key battery CHRYSLER PT CRUISER 2005 1.G Owners Manual

Remote Keyless Entry.....................21
▫To Unlock The Doors...................21
▫To Lock The Doors.....................22
▫Horn Chirp Feature.....................22
▫Using The Panic Alarm..................22
▫To Program Transmitters.................23
▫General Information....................23
▫Transmitter Battery Service...............24

Security Alarm System....................25
▫To Set The Alarm......................25
▫To Disarm The System...................26
▫Security System Manual Override...........26

Deck Lid..............................26▫Power Deck Lid Release.................27

Emergency Deck Lid Release Latch...........28

Power Windows........................28
▫Auto Down Feature....................29
▫Wind Buffeting........................30

Occupant Restraints......................30
▫Lap/Shoulder Belts.....................31
▫Lap/Shoulder Belt Untwisting Procedure.....37
▫Seat Belt Pretensioners...................39
▫Seat Belts And Pregnant Women............39
▫Driver And Front Passenger Supplemental
Restraint System (SRS) - Airbag............40
▫Child Restraint........................49
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

2. This device must accept any interference that may be
received including interference that may cause undesired
operation.
NOTE:Changes or modifications not expressly ap-
proved by the party responsible for compliance could
void the user’s authority to operate the equipment.
HomeLinkis a trademark owned by Johnson Controls,
Inc.
ELECTRICAL POWER OUTLETS
These three outlets include tethered caps, labeled with a
key symbol or battery symbol, indicating power source.
All outlets are protected by a single 20 Amp fuse.
The outlet that is located in the front of the center floor
console is a conventional cigar lighter outlet.It will accept a cigar lighter unit, which is part of the
optional Smokers Package. To preserve the heating ele-
ment of the cigar lighter unit, do not hold the lighter in
the heating position. As a child safety precaution, this
outlet is powered by the ignition switch, only when the
switch is in theONorACCESSORYpositions.
Power Outlet
112 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

started within 3 seconds, slightly depress the accelerator
pedal while continuing to crank. If the engine fails to start
within 15 seconds, turn the ignition switch to the“OFF”
position, wait 10 to 15 seconds, then repeat the normal
starting procedure.
WARNING!
Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
axle cannot be started this way. Unburned fuel could
enter the catalytic converter and once the engine has
started, ignite and damage the converter and vehicle.
If the vehicle has a discharged battery, booster cables
may be used to obtain a start from another vehicle.
This type of start can be dangerous if done improp-
erly, so follow the procedure carefully. See section 6
of this manual for jump starting instructions.
Extremely Cold Weather (below
20°For
29°C)
To insure reliable starting at these temperatures, use of an
externally powered electric engine block heater (available
from your dealer) is recommended.
If Engine Fails to Start
If the engine fails to start after you have followed the
“NORMAL STARTING”procedure, it may be flooded.
Push the accelerator pedal all the way to the floor and
hold it there. Crank the engine for no more than 15
seconds. This should clear any excess fuel in case the
engine is flooded. Leave the ignition key in the ON
position, release the accelerator pedal and repeat the
“NORMAL STARTING”procedure.
STARTING AND OPERATING 183
5

WHAT TO DO IN EMERGENCIES
CONTENTS

Hazard Warning Flasher..................232

If Your Engine Overheats.................233

Jacking And Tire Changing................235
▫Jack Location........................235
▫Spare Tire Stowage....................236
▫Preparations For Jacking................237
▫Jacking Instructions....................238

Jump-Starting Procedures Due To A Low
Battery..............................240
Driving On Slippery Surfaces..............243
▫Acceleration.........................243
▫Traction............................243

Freeing A Stuck Vehicle..................244

Towing A Disabled Vehicle................245
▫With Ignition Key.....................245
▫Without The Ignition Key...............246

