sensor CHRYSLER CARAVAN 2000 Workshop Manual

TEST TC-16ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SIGNAL LOW
EXCEEDED
FIG.1
FIG.2
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
72
ProCarManuals.com

TEST TC-16ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SIGNAL LOW
EXCEEDED
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-16A KEY OFF.
CONTINUED FROM DISCONNECT THE
THE PREVIOUS BOOST PRESSURE
PAGE. SENSOR HARNESS
CONNECTOR.**
USING A VOLTMETER, REPAIR THE 5-VOLT
MEASURE THE 5-VOLT IS THE VOLTAGE NO SUPPLY CIRCUIT FOR
TURN IGNITION ON. SUPPLY CIRCUIT. ABOVE 4.9 VOLTS? AN OPEN OR SHORT
TO GROUND.*
FIG.1
YES
CONNECT A JUMPER READ THE BOOST IS THE BOOST
BETWEEN THE BOOST PRESSURE SENSOR PRESSURE SENSOR YES REPLACE THE BOOST
PRESSURE SENSOR VOLTAGE ON THE VOLTAGE ABOVE 4.5 PRESSURE SENSOR.*
SIGNAL CKT. AND THE DRB. VOLTS?
5-VOLT CKT. FIG.1
NO
TURN IGNITION OFF. USING AN OHMMETER, REPAIR THE BOOST
DISCONNECT THE ECM MEASURE THE BOOST IS THE RESISTANCE YES PRESSURE SENSOR
HARNESS PRESSURE SENSOR BELOW 5.0 OHMS? SIGNAL CIRCUIT FOR
CONNECTORS.** SIGNAL CKT TO GND. A SHORT TO
FIG.1 GROUND.*
NO
USE AN OHMMETER IN SENSOR SIGNAL REPAIR THE SENSOR
THE FOLLOWING STEP. CIRCUIT AND THE IS THE RESISTANCE YES SIGNAL CIRCUIT
TEST THE RESISTANCE SENSOR GROUND BELOW 5.0 OHMS? SHORTED TO THE
BETWEEN THE BOOST CIRCUIT. SENSOR GROUND
PRESSURE... FIG.1 CIRCUIT.*
NO
USING AN OHMMETER,
MEASURE THE BOOST IS THE RESISTANCE YES REPLACE THE ENGINE
PRESSURE SENSOR BELOW 5.0 OHMS? CONTROL MODULE.*
SIGNAL CIRCUIT.
FIG.2
NO
REPAIR THE OPEN
BOOST PRESSURE
SENSOR SIGNAL
CIRCUIT.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
73
ProCarManuals.com

TEST TC-17AREPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY HIGH EXCEEDED
Perform TEST DTC Before Proceeding
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
74
ProCarManuals.com

TEST TC-17AREPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY HIGH EXCEEDED
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
WITH THE DRB, DOES THE DRB
START TEST ERASE CODES. CYCLE DISPLAY "BOOST YES CONTINUE TEST
TC-17A. THE IGNITION OFF PRESSURE SENSOR TC-17A ON THE
THEN ON. SUPPLY HIGH NEXT PAGE.
EXCEEDED"?
NO
WIGGLE THE BOOST DOES THE DRB REPAIR THE
PRESSURE SENSOR MONITOR THE DRB DISPLAY "BOOST YES CONNECTOR OR
CONNECTOR AND DISPLAY. PRESSURE SENSOR HARNESS WIRES THAT
HARNESS WIRES. SUPPLY HIGH CAUSED THE CODE TO
EXCEEDED"? SET.*
NO
AT THIS TIME THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THIS CODE GUIDE, INSPECT THE FOUND? NECESSARY.*
IS NOT PRESENT. WIRING AND
CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES. FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
75
ProCarManuals.com

TEST TC-17ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY HIGH
EXCEEDED
FIG.1
FIG.2
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
76
ProCarManuals.com

TEST TC-17ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY HIGH
EXCEEDED
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-17A TURN IGNITION OFF.
CONTINUED FROM DISCONNECT THE
THE PREVIOUS BOOST PRESSURE
PAGE. SENSOR HARNESS
CONNECTOR.**
DISCONNECT THE ECM REMOVE THE DIESEL
HARNESS POWER RELAY.**
CONNECTORS.**
WITH A JUMPER WIRE, TURN IGNITION ON.
CONNECT DIESEL POWER
RELAY CONN. CAVITIES USE A VOLTMETER IN
30 AND 87 (IN PDC). THE FOLLOWING
FIG.1 STEP.
MEASURE THE BOOST REPAIR THE BOOST
PRESSURE SENSOR IS THE VOLTAGE YES PRESSURE SENSOR
5-VOLT SUPPLY ABOVE 1.0 VOLT? SUPPLY CIRCUIT FOR
CIRCUIT. A SHORT TO
FIG.2 VOLTAGE.*
NO
REPLACE THE ENGINE
CONTROL MODULE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
77
ProCarManuals.com

TEST TC-18AREPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY LOW EXCEEDED
Perform TEST DTC Before Proceeding
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
78
ProCarManuals.com

TEST TC-18AREPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY LOW EXCEEDED
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
WITH THE DRB, DOES THE DRB
START TEST ERASE CODES. CYCLE DISPLAY "BOOST YES CONTINUE TEST
TC-18A. THE IGNITION OFF PRESSURE SENSOR TC-18A ON THE
THEN ON. SUPPLY LOW NEXT PAGE.
EXCEEDED"?
NO
WIGGLE THE BOOST DOES THE DRB REPAIR THE
PRESSURE SENSOR MONITOR THE DRB DISPLAY "BOOST YES CONNECTOR OR
CONNECTOR AND DISPLAY. PRESSURE SENSOR HARNESS WIRES THAT
HARNESS WIRES. SUPPLY LOW CAUSED THE CODE TO
EXCEEDED"? SET.*
NO
AT THIS TIME THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THIS CODE GUIDE, INSPECT THE FOUND? NECESSARY.*
IS NOT PRESENT. WIRING AND
CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES. FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
79
ProCarManuals.com

TEST TC-18ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY LOW
EXCEEDED
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
80
ProCarManuals.com

TEST TC-18ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY LOW
EXCEEDED
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
USING A VOLTMETER,
MEASURE THE 5-VOLT
SUPPLY CIRCUIT.
FIG. 1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
81
ProCarManuals.com