display CHRYSLER CARAVAN 2000 Repair Manual

TEST TC-80ACONTINUED - REPAIRING - SOLENOID VALVE CONTROLLER SHORT CIRCUIT
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
KEY OFF. KEY ON. ERASE CODES.
TEST TC-80A DISCONNECT THE DOES THE DRB DISPLAY YES REPLACE THE FUEL
CONTINUED FROM FUEL PUMP ASSEMBLY "FUEL TIMING PUMP ASSEMBLY.*
PREVIOUS PAGE. CONNECTOR.** SOLENOID CONTROLLER
OPEN CIRCUIT"?
NO
KEY OFF.
DISCONNECT THE ECM REMOVE THE DIESEL
HARNESS POWER RELAY.
CONNECTORS.**
WITH A JUMPER WIRE, KEY ON. USING A REPAIR THE FUEL
CONNECT DIESEL POWER VOLTMETER MEASURE IS THE VOLTAGE YES TIMING SOLENOID
RELAY CONN. CAVITIES THE FUEL TIMING ABOVE 1.0 VOLTS? CONTROL CIRCUIT
30 AND 87 (IN PDC). SOLENOID CONTROL FOR A SHORT TO
FIG.1 CKT. FIG.2 VOLTAGE.*
NO
NOTE: BEFORE
REPLACING THE ECM, DID THE FUEL YES REPLACE THE ENGINE
PERFORM TEST NTC-3A INJECTION PUMP CONTROL MODULE.*
TO CHECK INTERNAL PASS TEST NTC-3A?
FUEL PUMP CIRCUITRY.
NO
REPLACE THE FUEL
INJECTION PUMP
ASSEMBLY.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
249
ProCarManuals.com

TEST TC-81AREPAIRING - TEMPERATURE OF ENGINE COOLANT SRC HIGH EXCEEDED
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
WITH THE DRB, READ IS THE ENGINE
START TEST THE ENGINE COOLANT COOLANT YES CONTINUE TEST
TC-81A. TEMPERATURE SENSOR TEMPERATURE SENSOR TC-81A ON THE
VOLTAGE. VOLTAGE ABOVE 4.7 NEXT PAGE.
VOLTS?
NO
USE THE SCHEMATIC WAS THERE ANY REPAIR THE HARNESS
AS A GUIDE AND MONITOR THE DRB ENGINE COOLANT YES OR CONNECTOR THAT
WIGGLE THE ECT DISPLAY. TEMPERATURE SENSOR CAUSED THE VOLTAGE
SENSOR CONNECTOR & VOLTAGE CHANGE? CHANGE.*
HARNESS. FIG.1
NO
AT THIS TIME, THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THE CODE IS GUIDE, INSPECT THE FOUND? NECESSARY.*
NOT PRESENT. FIG.2 WIRING AND
CONNECTORS.
NO
REFER TO GENERAL
INFOMATION 3.3.2 FOR YES
ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
251
ProCarManuals.com

TEST TC-82AREPAIRING - TEMPERATURE OF ENGINE COOLANT SRC LOW EXCEEDED
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
WITH THE DRB, READ IS THE ENGINE
START TEST THE ENGINE COOLANT COOLANT YES CONTINUE TEST
TC-82A. TEMPERATURE SENSOR TEMPERATURE SENSOR TC-82A ON THE
VOLTAGE. VOLTAGE BELOW NEXT PAGE.
0.3 VOLT?
NO
USING THE SCHEMATIC, WAS THERE ANY REPAIR THE HARNESS
WIGGLE THE ENGINE MONITOR THE DRB ENGINE COOLANT YES OR CONNECTOR THAT
COOLANT TEMPERATURE DISPLAY. TEMPERATURE SENSOR CAUSED THE VOLTAGE
SENSOR CONNECTOR & VOLTAGE CHANGE? CHANGE.*
HARNESS. FIG.1
NO
AT THIS TIME, THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THE CODE IS GUIDE, INSPECT THE FOUND? NECESSARY.*
NOT PRESENT. WIRING AND
FIG.2 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2 YES
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
255
ProCarManuals.com

