lock CHRYSLER PT CRUISER 2008 1.G Manual Online

Press and release the SCAN button (if equipped) to
automatically change channels every 7 seconds. The
radio will pause on each channel for 7 seconds before
moving on to the next channel. The wordSCANwill
appear in the display between each channel change. Press
the SCAN button a second time to stop the search.
NOTE: Channels that may contain objectionable content
can be blocked. Contact Sirius Customer Care at 888-539-
7474 to discuss options for channel blocking or unblock-
ing. Please have your ESN/SID information available.Storing and Selecting Pre-Set ChannelsIn addition to the 12 AM and 12 FM pre-set stations, you
may also commit 12 satellite stations to push button
memory. These satellite channel pre-set stations will not
erase any AM or FM pre-set memory stations. Follow the
memory pre-set procedures that apply to your radio.
Using the PTY (Program Type) Button (if
equipped)Follow the PTY button instructions that apply to your
radio.PTY Button SCAN When the desired program type is obtained, press the
SCANbutton within five seconds. The radio will play 7
seconds of the selected channel before moving to the next
channel of the selected program type. Press the SCAN
button a second time to stop the search.
NOTE: Pressing the SEEKorSCAN button while
performing a music type scan will change the channel by
one and stop the search. Pressing a pre-set memory
button during a music type scan, will call up the memory
channel and stop the search.
UNDERSTANDING YOUR INSTRUMENT PANEL 275
4

PTY Button SEEK When the desired program is obtained, press the SEEK
button within five seconds. The channel will change to
the next channel that matches the program type selected.Satellite AntennaTo ensure optimum reception, do not place items on the
roof around the rooftop antenna location. Metal objects
placed within the line of sight of the antenna will cause
decreased performance. Larger luggage items should be
placed as far forward as possible. Do not place items
directly on or above the antenna. The luggage rack (if
equipped), should also not be positioned directly above
the antenna.
Reception QualitySatellite reception may be interrupted due to one of the
following reasons.•
The vehicle is parked in an underground parking
structure or under a physical obstacle.
•
Dense tree coverage may interrupt reception in the
form of short audio mutes.
•
Driving under wide bridges or along tall buildings can
cause intermittent reception.
•
Placing objects over or too close to the antenna can
cause signal blockage.
276 UNDERSTANDING YOUR INSTRUMENT PANEL

NOTE:•
Recirculation Mode will not operate in floor, mix or
defrost modes.
•
See “Circulation Control” in this section, for proper or
extended use of this position.
Circulation Control
Rotate this control to choose be-
tween outside air intake or recir-
culation of the air inside the ve-
hicle. A lamp will illuminate when
you are in recirculate mode. Only
use the recirculate mode to tem-
porarily block out any outside
odors, smoke, or dust and to cool
the interior rapidly upon initial
start up in very hot or humid weather. NOTE:
Continuous use of the recirculate mode may
make the inside air stuffy and window fogging may
occur. Extended use of this mode is not recommended.
In cold or damp weather, the use of the Recirculate
position will cause windows to fog on the inside because
of moisture build up inside the vehicle. For defogging,
select the Outside Air position.
NOTE: Recirculation Mode will not operate in floor, mix
or defrost modes.
282 UNDERSTANDING YOUR INSTRUMENT PANEL

STARTING AND OPERATING
CONTENTSStarting Procedures .....................291
▫ Automatic Transaxle ...................291
▫ Manual Transaxle .....................292
▫ Normal Starting ......................292
▫ Extremely Cold Weather (Below 20°F Or
29°C) .............................292
▫ If The Engine Fails To Start ..............293
▫ After Starting ........................293
▫ Turbocharger Cool-Down...............293 
Automatic Transaxle — If Equipped .........294
▫ Brake/Transmission Interlock System .......295
▫ Automatic Transaxle Ignition Interlock
System .............................295
▫ Four-Speed Automatic Transaxle ...........296
▫ Reset Mode .........................296
▫ Gear Ranges For The Four-Speed Automatic
Transaxle ...........................297
5

AutoStick — If Equipped .................299
▫ AutoStick Operation ...................300
▫ AutoStick General Information ............300
 Manual Transaxle Operation — If Equipped ....301
▫ 2.4 Liter Turbo — If Equipped ............303
▫ Manual Transaxle — Recommended Shift
Speeds .............................304
▫ Downshifting ........................304
 Parking Brake .........................305
 Brake System ..........................307
▫ Anti-Lock Brake System (ABS) —
If Equipped .........................308
 Power Steering ........................310
 Traction Control System — If Equipped .......311
Tire Safety Information ...................313
▫ Tire Markings ........................313
▫ Tire Identification Number (TIN) ..........316
▫ Tire Loading And Tire Pressure ...........317
 Tires — General Information ...............321
▫ Tire Pressure .........................321
▫ Tire Inflation Pressures .................322
▫ Radial Ply Tires ......................324
▫ Compact Spare Tire — If Equipped .........325
▫ Limited-Use Spare — If Equipped .........325
▫ Tire Spinning ........................326
▫ Tread Wear Indicators ..................327
▫ Life Of Tire .........................327288 STARTING AND OPERATING

