inspect the valve lash and adjust if necessary.
0 Check engine idle speed and adjust it to underhood label specifications.
An Emission Control Service.
An Emission Control Service. (See footnote"f)
0 Inspect propeller shafts and u-joints for looseness and damage (or every
15 months, whichever occurs fist). Inspect more frequently if used off-road
or for pulling a trailer. Tighten u-joint flange bolts if necessary.
7-35

Downloaded from www.Manualslib.com manuals search engine Long Tripmighway Maintenance Schedule
Rotate tires. See “Tire Inspection and Rotation” in the Index for proper
Inspect the locking front hubs (if equipped) for correct operation (or every
Inspect the valve lash and adjust if necessary.
rotation pattern and additional information. (See footnote
+.)
3 months, whichever occurs first). Repair or replace if necessary.
An Emission Control Service.
’ Check
engine idle speed and adjust it to underhood label specifications.
0 Inspect propeller shafts and u-joints for looseness and damage (or every
An Emission Control Service. (See footnote?.)
15 months, whichever occurs first). Inspect more frequently if used off-road
or for pulling a trailer. Tighten u-joint flange bolts if necessary.
50,000 Miles (83 000 km)
0 Replace Positive Crankcase Ventilation (PCV) valve. Replace any\
worn,
plugged or collapsed hoses.
An Emission Control Service.
52,500 Miles (87 500 km)
0 Change engine oil and filter (or every 7.5 months, whichever occurs first).
An Emission Control Service.
(Continued)
I DATE I
MILEAGE
ACTUAL SERVICED BY:
I DATE I
SERVICED BY:
7-37

Downloaded from www.Manualslib.com manuals search engine Long TripMighway Maintenance Schedule 1
60,000 Miles (100 000 km) (Continued)
0 Inspect the valve lash and adjust if necessary.
0 Check engine idle speed and adjust it to underhood label specifications.
0 Adjust engine timing to underhood label specifications. Inspect \
the inside and
An Emission Control Service.
An Emission Control Service.
(See footnote?.)
outside of the distributor cap and rotor for cracks, carbon tracking and
corrosion. Clean or replace
as needed.
An Emission Control Service.
An Emission Control Service.
(See footnote?’.)
Inspect emission system hoses and replace as necessary.
0 Inspect propeller shafts and u-joints for looseness and damage \
(or every
15 months, whichever occurs first). Inspect more frequently if use\
d off-road
or for pulling a trailer. Tighten u-joint flange bolts if nece\
ssary.
damage
(or every 60 months, whichever occurs first).
An Emission Control Service. (See footnote?.)
An Emission Control Service. (See footnote “f)
An Emission Control Service.
0 Inspect the underhood wiring harness for loose connections, chaf\
ed wires and
0 Replace the camshaft timing belt.
0 Replace spark plug wires (or every 60 months, whichever occurs first).
0 Drain, refill and bleed the brake system.
7-40

Downloaded from www.Manualslib.com manuals search engine Long Tripmighway Maintenance Schedule
75,000 Miles (125 000 km) (Continued)
0 Rotate tires. See “Tire Inspection and Rotation” in the Index for proper
0 Inspect the locking front hubs (if equipped) for correct operation (or every
0 Inspect the valve lash and adjust if necessary.
Check engine idle speed and adjust it to underhood label specifications.
0 Inspect propeller shafts and u-joints for looseness and damage (or every
rotation pattern and additional information. (See footnote
+.)
3 months, whichever occurs first). Repair or replace
if necessary.
An Emission Control Service.
An Emission Control Service.
(See footnote?.)
15 months, whichever occurs first). Inspect more frequently if used off-road
or for pulling a trailer. Tighten u-joint flange bolts
if necessary.
82,500 Miles (I37 500 km)
0 Change engine oil and filter (or every 7.5 months, whichever occurs first).
0 Rotate tires. See “Tire Inspection and Rotation” in the I\
ndex for proper
0 Inspect the locking front hubs (if equipped) for correct operation (or every
An Emission Control Service.
rotation pattern and additional information. (See footnote +.)
3 months, whichever occurs first). Repair or replace if necessary.
DATE I
MILEAGE
7-42

Downloaded from www.Manualslib.com manuals search engine 1 Long Tripmighway Maintenance Schedule I
Inspect the valve lash and adjust if necessary.
Check engine idle speed and adjust it to underhood label specifications.
0 Inspect propeller shafts and u-joints for looseness and damage (or every
An Emission Control Service.
An Emission Control Service. (See footnote”f)
15 months, whichever occurs first). Inspect more frequently if use\
d off-road
or for pulling a trailer. Tighten u-joint flange bolts if necessary.
rotation pattern and additional information. (See footnote
+.)
Rotate tires. See “Tire Inspection and Rotation” in the Index for proper
97,500 Miles (162 500 km)
Change engine oil and filter (or every 7.5 months, whichever occurs first).
An Emission Control Service.
0 Rotate tires. See “Tire Inspection and Rotation” in the Index for proper
0 Inspect the locking front hubs (if equipped) for correct operation (or every
rotation pattern and additional information. (See footnote +.)
3 months, whichever occurs first). Repair or replace if necessary.
I DATE
7-45

