Citroen C ZERO 2011 1.G Service Manual

3
!
Comfort
39






Head restraint height adjustment



)
To raise it, pull upwards.

)
To lower it, push it downwards, pressing
the height adjustment button at the same
time.

)
To remove it, raise it to the high position,
then remove it pressing the height
adjustment button at the same time.

)
To refit it, engage the rods of the head
restraint in the aper tures, pressing the
height adjustment button at the same time. Never drive with the removed head
restraints in the vehicle as they could
be thrown around the vehicle on sharp
braking. They must always be in place
and adjusted correctly.
After installing the head restraint, check
that the height adjustment button has
engaged correctly.
The adjustment is correct when the top
of the head restraint is aligned with the
top of the head of the seated person.
Press the control switch, located on the
dashboard, to switch on the driver's seat
heating.
The warning lamp in the switch comes on.
The temperature is controlled automatically.
Pressing a second time stops operation.


Heated seat control

!!
Comfort
40













Rear seats
Rear seat comprising two adjustable, foldable backrests and a fixed cushion.


Rear head restraints

These have a high position (comfor t and best
safety) and a low position (best rear vision for
the driver).
They can also be removed.
To remove a head restraint:


)
pull the head restraint fully upwards,

)
then, press the lug.
When carrying rear passengers, never
drive with their head restraints removed;
ensure that they are in place and in the
high position.


Adjusting the backrest
angle
To adjust the backrest:


)
pull the control for wards to release
the backrest,

)
adjust the backrest then release
the control.
The backrest can be adjusted to one of seven
positions.
Always ensure that the backrest has
engaged correctly.

3
!
Comfort
41
Returning the seat backrest to its original position



)
Push the seat backrest in position and secure it,

)
refit the head restraints or put them back in
place.


1.
Place the head restraints in the low position
or remove them if necessary,

2.
pull the control for wards to release
backrest,

3.
fold the backrest for ward.



Folding the backrest

When returning the backrest to its
original position, take care not to trap
the seat belts.

!
Comfort
42





Door mirrors

The mirrors can be adjusted when the ignition
switch is in the "ON" or "ACC" position.


)
Move control A
to the right or to the left to
select the corresponding mirror.

)
Direct control B
in all four directions to
adjust the mirror.
When adjustment is complete, return control A

to the central position.


Adjustment


The mirrors can also be folded
manually.
However, you must never unfold them
manually
, other wise the mirrors may
not remain in place correctly when
driving.
Always use control C
to unfold them.




)
With the ignition switch in the "ON" or
"ACC" position: press control C
to unfold
them

)
With the ignition switch in the "LOCK"
position: press control C within
30 seconds
to fold them.








Electric folding/unfolding

3
Comfort
43





Rear view mirror


Adjust the mirror by moving it up or down and/
or to the left or right.
The rear view mirror has two positions:


- day (normal),

- night (anti-dazzle).
To change from one to the other, push or pull
the lever on the lower edge of the mirror.

Comfort
44




















Interior fi ttings



1.
Glove box


2.
Retractable cup holder

Press the cover to open the cup holder

3.
1

2 V accessor y socket
(120 W )

Observe the maximum power rating to
avoid damaging your accessory

4.
Open storage


5.
USB Player


6.
Door pocket

3
!
Comfort
45





12 V accessory
socket


)
To connect a 12 V accessory (max power:
120 W), lift the cover and connect a
suitable adaptor.












Mat

To prevent any risk of jamming under
the pedals:


- only use mats suited to the fixings
already present in the vehicle; it is
imperative that these fixings are
used.

- never fit one mat on top of another.

When removing the mat on the driver's side,
move back the seat as far as possible and
remove the fixings.
When refitting, position the mat correctly on the
pins and clip the fixings. Check that the mat is
secured firmly. The sun visors fold for wards, and to the side
when they are unhooked.
They are fitted with a cour tesy mirror and a
ticket holder.





Sun visor

i
Comfort
46

When connected to the USB por t, the por table
device charges automatically.

For more information on the use of
this system, refer to the "Audio and
Telematics" section.









USB Player


This USB port, is located on the centre console.
It permits the connection of por table devices,
such as a digital audio player of the iPod ® type
or a USB memory stick.
It reads the audio files which are transmitted
to your audio equipment and played via the
vehicle’s speakers.
You can manage these files using the audio
system controls.

3
Comfort
47








Heating and Ventilation


Air intake

The air circulating in the passenger compar tment
is filtered and originates either from the outside
via the grille located at the base of the windscreen
or from the inside in air recirculation mode.

System which creates and maintains good
conditions of comfor t and visibility in the
vehicle's passenger compar tment.
The heating and ventilation can be used as
soon as the "Ready" lamp is on.

Controls

The incoming air follows various routes
depending on the controls selected.
The temperature control enables you to obtain
the level of comfor t required by mixing the air of
the various circuits.
The air distribution control enables you to
select the air vents used in the passenger
compartment.
The air flow control enables you to increase or
reduce the speed of the ventilation fan.
These controls are grouped together on control
panel A
on the centre console.


Air distribution



1.
Windscreen demisting/defrosting vents.

2.
Front side window demisting/defrosting
vents.

3.
Side adjustable air vents.
4.
Central adjustable air vents.

5.
Air outlets to the front footwells.

i
Comfort
48
In order for these systems to be fully effective, follow the operation and maintenance
guidelines below:


)
If the interior temperature remains very high after the vehicle has been parked in
the sun for a considerable time, first ventilate the passenger compartment for a few
minutes by opening the windows.
Place the air flow control at a sufficient level to provide an adequate renewal of air in
the passenger compar tment.

)
Condensation created by the air conditioning results in a discharge of water under
the vehicle when stationary, which is per fectly normal.

)
To obtain an even air distribution, take care not to obstruct the exterior air intake grilles
located at the base of the windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.

)
Use in preference the intake of exterior air as prolonged use of the air recirculation may
cause misting of the windows and side windows.

)
Operate the air conditioning system for 5 to 10 minutes, once or twice a month to keep it
in good working order.

)
Ensure that the passenger compartment filter is in good condition and have the filter
elements replaced regularly (refer to "Checks").

)
To ensure correct operation of the air conditioning system, you are also advised to have
it checked regularly.

)
If the system does not produce cold air, do not use it and contact a CITROËN dealer or
a qualified workshop.











Recommendations for ventilation and air conditioning


The heating and air conditioning use
energy from the main battery. Their use
increases electrical consumption and
reduces the range of the vehicle.
Remember to switch off the heating
or air conditioning as soon as it is no
longer needed.