TEST TC-84AREPAIRING - TERMINAL 15 PLAUSIBILITY AFTER START-UP
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
START TEST WITH THE DRB,
TC-84A. ERASE CODES.
CYCLE THE IGNITION
ON AND OFF SEVERAL WITH THE IGNITION DOES THE DRB YES CONTINUE TEST
TIMES, PAUSING FOR ON ENGINE OFF, DISPLAY "TERMINAL TC-84A ON THE
TEN SECONDS AT KEY READ CODES. 15 PLAUSIBILITY"? NEXT PAGE.
ON AND OFF.
NO
AT THIS TIME THE REVIEW THE CIRCUIT
CONDITION FOR DESCRIPTION FOR A WERE ANY PROBLEMS YES REPAIR AS
SETTING THE CODE PROPER UNDERSTANDING FOUND? NECESSARY.*
IS NOT PRESENT. OF THIS CODE. CHECK
FIG. 1 FOR PROBLEMS.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
259
ProCarManuals.com

TEST TC-85ACONTINUED - REPAIRING - TIMING GOVERNING NEGATIVE GOVERNOR DEVIATION
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
NOTE: THIS CODE REPAIR OTHER CODES
TEST TC-85A WILL SET DUE TO ARE ANY OTHER YES FIRST. CLEAR THIS
CONTINUED FROM NOISE ON THE CODES SET? CODE AND REPEAT
PREVIOUS PAGE. NEEDLE MOVEMENT DIAGNOSIS.*
SENSOR CIRCUIT.
NO
TEST DRIVE
REPLACE THE FUEL VEHICLE. USING THE DOES THE DRB YES REPLACE THE ENGINE
INJECTION PUMP DRB, DISPLAY DISPLAY THIS CODE? CONTROL MODULE.*
ASSEMBLY. CODES.
NO
TEST COMPLETED.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
265
ProCarManuals.com

TEST TC-86AREPAIRING - TIMING GOVERNING POSITIVE GOVERNOR DEVIATION
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
NOTE: INCORRECT HAS THE TIMING VERIFY CORRECT
START TEST INJECTION PUMP CHAIN, TIMING YES VALVE TIMING AND
TC-86A. TIMING CAN CAUSE GEARS OR INJECTION INJECTION PUMP
THIS TROUBLE CODE. PUMP BEEN SERVICED TIMING BEFORE
RECENTLY? CONTINUING.
NO
WITH THE DRB, ATTEMPT TO START READ CODES. DOES
ERASE CODES. ENGINE AND THE DRB DISPLAY YES CONTINUE TEST
INCREASE ENGINE "TIMING GOVERNING TC-86A ON THE
TURN IGNITION OFF SPEED ABOVE 1000 POSITIVE GOVERNOR NEXT PAGE.
FOR 10 SECONDS. RPM. DEVIATION"?
NO
USE THE SCHEMATIC AS DOES THE DRB REPAIR THE HARNESS
A GUIDE AND WIGGLE MONITOR THE DRB DISPLAY "TIMING YES OR CONNECTOR THAT
THE SENSOR CONNECTOR DISPLAY. GOVERNING POSITIVE CAUSED THE CODE TO
& HARNESS. GOVERNOR SET.*
FIG.1 DEVIATION"?
NO
AT THIS TIME, THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THE CODE IS GUIDE, INSPECT THE FOUND? NECESSARY.*
NOT PRESENT. WIRING AND
FIG.2 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2 YES
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
267
ProCarManuals.com

TEST TC-86ACONTINUED - REPAIRING - TIMING GOVERNING POSITIVE GOVERNOR DEVIATION
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
NOTE: THIS CODE
TEST TC-86A WILL SET DUE TO
CONTINUED FROM LOW FUEL VOLUME TO
PREVIOUS PAGE. THE INJECTION
PUMP.
CHECK THE FUEL WERE ANY PROBLEMS YES REPAIR AS
SYSTEM FOR FOUND? NECESSARY.*
RESTRICTIONS.
NO
TEST DRIVE THE
REPLACE THE FUEL VEHICLE. USING THE DOES THE DRB NO
INJECTION PUMP DRB, DISPLAY DISPLAY THIS CODE? TEST COMPLETED.*
ASSEMBLY.* CODES.
YES
NOTE: BEFORE
REPLACING THE ECM, DID THE FUEL YES REPLACE THE ENGINE
PERFORM TEST NTC-3A INJECTION PUMP CONTROL MODULE.*
TO CHECK INTERNAL PASS TEST NTC-3A?
FUEL PUMP CIRCUITRY.
NO
REPLACE THE FUEL
INJECTION PUMP
ASSEMBLY.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
269
ProCarManuals.com

