warning Citroen BERLINGO MULTISPACE 2016 2.G Workshop Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2016, Model line: BERLINGO MULTISPACE, Model: Citroen BERLINGO MULTISPACE 2016 2.GPages: 296, PDF Size: 10.36 MB
Page 170 of 296

168
Berlingo-2-VP_en_Chap07_Verification_ed01-2016
Filling
Ensure that the vehicle is parked on a flat and level surface.
Pour
the contents of the container /
bottle
into the dedicated tank.
After
filling the
AdBlue® tank, observe the
following
procedure:
-
Switch on the ignition without
starting.
-
W
ait 10 seconds before starting the
engine.
Never
dispose
of
empty
AdBlue®
containers and bottles in the
household
waste.
Place
them
in
a
special
container
provided
this
purpose
or
take
them
to
your
dealer.
k
eep a dBlue
® out of the reach of
children,
in
its
original container.
n
ever transfer a dBlue
® to another
container:
it
would
loose
its
purity.
Never
dilute
the
fluid
with
water.
Never
pour
the
fluid
into
the Diesel fuel
tank.
Recommendations on storage
never store containers or bottles of adBlue® in your vehicle.
Freezing of the AdBlue
®
adBlue® freezes at about -11°C (12.2° F) and
deteriorates above 25°C (77°F).
It
is
recommended that containers and
bottles be stored in a cool area and
protected
from direct sunlight.
Under
these conditions, the fluid can
be
kept
for at least a year.
a
dditive that has been frozen can
be used once it has thawed out in
ambient air. The
SCR system includes an
a dBlue
® tank heater that ensures operation
of the vehicle in normal
conditions.
In exceptional situations, such
as
when
the
vehicle is kept at
temperatures
below -15°C (5°F) for a
long
period,
there may be an emission
fault alert related to freezing of the a
dBlue
® additive.
Park
the vehicle in an area at a more
moderate
temperature for a few hours
until
the a dBlue
® becomes a fluid again.
The
emissions
warning lamp does not
go
off
immediately, but does so after a
few
miles
of
driving.
adBlue®
Page 172 of 296

170
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2016
ECONOMY MODE
after the engine has stopped, with
the key in the ignition position, certain
functions (windscreen wiper
, electric
windows,
courtesy lamps, audio
equipment,
etc.) can only be used for a
cumulative
duration of thirty minutes, to
prevent
discharging of the battery.
Once
the thirty minutes have elapsed,
the active functions are put on standby
and
the battery warning lamp flashes
accompanied
by a message in the
screen.
T
o resume the use of these functions
immediately
, start the engine and let it
run
for a few minutes.
The
time available will then be double
the
time for which the engine was left
running.
However, this time will always
be
between five and thirty minutes.
A
flat battery will prevent the
engine
from starting.
Battery
Page 173 of 296

171
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2016
The temporary tyre repair kit consists of a compressor and a bottle
(containing
a sealant).
Using the kit
- Tick the deflated wheel on the speed
limitation sticker then affix
the
sticker to the vehicle's steering
wheel
to remind you that a wheel is
in
temporary use.
-
Clip the bottle
1 on the
compressor 2.
-
Connect the bottle
1 to the valve of
the
tyre to be repaired.
-
T
ake care to unwind the
compressor
pipe before connecting
it
to the bottle.
-
Connect the power lead to one of
the
vehicle's 12V sockets.
-
Switch
on the compressor by
pressing button
A until the tyre
pressure
reaches 2.0 bars. If this
pressure cannot be reached, the
tyre
cannot be repaired.
-
Remove
and store the compressor.
-
Drive
immediately, for a few miles
(kilometres),
at reduced speed, to
fill
the puncture.
-
Adjust
the pressure using the
compressor
in accordance with the
recommendation
for
the
vehicle
and
check
that the leak is filled correctly
(no
further loss of pressure).
-
Drive
at reduced speed (50 mph
[80
km/h]).
The
tyre must be
examined
and repaired by a
specialist
as soon as possible.
a
fter use, the bottle can be stored in
a plastic bag, supplied in the kit, to avoid staining your vehicle with traces
of
fluid.
Warning:
the sealant product is
harmful
if swallowed and causes
irritation
to the eyes.
Keep
it out of reach of children.
a
fter use, do not discard the bottle into
the
environment, take it to a CITROËN
dealer or to an specialised waste
disposal
site.
Replacement
bottles of sealant are
available
from CITROËN dealers.
TEMPORARY PUNCTURE
REP
AIR KIT
The kit is located in one of the two storage compartments located
under
the front seats.
Vehicles
supplied with a temporary
puncture
repair kit do not have a spare
wheel
or tooling (jack, wheelbrace, ...).
QUICk HELP
8
Changing a wheel
Page 220 of 296

Audio and Telematics
218
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
Risk areas / Danger zone
alert settings
Press on Navigation to display the
primary pag e.
Press
on the secondary page.
Select " Settings ".
Select " Alarm!"
(Alert).
It
is
then
possible to activate Risk areas alerts
t
hen:
-
"au
dible warning"
-
"al
ert only when navigating"
-
"al
ert only for overspeed"
-
"
Display speed limits"
-
T
iming: the choice of timing allows the
t
ime
before giving a Risk areas alert to be
de
fined. Select " Confirm ". This series of alerts and displays is
only
available if Risk areas have first
b
een downloaded and installed on the
system.
Tr a f fi c
Traffic information
Display of messages
Press on Navigation to display the
primary pag e.
Press
on the secondary page.
Select " Traffic messages ".
Choose
filter settings for:
" On the route ",
" Around ",
" Near destination ", filters to fine-
tune
the list of messages.
Press
again to remove the filter.
Page 264 of 296

Audio and Telematics
262
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
The table below gives answers to the most frequently asked questions on your audio system.
Q UESTION ANSWER SOLUTION
The route calculation is not
successful. The
navigation settings may conflict with the current location
(
exclusion of toll roads on a toll motor way).Check
the settings in the "Navigation" menu.
The
POIs do not appear. The POIs have not been selected.Select
the POIs in the list of POIs.
The
Risk areas audible
w
arning does not work.The
audible warning is not active.
ac
tivate audible warnings in the "
na
vigation"
menu.
The
system does not
s
uggest a detour around an
incident
on the route.The
guidance criteria do not take account of TMC messages. Select the "Information" function in the list of
g
uidance
c
riteria.
I
receive a Risk areas alert
w
hich is not on my route.Other
than guidance, the system announces all Risk areas
p
ositioned in a cone located in front of the vehicle. It may provide an
a
lert for Risk areas located on nearby or parallel roads.Zoom
in on the map to view the exact position of
t
he Risk areas. Select "On the route" to no longer
r
eceive alerts other than guidance or to reduce
the
time for the announcement.
Frequently asked questions
Navigation
Page 284 of 296

Audio and Telematics
282
Berlingo-2-VP_en_Chap10b_Rd45_ed01-2016
Screen C
Audio functions
alternative frequencies (RdS )
Activate / deactivate
FM
preferences
Regional mode (REG)
Activate
/ deactivate
Radio-text
information (RDTXT)
Activate
/ deactivate
1
2
3
4
3
4
3
4
Play modesAlbum repeat (RPT)
Activate
/ deactivate
Track
random play (RDM)
Activate
/ deactivate2
3
4
3
4
Enter distance to destination1
1
1
2
2
2
Pressing the MENU button displays:
Audio functions Trip computerDistance: x miles
Vehicle diagnosis
Warning log
Systems activated or deactivated
State of systems