Downloaded from www.Manualslib.com manuals search engine Part B: Owner Checks and Services
Listed below are owner checks and services which should be performed at the intervals specified to help
ensure the safety, dependability and emission control
performance of your vehicle.
Be sure any necessary repairs are completed at once.
Whenever any fluids or lubricants are added to your
vehicle, make sure they are the proper ones, as shown
in
Part D.
At Each Fuel Fill
It is important for you or a service station attendant to
per3corm these underhood checks at eachfuelfill.
Engine Oil Level Check
Check the engine oil level and add the proper oil
if necessary. See “Engine Oil” in
the Index for
further details.
Engine Coolant Level Check
Check the engine coolant level and add the proper
coolant mixture if necessary. See “Engine Coolant” in
the Index for further details.
Windshield Washer Fluid Level Check
Check the windshield washer fluid level in the
windshield washer tank and add the proper fluid
if
necessary. See “Windshield Washer Fluid” in the
Index for further details.
Hood Latch Operation Check
Pull the primary hood latch release handle inside the
vehicle. The secondary latch should keep the hood from
opening all the way when the primary latch is released.
Make sure the hood closes firmly. See “Hood Release”
in the Index for further details.
At Least Once a Month
Tire Inflation Check
Make sure tires are inflated to the correct pressures.
See “Tires” in the Index for further details.
Cassette Deck Service
Clean cassette deck. Cleaning should be done every
50 hours of tape play. See “Audio Systems” in the
Index for further details.
7-47

Downloaded from www.Manualslib.com manuals search engine At Least Twice a Year
Restraint System Check
Make sure the safety belt reminder light and all your
belts, buckles, latch plates, retractors and anchorages are working properly. Look for any other loose or damaged
safety belt system parts. If you see anything that might
keep a safety belt system from doing its job, have it
repaired. Have any torn or frayed safety belts replaced.
Also look for any opened or broken air bag coverings,
and have them repaired or replaced. (The air bag system
does not need regular maintenance.)
Wiper Blade Check
Inspect wiper blades for wear or cracking. Replace blade
inserts that appear worn or damaged or that streak or
miss areas of the windshield. Also
see “Wiper Blades,
Cleaning” in the Index.
Fluid Level Check
Check the transfer case, axle differential(s) and
automatic
or manual transmission fluid levels and add
as needed. See “Transfer Case,” “Axle, Rear,” “Axle,
Front” and “Automatic Transmission” or “Manual
Transmission” in the Index. Check for leaks.
A fluid loss
in these systems could indicate a problem. Have the
system inspected and repaired at once.
Automatic Transmission Check
Check the transmission fluid level; add if needed. See
“Automatic Transmission” in the Index. A fluid
loss
may indicate a problem. Check the system and repair
if needed.
At Least Once a Year
Key Lock Cylinders Service
Lubricate the key lock cylinders with the lubricant specified in Part
D.
Body Lubrication Service
Lubricate all body door hinges. Also lubricate all
hinges and latches, including those for the hood, rear
compartment, glove box door, console door and any
folding seat hardware.
Part D tells you what to use.
More frequent lubrication may be required when
exposed to a corrosive environment.
7-48

Downloaded from www.Manualslib.com manuals search engine Starter Switch Check Brake-Transmission Shift Interlock (BTSI) Check
(Automatic Transmission)
’ A CAUTION: I
When you are doing this check, the vehicle could
move suddenly. If it does, you
or others could be
injured. Follow the
steps below.
1. Before you start, be sure you have enough room
around the vehicle.
2. Firmly apply both the parking brake (see “Parking
Brake” in the Index if necessary) and the regular brake.
NOTE:
Do not use the accelerator pedal, and be
ready to turn
off the engine immediately if it starts.
3. On automatic transmission vehicles, try to start the
engine
in each gear. The starter should work only in
PARK
(P) or NEUTRAL (N). If the starter works in
any other position, your vehicle needs service.
On manual transmission vehicles, put the shift
lever
in NEUTRAL (N), push the clutch down halfway
and try to start the engine. The starter should work
only when the clutch is pushed down all the way to
the floor.
If the starter works when the clutch isn’t
pushed all the way down, your vehicle needs service.
A CAUTION:
When you are doing this check, theqehicle could
I
move suddenly. If it does, you or others could be
injured. Follow the steps below.
I
1. Before you start, be sure you have enough room around the vehicle. It should be parked on a
level surface.
2. Firmly apply the parking brake (see “Parking Brake”
in the Index
if necessary).
NOTE: Be ready to apply the regular brake
immediately if the vehicle begins to move.
3. With the engine off, turn the key to the
ON position,
but don’t start the engine. Without applying the
regular brake, try to move the shift lever out of
PARK (P) with normal effort. If the shift lever
moves out of PARK (P), your vehicle’s BTSI
needs service.
7-49
-