Convertible Top Manual Override...........247
6

HAZARD WARNING FLASHER
The flasher switch is on top of the steering column,
just behind the steering wheel. Depress the switch
and both cluster indicators and all front and rear direc-
tional signals will flash. Depress the switch again to turn
Hazard Warning Flashers off.Do not use this emergency warning system when the
vehicle is in motion. Use it when your vehicle is disabled
and is creating a safety hazard for other motorists.
If it is necessary to leave the vehicle to go for service, the
flasher system will continue to operate with the ignition
key removed and the vehicle locked.
NOTE:With extended use, the flasher may wear down
your battery.
Hazard Flasher Switch
232 WHAT TO DO IN EMERGENCIES

EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
MAINTAINING YOUR VEHICLE 255
7

a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
ignition key or start the engine. This means that your
vehicle’s OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle’s OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle’s OBD system is
ready or not ready, if the MIL symbol is illuminatedduring normal vehicle operation, you should have your
vehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.
REPLACEMENT PARTS
Use of genuine Moparparts for normal/scheduled
maintenance and repairs is highly recommended to in-
sure the designed performance. Damage or failures
caused by the use of non-Moparparts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
DEALER SERVICE
Your dealer has the qualified service personnel, special
tools and equipment to perform all service operations in
an expert manner. Service Manuals are available which
include detailed service information for your vehicle.
Refer to these manuals before attempting any procedure
yourself.
256 MAINTAINING YOUR VEHICLE

Back-Up Lights......................... 301
Ball Joints............................. 268
Battery............................... 265
Keyless Transmitter Replacement............ 24
Belts, Drive............................ 261
Belts, Engine........................... 264
Body Mechanism Lubrication............... 269
Boot, Convertible Top...................68,72
B-Pillar Location........................ 206
Brake Fluid............................ 304
Brake, Parking.......................... 195
Brake System........................197,278
Anti-Lock........................... 198
Hoses.............................. 278
Master Cylinder....................... 279
Parking............................. 195
Warning Light........................ 130
Brakes.............................197,278
Brake/Transmission Interlock............... 186Break-In Recommendations, New Vehicle........ 56
Bulb Replacement.....................297,299
Bulbs, Light............................ 297
Calibration, Compass...................... 78
Capacities, Antifreeze (Engine Coolant)........ 302
Capacities, Fluid........................ 302
Caps, Filler
Fuel................................ 225
Oil (Engine)....................252,253,260
Radiator (Coolant Pressure)............... 275
Carbon Monoxide Warning................. 224
Cassette Tape and Player Maintenance......... 167
Cassette Tape Player................136,146,149
Catalytic Converter...................... 262
Caution, Exhaust Gas...................... 57
CD Changer......................145,151,157
CD Player..................142,153,155,159,162
CD Player Maintenance................... 168
INDEX 341
10

Quality Grading....................... 337
Radial.............................. 214
Replacement......................... 217
Rotation............................. 220
Safety...........................201,210
Sizes............................... 203
Snow Tires........................... 219
Spare Tire........................... 236
Spinning............................ 216
Tread Wear Indicators................... 216
Top Cover.............................. 68
Towing
Disabled Vehicle....................... 245
Traction.............................. 243
Traction Control................102,131,132,200
Traction Control Switch.................102,200
Trailer Towing.......................... 227
Minimum Requirements................. 228
Trailer and Tongue Weight................ 228Warnings............................ 227
Transaxle............................. 185
Automatic....................12,182,185,280
Autostick............................ 190
Manual........................13,182,191
Operation........................... 185
Overdrive........................... 189
Selection of Lubricant................... 280
Transmitter Battery Service.................. 24
Transmitter, Garage Door Opener............ 106
Transmitter Programming................... 23
Transmitter, Remote Keyless Entry............ 21
Transporting Pets........................ 56
Tread Wear Indicators.................... 216
Trip Odometer Reset Button.............131,134
Trunk Lid (Deck Lid)...................... 26
Turbo Cool Down....................... 184
Turn Signals.........................97,128
INDEX 353
10