MANUAL TRANSAXLEBefore starting the engine fully apply the parking brake,
press the clutch pedal to the floor and shift the gear
selector lever in NEUTRAL.
NOTE:The engine will not start unless the clutch pedal
is pressed to the floor.NORMAL STARTINGNormal starting of either a cold or a warm engine does
not require pumping or depressing the accelerator pedal.
Simply turn the ignition switch to the START position
and release when the engine starts. If the engine has not
started within three seconds, slightly depress the accel-
erator pedal while continuing to crank. If the engine fails
to start within 15 seconds, turn the ignition switch to the
OFF position, wait 10 to 15 seconds, then repeat the
“NORMAL STARTING” procedure above.
WARNING!
Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
axle cannot be started this way. Unburned fuel could
enter the catalytic converter and once the engine has
started, ignite and damage the converter and vehicle.
If the vehicle has a discharged battery, booster cables
may be used to obtain a start from another vehicle.
This type of start can be dangerous if done improp-
erly, so follow the procedure carefully. See Section 6
of this manual for jump starting instructions.EXTREMELY COLD WEATHER (BELOW 20°F or
29°C)To insure reliable starting at these temperatures, use of an
externally powered electric engine block heater (available
from your authorized dealer) is recommended.
292 STARTING AND OPERATING

WARNING!
It is dangerous to shift the gear selector lever out of
PARK, or NEUTRAL if the engine speed is higher
than idle speed. If your foot is not firmly on the
brake pedal, the vehicle could accelerate quickly
forward or in REVERSE. You could lose control of the
vehicle and hit someone or something. Only shift the
gear selector lever into gear when the engine is idling
normally and when your right foot is firmly on the
brake pedal.BRAKE/TRANSMISSION INTERLOCK SYSTEMThis system prevents you from shifting the gear selector
lever out of PARK and into any gear unless the brake
pedal is pressed. This system is active only while the
ignition switch is in the ON or ACC positions.Alwaysstep on the brake pedal and depress the gear selector
lever knob button before shifting out of PARK.
NOTE:
If a malfunction occurs, the system will function
normally, except you may be able to shift the vehicle from
PARK, without depressing the brake pedal. If this occurs
obtain service from an authorized dealer as soon as
possible.
AUTOMATIC TRANSAXLE IGNITION INTERLOCK
SYSTEMThis system prevents the key from being removed unless
the gear selector lever is in PARK and the gear selector
lever knob push button is out. It also prevents shifting
out of PARK unless the key is in the ACC or ON
positions, and the brake pedal is depressed.
NOTE: If a malfunction occurs, the system will trap the
key in the ignition cylinder to warn you that this safety
STARTING AND OPERATING 295
5

GEAR RANGES FOR THE FOUR-SPEED
AUTOMATIC TRANSAXLEDO NOT race the engine when shifting from PARK or
NEUTRAL positions into another gear range.PARKPARK supplements the parking brake by locking the
transmission. The engine can be started in this range.
Never use PARK while the vehicle is in motion. Apply
the parking brake when leaving the vehicle in this range.
Always apply the parking brake first, and then shift the
gear selector lever into the PARK position.
WARNING!
Unintended movement of a vehicle could injure
those in and near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running. Before exiting a vehicle, you should always
shift the vehicle into PARK, remove the key from the
ignition, and apply the parking brake. Once the key
is removed from the ignition, the transmission gear
selector lever is locked in the PARK position, secur-
ing the vehicle against unwanted movement. Further-
more, you should never leave children unattended
inside a vehicle.
STARTING AND OPERATING 297
5

The following indicators should be used to ensure that
you have engaged the transmission gear selector lever
into the PARK position:•
When shifting the gear selector lever into PARK,
depress the button on the gear selector lever knob and
firmly move the lever all the way forward until it
stops.
•
Look at the shift indicator window on the console to
ensure it is in the PARK position.
•
When engaged in PARK, you will not be able to move
the gear selector lever rearward without depressing
the gear selector lever knob button
CAUTION!
Before shifting the gear selector lever out of PARK,
you must turn the ignition from LOCK to ON so the
steering wheel and gear selector lever are released.
Otherwise, damage to the steering column or gear
selector lever could result.REVERSEShift into this range only after the vehicle has come to a
complete stop.NEUTRALThe engine may be started in this range.DRIVE / OVERDRIVEThis range should be used for most city and highway
driving. It provides smoothest upshifts and downshifts,
and best fuel economy.
298 STARTING AND OPERATING

NOTE:The parking brake lever will not release unless
the lever is pulled up slightly past its applied position.
When parking on a hill, it is important to set the parking
brake before placing the gear selector lever in PARK,
otherwise the load on the automatic transaxle locking
mechanism may make it difficult to move the gear selector lever out of PARK. As an added precaution, turn
the front wheels toward the curb on a downhill grade
and away from the curb on a uphill grade.
You should always apply the parking brake before leav-
ing the vehicle.
WARNING!
•
Never leave children alone in a vehicle. Leaving
children in a vehicle unattended is dangerous for a
number of reasons. A child or others could be
seriously or fatally injured. Don’t leave the keys in
the ignition. A child could operate power win-
dows, other controls, or move the vehicle.
•
Be sure the parking brake is fully disengaged
before driving; failure to do so can lead to brake
failure and an accident.
Parking Brake Lever
306 STARTING AND OPERATING