CHRYSLER CARAVAN 2000 Service Manual

TEST TC-27AREPAIRING - DIAGNOSTIC LAMP SHORT CIRCUIT
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
START TEST WITH THE DRB, READ DOES THE DRB YES REPAIR OTHER
TC-27A. FAULT CODES. DISPLAY OTHER FAULTS BEFORE
CODES. CONTINUING.
NO
WITH THE DRB,
ACTUATE THE IS THE DIAG/GLOW NO CONTINUE TEST
DIAG/GLOW PLUG PLUG LAMP FLASHING TC-27A ON THE
LAMP. ON AND OFF? NEXT PAGE.
YES
THE CONDITION TO SET USING THE SCHEMATIC
THE TROUBLE CODE IS AS A GUIDE, INSPECT WERE ANY PROBLEMS YES REPAIR AS
NOT PRESENT. THE WIRING AND FOUND? NECESSARY.*
CONNECTORS.
FIG.1 FIG.2
NO
WIGGLE THE WIRING NOTE: THE DRB MUST DID THE WIGGLING REPAIR AS
HARNESS FROM THE STILL BE ACTUATING INTERUPT THE YES NECESSARY WHERE
MESSAGE CENTER TO THE DIAG/GLOW PLUG DIAG/GLOW PLUG WIGGLING CAUSED
THE ENGINE CONTROL LAMP. LAMP FLASHING? FLASHING TO BE
MODULE.INTERUPTED.*
NO
REFER TO GENERAL
INFORMATION 3.3.2 YES
FOR ADDITIONAL TEST COMPLETED.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 5
ProCarManuals.com

TEST TC-27ACONTINUED - REPAIRING - DIAGNOSTIC LAMP SHORT CIRCUIT
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 6
ProCarManuals.com

TEST TC-27ACONTINUED - REPAIRING - DIAGNOSTIC LAMP SHORT CIRCUIT
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-27A
CONTINUED FROM
THE PREVIOUS TURN IGNITION OFF.
PAGE.
DISCONNECT THE
MESSAGE CENTER
HARNESS TURN IGNITION ON.
CONNECTOR.**
USING A VOLTMETER, AT THE MESSAGE REPAIR DIAG/GLOW
MEASURE THE CENTER HARNESS IS THE VOLTAGE YES PLUG LAMP CIRCUIT
DIAG/GLOW LAMP CONNECTOR. ABOVE 1.0 VOLT? FOR A SHORT TO
CONTROL CKT... VOLTAGE.*
FIG. 1
NO
DOES THE DRB
CLEAR FAULT CODES. TURN IGNITION ON. DISPLAY YES REPLACE THE ENGINE
TURN IGNITION OFF READ DRB FAULT "DIAGNOSTIC LAMP CONTROL MODULE.*
FOR 30 SECONDS. CODES. SHORT CIRCUIT"?
NO
CHECK FOR SHORTED
DIAG/GLOW PLUG
LAMP. IF OK,
REPLACE THE
MESSAGE CENTER.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 7
ProCarManuals.com

TEST TC-30AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO EARLY
Perform TEST DTC Before ProceedingT
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 8
ProCarManuals.com

TEST TC-30AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO EARLY
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TURN IGNITION ON.
START TEST ARE THERE OTHER YES DIAGNOSE OTHER
TC-30A. USING THE DRB, TROUBLE CODES SET. CODES BEFORE
CHECK FOR CONTINUING.
ADDITIONAL CODES.
NO
USING THE DRB,
ERASE CODES.
PERFORM SEVERAL TURN IGNITION ON.
IGNITION KEY CYCLES DOES THIS CODE YES CONTINUE TEST
PAUSING AT LEAST 10 USING THE DRB, APPEAR? TC-30A ON THE
SECONDS BETWEEN EACH READ CODES. NEXT PAGE.
CYCLE.
NO
AT THIS TIME THE USING THE
CONDITION TO SET SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
THE TROUBLE CODE GUIDE, INSPECT THE FOUND? NECESSARY.*
IS NOT PRESENT. WIRING AND
FIG.1 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 9
ProCarManuals.com

TEST TC-30ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TO EARLY
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
120
ProCarManuals.com

TEST TC-30ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TO EARLY
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-30A KEY OFF.
CONTINUED FROM SUBSTITUTE THE
THE PREVIOUS DIESEL POWER RELAY
PAGE. WITH A KNOWN GOOD
RELAY.
PERFORM SEVERAL TURN IGNITION ON.
KEY CYCLES PAUSING DOES THIS CODE NO REPLACE THE
FOR AT LEAST 10 USING THE DRB, APPEAR? INITIAL DIESEL
SECONDS BETWEEN READ CODES. POWER RELAY.*
EACH CYCLE.
YES
KEY OFF.
DISCONNECT THE ECM
REMOVE THE DIESEL HARNESS
POWER RELAY.** CONNECTORS.**
FIG.1
USING AN OHMMETER, WIGGLING THE WAS THE RESISTANCE REPAIR THE
MEASURE RESISTANCE WIRING AND ABOVE 5.0 OHMS AT YES INTERMITTENT OPEN
OF THE DIESEL POWER CONNECTORS BETWEEN ANY TIME WHILE IN THE DIESEL
RELAY CONTROL CKT THE ECM AND PDC. WIGGLING? POWER RELAY
WHILE... FIG.1 CONTROL CIRCUIT.*
NO
REINSTALL THE DIESEL
POWER RELAY.
RECONNECT THE ECM
HARNESS CONNECTORS.
PERFORM SEVERAL TURN IGNITION ON.
KEY CYCLES PAUSING DOES THIS CODE YES REPLACE THE ENGINE
FOR AT LEAST 10 USING THE DRB, APPEAR? CONTROL MODULE.*
SECONDS BETWEEN READ CODES.
EACH CYCLE.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
121
ProCarManuals.com

TEST TC-31AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
Perform TEST DTC Before Proceeding
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
122
ProCarManuals.com

TEST TC-31AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TURN IGNITION ON.
START TEST ARE THERE OTHER YES DIAGNOSE OTHER
TC-31A. USING THE DRB, TROUBLE CODES SET. CODES BEFORE
CHECK FOR CONTINUING.
ADDITIONAL CODES.
NO
USING THE DRB,
ERASE CODES.
PERFORM SEVERAL TURN IGNITION ON.
IGNITION KEY CYCLES DOES THIS CODE YES CONTINUE TEST
PAUSING AT LEAST 10 USING THE DRB, APPEAR? TC-31A ON THE
SECONDS BETWEEN EACH READ CODES. NEXT PAGE.
CYCLE.
NO
AT THIS TIME THE USING THE
CONDITION TO SET SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
THE TROUBLE CODE GUIDE, INSPECT THE FOUND? NECESSARY.*
IS NOT PRESENT. WIRING AND
FIG.1 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
123
ProCarManuals.com

TEST TC-31ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
124
ProCarManuals.com