CHRYSLER SEBRING SEDAN 2007 3.G Repair Manual
Manufacturer: CHRYSLER, Model Year: 2007, Model line: SEBRING SEDAN, Model: CHRYSLER SEBRING SEDAN 2007 3.GPages: 376
Page 61 of 376
1 — Cover
3 — Attaching Strap
A — Tether Strap and Hook
B — Tether Anchor
2. Route the tether strap to provide the most direct path
for the strap between the anchor and the child seat. If
your vehicle is equipped with adjustable rear head
restraints, raise the head restraint, and where possible,
route the tether strap under the head restraint andbetween the two posts. If not possible, lower the head
restraint and pass the tether strap around the outboard
side of the head restraint.
3. Attach the tether strap hook (A) of the child restraint
to the anchor (B) and remove slack in the tether strap
according to the child restraint manufacturer’s instruc-
tions.
WARNING!
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchor positions directly behind
the child seat to secure a child restraint top tether
strap.
Installing Child Restraints Using the Vehicle Seat
belt
The passenger seat belts are equipped with either cinch-
ing latch plates or automatic locking retractors, which are
designed to keep the lap portion tight around the child
restraint so that it is not necessary to use a locking clip.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 61
2
Page 62 of 376
Pulling up on the shoulder portion of the lap/shoulder
belt will tighten the belt. The cinching latch plate will
keep the belt tight; however, any seat belt system will
loosen with time, so check the belt occasionally, and pull
it tight if necessary.
Seat belts with an automatic locking retractor have a
distinctive label on the seat belt webbing. The seat belt
must be in the automatic locking mode in order to enable
a child restraint to be tightly installed. Refer to “Auto-
matic Locking Mode” in this section for details. A locking
clip should not be necessary once the automatic locking
feature is enabled. Position the shoulder and lap belt on
the child restraint. The automatic locking retractor is
activated by first attaching the child seat, then pulling all
of the webbing out of the retractor, then allowing back in.
Tighten webbing. To release, simply unbuckle the seat
belt by depressing the button, allowing the webbing to
retract into the retractor.In the rear seat, you may have trouble tightening the
lap/shoulder belt on the child restraint because the
buckle or latch plate is too close to the belt path opening
on the restraint. Disconnect the latch plate from the
buckle and twist the short buckle-end belt several times
to shorten it. Insert the latch plate into the buckle with the
release button facing out.
If the belt still can’t be tightened, or if by pulling and
pushing on the restraint loosens the belt, you may need
to do something more. Disconnect the latch plate from
the buckle, turn the buckle around, and insert the latch
plate into the buckle again. If you still can’t make the
child restraint secure, try a different seating position.
Children Too Large For Booster Seats
Children who are large enough to wear the shoulder belt
comfortably, and whose legs are long enough to bend
over the front of the seat when their back is against the
seat back, should use the lap/shoulder belt in a rear seat.
62 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 63 of 376
•Make sure that the child is upright in the seat.
•The lap portion should be low on the hips and as snug
as possible.
•Check belt fit periodically. A child’s squirming or
slouching can move the belt out of position.
•If the shoulder belt contacts the face or neck, move the
child closer to the center of the vehicle. Never allow a
child to put the shoulder belt under an arm or behind
their back.
Transporting Pets
Airbags deploying in the front seat could harm your pet.
An unrestrained pet will be thrown about and possibly
injured, or injure a passenger during panic braking or in
a collision.
Pets should be restrained in the rear seat in pet harnesses
or pet carriers that are secured by seat belts.
ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine in
your new vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 km), speeds up to 50 or 55
mph (80 or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration, within the
limits of local traffic laws, contributes to a good break-in.
Wide open throttle acceleration in low gear can be
detrimental and should be avoided.
The engine oil installed in the engine at the factory is a
high quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
The recommended viscosity and quality grades are
shown in Section 7 of this manual. NON-DETERGENT
OR STRAIGHT MINERAL OILS MUST NEVER BE
USED.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 63
2
Page 64 of 376
A new engine may consume some oil during its first few
thousand miles (kilometers) of operation. This should be
considered as a normal part of the break-in and not
interpreted as an indication of difficulty.
SAFETY TIPS
Exhaust Gas
WARNING!
Exhaust gases can injure or kill. They contain carbon
monoxide (CO) which is colorless and odorless.
Breathing it can make you unconscious and can
eventually poison you. To avoid breathing (CO)
follow the safety tips below.
Do not run the engine in a closed garage or in confined
areas any longer than needed to move your vehicle in or
out of the area.
If it is necessary to sit in a parked vehicle with the engine
running, adjust your heating or cooling controls to force
outside air into the vehicle. Set the blower at high speed.
WARNING!
If you are required to drive with the deck lid open,
make sure that all windows are closed, and the
climate control blower switch is set at high speed.
DO NOT use the recirculation mode.
Safety Checks You Should Make Inside The
Vehicle
Seat Belts
Inspect the belt system periodically, checking for cuts,
frays and loose parts. Damaged parts must be replaced
immediately. Do not disassemble or modify the system.
Front seat belt assemblies must be replaced after a
collision. Rear seat belt assemblies must be replaced after
a collision if they have been damaged (bent retractor, torn
webbing, etc. If there is any question regarding belt or
retractor condition, replace the belt.
Airbag Light
The light should come on and remain on for 6 to 8
seconds as a bulb check when the ignition switch is first
64 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 65 of 376
turned ON. If the LED is not lit during starting, have it
checked. If the light stays on or comes on while driving,
have the system checked by an authorized dealer.
