ignition Citroen C1 2008.5 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2008.5, Model line: C1, Model: Citroen C1 2008.5 1.GPages: 99, PDF Size: 4.14 MB
Page 65 of 99
6
59
SAFETY
AIRBAGS
The airbags have been designed to
maximise the safety of the occupants
in the event of serious collisions. They
work in conjunction with the force-
limiting seat belts. The electronic
detectors register and analyse any
abrupt deceleration of the vehicle
in the impact detection zones (see
diagram): if the triggering threshold is
r e a c h e d , t h e a i r b a g s i n fl a t e i n s t a n t l y
and protect the occupants of the
vehicle.
FRONT AIRBAGS
These are folded in the centre of the
steering wheel for the driver and in the
fascia for the front passenger. They
are deployed simultaneously, except in
cases where the passenger airbag is
deactivated, in the event of a serious
front impact applied in the impact
zone A in the longitudinal centreline of
the vehicle, on a horizontal plane and
from the front of the vehicle towards
t h e r e a r . T h e a i r b a g i n fl a t e s b e t w e e n
the front occupant of the vehicle and
the dashboard to cushion his forward
movement. The airbags therefore limit
the risk of injury to the head and chest.
Front airbag malfunction
Flashing indicates an
airbag malfunction, contact
a C I T R O Ë N d e a l e r t o h a v e
the system checked. The
airbags may no longer be
triggered in the event of a serious
impact
Note: the gas escaping from
the airbags can be a minor
irritant.
Immediately after the impact, the
a i r b a g s d e fl a t e r a p i d l y s o t h a t t h e y
do not hinder the visibility of the
occupants nor their exit if necessary
from the vehicle. The air bags are
not deployed in the case of minor
impacts, rear impacts or in certain
roll-over conditions. The seat belt
i s s u f fi c i e n t t o e n s u r e m a x i m u m
protection in these situations. The
seriousness of a collision depends
on the nature of the obstacle and the
speed of the vehicle at the moment
of the collision.
Airbags only operate when the
ignition is switched on. When they
are triggered, a noise is heard
d u r i n g i n fl a t i o n .
Impact detection zones
A. Front impact zone.
B. Side impact zone.
Page 66 of 99
6
60
SAFETY
Deactivating the passenger
airbag
it is essential to deactivate the passenger airbag when you install a "rear-facing" child seat on the front passenger seat. Otherwise, the child would risk being seriously injured or killed if the air bag were t o i n fl a t e . With the ignition switched off , switched offinsert the key into the passenger airbag deactivation switch 1 , turn it to the "OFF" position, then remove the key keeping the switch in this position.
In the "OFF" position, the passenger air bag will not be triggered in the event of an impact.
As soon as the child seat is removed, turn the airbag switch to the "ON"position to re-activate the airbag and thus ensure the safety of your passenger in the event of an impact.
If the passenger airbag is deactivated, the warning lamp on the instrument panel remains on until the passenger airbag is reactivated.
T h e c u r t a i n a i r b a g i n fl a t e s b e t w e e n
the front or rear occupant and the
windows. It therefore limits the risk
of head injuries. In the event of a
minor impact or bump on the side of
the vehicle or if the vehicle rolls over,
the airbag may not be triggered. The
airbag is not triggered in the event of
a front or rear collision. Flashing indicates a
malfunction of at least one
of these airbags.
C o n t a c t a C I T R O Ë N d e a l e r
to have the system checked.
The air bags may no longer be triggered
in the event of a serious impact.
Deactivation (check)
Airbag malfunction
* According to version.
SIDE AIRBAGS * AND CURTAIN AIRBAGS *
The side airbags are built into the
front seat backs on the door side.
The triggering of these airbags
requires a serious side impact
applied in the side impact zone B ,
perpendicular to the longitudinal
centreline of the vehicle, on a
horizontal plane and from the outside
of the vehicle towards the inside. The
s i d e a i r b a g i n fl a t e s b e t w e e n t h e f r o n t
occupant of the vehicle and the door
trim pad. It therefore limits the risk of
injury to the chest.