TEST TC-91AREPAIRING - VEHICLE SPEED SENSOR TROUBLE CODES
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
START TEST USING THE DRB,
TC-91A ERASE CODES.
TEST DRIVE THE WITH THE DRB, READ DOES THE DRB YES CONTINUE TEST
VEHICLE. TROUBLE CODES. DISPLAY A VEHICLE TC-91A ON THE
SPEED SENSOR CODE? NEXT PAGE.
NO
TURN IGNITION OFF. INSPECT THE VSS
HARNESS CONNECTOR IS THERE EVIDENCE YES REPAIR OR REPLACE
DISCONNECT THE VSS TERMINALS.** OF TERMINAL DAMAGE TERMINALS AS
HARNESS OR CORROSION? NECESSARY.*
CONNECTOR.** FIG.1
NO
CHECK THE VSS THIS INTERFERENCE
HARNESS FOR COULD BE CAUSED BY IS THE VSS WIRING NO REPAIR AS
MIS-ROUTING THAT HIGH CURRENT ROUTED CORRECTLY? NECESSARY.*
COULD INDUCE CARRYING WIRES OR
INTERFERENCE. THE ALTERNATOR.
YES
AT THIS TIME, THE USING THE SCHEMATIC
CONDITION REQUIRED AS A GUIDE, WERE ANY PROBLEMS YES REPAIR AS
TO SET THE CODE IS INSPECTOR THE WIRING FOUND? NECESSARY.*
NOT PRESENT. AND CONNECTORS.
FIG.2
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
271
ProCarManuals.com

TEST TC-91BREPAIRING - VEHICLE SPEED SENSOR TROUBLE CODES
Perform TEST TC-91A Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
USING THE DRB
START TEST RECONNECT THE VSS RAISE AND SUPPORT OSCILLOSCOPE
TC-91B. AND ECM HARNESS THE VEHICLE DRIVE FUNCTION SELECT
CONNECTORS. AXLE. "LAB SCOPE".
SET VOLTAGE RANGE USING THE
TO +10.0v. SET TIME RANGE TO OSCILLOSCOPE LEAD,
SET PROBE TO x10. 40ms/Div. BACKPROBE ECM
HARNESS CONNECTOR
FIG.1 FIG.2 CAVITY 51. FIG.3
START THE ENGINE. SHIFT TRANSMISSION
INTO FIRST GEAR
ENGAGE THE PARKING AND ALLOW THE
BRAKE. WHEELS TO ROTATE
AT IDLE SPEED.
NOTE: A VALID VSS DOES THE DRB
OBSERVE THE DRB SIGNAL WILL CYCLE DISPLAY THE 5.0 NO REPLACE THE
OSCILLOSCOPE HI TO LOW SIMILAR VOLT VSS SIGNAL VEHICLE SPEED
PATTERN. TO THE PATTERN CYCLING HI AND SENSOR.*
SHOWN IN FIGURE 2. LOW?
YES
REPLACE THE ENGINE
CONTROL MODULE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
279
ProCarManuals.com

TEST TC-94AREPAIRING - VEHICLE THEFT ALARM TROUBLE CODES
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
CHECK SKIS MODULE
START TEST FOR PROPER ARE THERE ANY SKIS YES PERFORM TEST
TC-94A. COMMUNICATION AND PROBLEMS? SK-1A.
TROUBLE CODES
BEFORE CONTINUING.
NO
USING THE DRB,
SELECT "ENGINE"
FROM THE MAIN
MENU.
DISPLAY THE DOES THE REPLACE THE ENGINE
VEHICLE COMPARE THE PROGRAMMED VIN NO CONTROL MODULE AND
IDENTIFICATION PROGRAMMED VIN TO MATCH THE VEHICLE PROGRAM THE
NUMBER (VIN). THE VEHICLE VIN. VIN? CORRECT VIN INTO
THE ECM.*
YES
USING THE DRB,
SELECT "BODY" THEN
"BODY COMPUTER".
DISPLAY THE DOES THE REPLACE THE BODY
VEHICLE COMPARE THE PROGRAMMED VIN NO CONTROL MODULE AND
IDENTIFICATION PROGRAMMED VIN TO MATCH THE VEHICLE PROGRAM THE
NUMBER (VIN). THE VEHICLE VIN. VIN? CORRECT VIN INTO
THE BCM.*
YES
CONTINUE TEST
TC-94A ON THE
NEXT PAGE.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
281
ProCarManuals.com