Defroster
Check operation by selecting the defrost mode and place
the blower control on high speed. You should be able to
feel the air directed against the windshield.
NOTE:If the defrost feature is not functioning, the
cause should be located and corrected immediately. The
windshield could fog up while driving and obscure your
visibility.
Periodic Safety Checks You Should Make Outside
The Vehicle
Tires
Examine tires for excessive tread wear or uneven wear
patterns. Check for stones, nails, glass, or other objects
lodged in the tread. Inspect tread and sidewall for cuts or
cracks. Check wheel nuts for tightness, and tires (includ-
ing spare) for proper pressure.
Lights
Have someone observe the operation of exterior lights
while you work the controls. Check turn signal and high
beam indicator lights on the instrument panel.
Fluid Leaks
Check area under vehicle after overnight parking for fuel,
engine coolant, oil, or other fluid leaks. In addition, if
gasoline fumes are detected or fuel, power steering fluid,
transmission fluid, or brake fluid leaks are suspected, the
cause should be located and corrected immediately.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 65
2
Page 66 of 376
Page 67 of 376
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
CONTENTS
Mirrors..............................70
▫Inside Day/Night Mirror— If Equipped......70
▫Automatic Dimming Mirror— If Equipped....70
▫Electric Remote-Control Mirrors............71
▫Adjusting Side View Mirrors..............72
▫Illuminated Vanity Mirrors — If Equipped....73
Hands–Free Communication (UConnect™) —
If Equipped
...........................73
▫Operations...........................75
▫Phone Call Features....................81
▫UConnect™ System Features..............83
▫Advanced Phone Connectivity.............86▫Things You Should Know About Your
UConnect™ System.....................88
▫General Information....................95
Seats................................96
▫Manual Front Seat Adjustments............96
▫Power Seats — If Equipped...............98
▫Heated Seats — If Equipped..............99
▫Fold Flat Front Passenger Seat............100
▫Adjustable Head Restraints..............101
▫Folding Rear Seat.....................101
▫Folding Rear Seat Center Armrest..........102
To Open And Close The Hood............103
3
Page 68 of 376
Lights..............................104
▫Map/Reading/Interior Lights............104
▫Multi-Function Control Lever.............105
▫Headlights, Parking Lights, Instrument
Panel Lights.........................105
▫Automatic Headlight System — If Equipped . . 106
▫Headlight Time Delay..................106
▫Passing Light / Flash To Pass.............106
▫Daytime Running Lights (DRL) —
If Equipped.........................107
▫Lights On Reminder...................107
▫Fog Lights — If Equipped...............107
▫Turn Signals.........................108
▫Highbeam/Lowbeam Select Switch.........108
Windshield Wipers And Washers..........109
▫Windshield Washers...................109▫Mist Feature.........................110
▫Windshield Wiper Operation.............111
▫Speed Sensitive Intermittent Wiper System . . . 111
▫Adding Washer Fluid..................111
Tilt/Telescoping Steering Column..........112
Electronic Speed Control — If Equipped.....113
▫ToActivate ..........................113
▫To Set At A Desired Speed...............113
▫To Deactivate........................114
▫To Resume Speed.....................114
▫To Vary The Speed Setting...............114
▫To Accelerate For Passing...............115
Garage Door Opener (HomeLink)—
If Equipped
..........................115
▫Programming The Universal Transceiver
(HomeLink) ........................115
68 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 69 of 376
▫Programming A “Rolling Code” System.....117
▫Canadian Programming/Gate Programming . . 118
▫Using HomeLink.....................118
▫Erasing HomeLink Buttons..............118
▫Reprogramming a Single HomeLink Button . . . 119
▫Security............................119
Power Sunroof — If Equipped............121
▫Opening Sunroof - Manual..............122
▫Opening Sunroof - Express..............122
▫Closing Sunroof - Manual...............122
▫Venting Sunroof - Express...............122
▫Closing Sunroof - Express...............122
▫Auto Sunroof (Express) With Anti–Pinch
Protection — If Equipped...............122
▫Sunshade Operation...................123▫Wind Buffeting.......................123
▫Sunroof Maintenance...................123
▫Ignition Off Operation..................123
Electrical Power Outlets.................124
▫Electrical Power Inverter — If Equipped.....125
▫Electrical Outlet Use With Engine Off.......126
Cigar Lighter And Ash Receiver...........126
▫Cup Holder Ash Receiver — If Equipped....126
Console Features......................128
▫Console Features......................128
Cup Holders.........................130
▫Heated Or Cooled Cup Holder —
If Equipped.........................130
▫Rear Bottle Holders....................131
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 69
3
Page 70 of 376
MIRRORS
Inside Day/Night Mirror— If Equipped
Adjust the mirror to center on the view through the rear
window. A two-point pivot system allows for horizontal
and vertical mirror adjustment.
Annoying headlight glare can be reduced by moving the
small control under the mirror to the night position
(toward rear of vehicle). The mirror should be adjusted
while set in the day position (toward windshield).
Automatic Dimming Mirror— If Equipped
This mirror will automatically adjust for annoying head-
light glare from vehicles behind you. Push in the button
on the face of the mirror to activate the dimming feature.
Adjusting Manual Rear View Mirror
Automatic Dimming Mirror
70 UNDERSTANDING THE FEATURES OF YOUR VEHICLE