warning Citroen C3 RHD 2013 2.G Owner's Guide

2
Multifunction screens
43







Monochrome screen A

This displays the following information:


- time,

- date,

- ambient temperature
(this flashes if there isa risk of ice),

- status of the doors and boot,

- audio sources
(radio, CD...),

- trip computer (refer to the "Instruments andControls" section).
Warning messages (e.g.: "Emission control system faulty") or information messages (e.g.:
"Boot open") may appear temporarily. Thesecan be cleared by pressing the "Back"button.
Controls
From the control panel of your Audio system,you can:)
press the "MENU"
button to gain access to
the main menu,)
press the " 
" or " " buttons to scroll
through the items in the screen,) press the "MODE"
button to change
the permanent application (date, audio source...),) press the "  " or " " buttons to change asetting value,)
press the "OK"button to confirm,or )
press the "Back"button to abandon the
operation in progress.



Main menu
)
Press the "MENU"
button to gain access to
the main menu
, then press the " "or " " buttons to scroll through the variousmenus:
- radio-CD,
- vehicle configuration,
- options,
- displa
y settings,
- languages,
- units.)
Press the "OK"button to select the menurequired.


Radio-CD

With the Audio system switched on, once the
"Radio- CD" menu has been selected you canactivate or deactivate the functions linked
with use of the radio (RDS, REG), or the CD(introscan, shuffle, CD repeat).
For more information on the "Radio-CD"
application, refer to the Audio system par t of
the "Audio and Telematics" section.


Displays in the screen

Multifunction screens
46










Monochrome screen C
This displays the following information:
- time,
- date,
- ambient temperature (this flashes if there isa risk of ice),
- status of doors and boot,
- audio sources (radio, CD, USB por t / auxiliary socket etc.),
- trip computer (refer to the "Instruments andcontrols" section).
Warning messages (E.g. "Emissions controlsystem faulty") or information messages (E.g.: Automatic headlamps active") may appear temporarily. These can be cleared bypressing the "Back"
button.


Controls

From your Audio system control panel, you can: )
press the "MENU"
button to gain access to
the main menu,)
press the " " or " " buttons to scroll
through the items in the screen,
) press the "MODE"button to change the
permanent application (trip computer, audiosource...), ) press the " 
" or " 
" buttons to change a setting value, )
press the "OK"button to confirm,
or ) press the "Back"button to abandon theoperation in progress.

Main menu
)
Press the "MENU"button to gain access to
the main menu
:


- audio functions,

- the trip computer,

- personalisation-confi
guration,

- telephone (hands-free kit). )
Press the "  " or " " buttons to select the
menu required, then confirm by pressingthe "OK"button.



"Au d i o f u n c t i o n s"
menu

With the Audio system switched on, once this menu has been selected you can activateor deactivate the functions linked with use
of the radio (RDS, REG, RadioText), the CD (introscan, shuffle, CD repeat) or the MP3 player (USB por t / auxiliary socket).
For more information on the "Audio functions"
application, refer to the Audio system part of
the "Audio and Telematics" section.
Displays in the screen

2
Multifunction screens
47
"Trip computer" menu
Once this menu has been selected, you can consult information concerning the status of the
vehicle (warnings log, status of functions, etc.)

Alert log

This summarises the active warning messages,
displaying them in succession in themultifunction screen.
)
In the "Trip computer"
menu, select one
of the following applications:
) Press the "MENU"
button to gain access to
the general menu.) Press the arrows, then the "OK"
button to select the "Trip computer"menu.
Status of functions
This summarises the status (active or inactive)of the vehicle's functions.
Enter distance to destination
This allows you to enter an approximate
distance until your final destination.

Multifunction screens
50













16/9 colour screen (eMyWay)
It displays the following information automatically and directly:
- time,
- date,
- altitude,
- ambient temperature
(the value displayed
flashes if there is a risk of ice),
- check of the doors,
- warning and vehicle function status messages, displayed temporarily,
- audio functions,
- trip computer information (see the "Monitoring" section),
- satellite navigation system information.


Controls

To select one of the applications, from theeMyWay control panel:)
press the dedicated "RADIO"
, "MUSIC","NAV"
, "TRAFFIC", "SETUP"
or "PHONE"
button for access to thecorresponding menu, )
turn the knob to change the selection, )
press the knob to confirm the selection,
or ) press the "Back"button to abandon thecurrent operation and return to the previous
display.
For more in
formation on these applications, refer to the "Audio and Telematics" section or
to the specific user guide given to you with the other owner's documents.