The rear side airbags afford the rear
passengers the same protection
which the front side airbags offer the
front passengers.
The curtain airbags are built into the
headlining.
Page 68 of 99
6
60
SAFETY
Deactivating the passenger
airbag
it is essential to deactivate the passenger airbag when you install a "rear-facing" child seat on the front passenger seat. Otherwise, the child would risk being seriously injured or killed if the air bag were t o i n fl a t e . With the ignition switched off , switched offinsert the key into the passenger airbag deactivation switch 1 , turn it to the "OFF" position, then remove the key keeping the switch in this position.
In the "OFF" position, the passenger air bag will not be triggered in the event of an impact.
As soon as the child seat is removed, turn the airbag switch to the "ON"position to re-activate the airbag and thus ensure the safety of your passenger in the event of an impact.
If the passenger airbag is deactivated, the warning lamp on the instrument panel remains on until the passenger airbag is reactivated.
T h e c u r t a i n a i r b a g i n fl a t e s b e t w e e n
the front or rear occupant and the
windows. It therefore limits the risk
of head injuries. In the event of a
minor impact or bump on the side of
the vehicle or if the vehicle rolls over,
the airbag may not be triggered. The
airbag is not triggered in the event of
a front or rear collision. Flashing indicates a
malfunction of at least one
of these airbags.
C o n t a c t a C I T R O Ë N d e a l e r
to have the system checked.
The air bags may no longer be triggered
in the event of a serious impact.
Deactivation (check)
Airbag malfunction
* According to version.
SIDE AIRBAGS * AND CURTAIN AIRBAGS *
The side airbags are built into the
front seat backs on the door side.
The triggering of these airbags
requires a serious side impact
applied in the side impact zone B ,
perpendicular to the longitudinal
centreline of the vehicle, on a
horizontal plane and from the outside
of the vehicle towards the inside. The
s i d e a i r b a g i n fl a t e s b e t w e e n t h e f r o n t
occupant of the vehicle and the door
trim pad. It therefore limits the risk of
injury to the chest.
The rear side airbags afford the rear
passengers the same protection
which the front side airbags offer the
front passengers.
The curtain airbags are built into the
headlining.
Page 71 of 99
7
63
DRIVING
EASY mode (automatic mode)
Select position E u s i n g t h e g e a r l e v e r .
The gear engaged is displayed on
the instrument panel screen.
The gearbox continuously selects
the most suitable gear.
Manual mode
P l a c e t h e g e a r l e v e r i n p o s i t i o n M ,
then change up or down through the
g e a r s b y p r e s s i n g :
- r e a r w a r d s , "+" to change up,
- f o r w a r d s , "-" to change down.
The gear engaged is displayed on
the instrument panel screen.
If the engine speed is too low, the
gearbox automatically changes down
t o p r e v e n t s t a l l i n g .
I n t h e e v e n t o f o v e r h e a t i n g o f
the clutch, position N is selected
automatically and the symbol N
fl a s h e s a c c o m p a n i e d b y a n a u d i b l e
signal. Operating fault
Stopping the engine
Before switching off the engine, you
can change to position N to be in
neutral.
In all cases, it is essential that you
apply the parking brake to immobilise
t h e v e h i c l e . With the ignition on, the
lighting of this warning
lamp indicates a gearbox
malfunction.
On a slope, use the brake
t o i m m o b i l i s e t h e v e h i c l e
a n d p l a c e t h e g e a r l e v e r i n
position N , E or R .
D o n o t k e e p t h e v e h i c l e i m m o b i l i s e d
using the accelerator.
Always press the brake pedal
while starting the engine.
N e v e r s e l e c t n e u t r a l N while
t h e v e h i c l e i s m o v i n g .
In all cases, it is essential to
apply the parking brake to
i m m o b i l i s e t h e v e h i c l e .
C o n t a c t a C I T R O Ë N d e a l e r .
Page 74 of 99
8
67
CHECKS
CHECKING THE LEVELS
There are two marks
on the dipstick:
A = maximum
I f y o u fi l l p a s t t h i s m a r k ,
contact a CITROËN
dealer.
B = minimum
Never allow the level
to fall below this mark.
Dipstick
Oil change
According to the information given in
the servicing booklet. Changing the brake fluid
T h e b r a k e fl u i d m u s t b e c h a n g e d a t
the intervals stated, according to the
manufacturer's servicing schedule.
U s e fl u i d s r e c o m m e n d e d b y t h e
m a n u f a c t u r e r , w h i c h f u l fi l D O T 4
standards.
Windscreen wash level
For best quality cleaning and for your
safety, we would advise that you
use products recommended by your
manufacturer.
Consult a CITROËN dealer.
Oil viscosity grade
In all cases, the oil selected must meet
the manufacturer's requirements. Cooling system
Used oil
Avoid prolonged contact of used oil
with the skin.
B r a k e fl u i d i s h a r m f u l t o h e a l t h a n d
very corrosive.
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited. Slacken the cap by 1/4 of a
turn to release the pressure
to prevent any risk of
scalding. When the pressure
has dropped, remove the cap and
top up the level. O n l y u s e t h e fl u i d r e c o m -
mended by the manufacturer.
Otherwise, you risk seriously
damaging your engine.
Do not dispose of used oil,
b r a k e fl u i d o r c o o l a n t i n t o
drains or into the ground.
Empty the used oil into the
containers provided for this
purpose in the CITROËN network
(France) or at an authorised waste
disposal site.
Oil level
Check the level regularly and top up
between changes. The maximum
consumption is 0.5 l per 600 miles
(1 000 km).
Check the level with the vehicle level,
engine cold, using the dipstick.
When the engine is warm, the
temperature of the coolant is
controlled by the engine fan. As this
fan can operate with the ignition key
removed and because the cooling
system is pressurised, wait for at
least one hour after the engine has
stopped before carrying out any
work.
Page 89 of 99
9
78
PRACTICAL INFORMATION
Fuse N° Rating
Functions
1 50 A "SensoDrive" gearbox - Fan assembly (diesel)
2
10 A Headlamps
20 A Headlamps with daytime running lamps
3 30 A ABS/ESP control unit
4 30 A Ignition switch supply
5 10 A Hazard warning lamps - Instrument panel warning lamps - Direct ion indicators
6 10 A Headlamps
7 15 A Courtesy lamp - Speedometer - Audio equipment - Instrument pan el - Rev counter
8 15 A/25 A Petrol/diesel engine control unit
9 10 A Horn
10 30 A Fan assembly (petrol)
11 50 A ABS/ESP
12 50 A Power steering
Page 90 of 99
9
79
PRACTICAL INFORMATION
BATTERY
Do not push the vehicle to
start the engine if you have a
"SensoDrive" gearbox.
Before disconnecting the
battery, you must wait for
2 minutes after switching off
the ignition.
Never disconnect a terminal when
the engine is running.
N e v e r c h a r g e a b a t t e r y w i t h o u t fi r s t
disconnecting the terminals.
Close the windows and doors before
disconnecting the battery.
After every reconnection of the
battery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised.
I f s l i g h t d i f fi c u l t i e s a r e e x p e r i e n c e d
after this, please consult a CITROËN
dealer.
To start the vehicle from
another battery:
- Connect the red cable to the
positive (+) terminals of the two
batteries,
- Connect the green or black cable to the negative (-) terminals of the
two batteries,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
It is advisable to disconnect
the battery if the vehicle is
not to be used for a period of
more than one month.
The batteries contain harmful
substances such as sulphuric
acid and lead. They must
be discarded in accordance
with the provisions of the law and
must not, in any circumstances, be
discarded with household waste.
Return used batteries to a special
collection point.
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use
given by the battery charger
manufacturer,
- Reconnect starting with the negative (-) terminal,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them.
A. Failed battery
B. Slave battery