"SETUP" menu
)Press the "SETUP"button to gain access
to the "SETUP"
menu. This allows you to select from the following functions:
- "System language",
- "Date and time",
- "Displa
y",
- "Vehicle",
- "Units",
- "S
ystem".


Displays in the screen

Comfort
56
With the heating /
ventilation s
ystem
)Put the temperature and air flow controls to
t
he dedicated marked position. )Put the air intake control to the "Exterior air intake" position (manual control to the right or electric control with indicator lamp off). )Put the air distribution control to the"Windscreen" position.
Front demist - defrost


These markings on the control panel indicate the control positions for rapid demisting or
defrosting of the windscreen and side windows.

With the manual air
conditioning system
)
Put the temperature and air flow controls to
t
he dedicated marked position.) Put the air intake control to the "Exterior air
intake" position
(manual control to the right or electriccontrol with indicator lamp off).) Put the air distribution control to the "Windscreen" position. )
Switch on the air conditioning by pressingthe "A/C"
button; the associated green
warning lamp comes on.

With Stop & Star t, when the demisting, air conditioning and air flow functionsare activated, STOP mode is not available.

Access
68
Anti-theft protection

Electronic engine immobiliser

The key contains an electronic chip which has
a special code. When the ignition is switched
on, this code must be recognised in order for
startin
g to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event o
f a fault, you are
informed by illumination of this
warning lamp, an audible signal and
a message in the screen.
Ignition switch


- Position 1: Stop

- Position 2: Ignition

- Position 3: Starting


Starting the vehicle
)Inser t the key in the ignition switch.
The system recognises the star ting code. )Turn the key fully towards the dashboard toposition 3 (Starting).)When the engine star ts, release the key.
Locating your vehicle
) Press the closed padlock to locate your locked vehicle in acar park.
This is indicated b
y lighting of the cour tesylamps and flashing of the direction indicators
for a few seconds.
In this case,
your vehicle will not start; contact
a CITROËN dealer as soon as possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.

4
Access
69
Remote control problem
Reinitialisation
) Switch off the ignition.)
Turn the key to position 2 (Ignition on)
. )
Press the closed padlock immediately for a
few seconds.) Switch off the ignition and remove the key
from the ignition switch.
The remote control is full
y operational again.


Changing the battery

Battery ref.: CR1620 / 3 volts.
If the batter
y is flat, you are informed
by illumination of this warning lamp,an audible signal and a message in
the multifunction screen.
) Unclip the casing using a coin at the notch. )
Slide the flat battery out of its location.)
Slide the new battery into its location
observing the original direction. ) Clip the casing.)
Reinitialise the remote control.




Switching the vehicle off


Key reminder

If the key is left in the ignition switch, anaudible signal sounds when the driver's door is opened.


Do not attach any heavy objects to the key as this could weigh down on it whenin the ignition switch and cause a fault. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
v
ehicle.) First of all, use the key in the lock to unlock
or lock your vehicle.) Then, reinitialise the remote control.
If the problem persists, contact a CITROËNdealer as soon as possible.
)Immobilise the vehicle. )Turn the key fully towards you toposition 1 (Stop).)Remove the key from the ignition switch.

4
Access
75











Doors


Opening


From outside
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front door control to open the door;
this unlocks the vehicle completely. ) Pull the rear door control to open the door;
this unlocks only the door opened.

Closing
- When the engine is running, this
warning lamp comes on, accompanied
by a message in the multifunction
screen for a few seconds,
When a door or the boot is not closed correctly:
- When the vehicle is movin
g
(speed higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by an
audible signal and a message in the multifunction screen for a few seconds.

Version with deadlocking

The interior door controls do not operate when
the vehicle is deadlocked.

Access
78











Boot
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.
)
Lower the tailgate using the interior grab
handle.
-when the engine is running, this
warning lamp comes on, accompanied
by a message on the multifunction
screen for a few seconds,
Tailgate release
Unlocking
)Fold back the rear benchseat to gainaccess to the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate.

I
f the tailgate is not closed correctly:
Opening

Closing
-when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal and
a message on the multifunction screen for a few seconds.

System for mechanical unlocking of the boot
in the event of a battery or central lockingmalfunction.

Visibility
84
Manual guide-me-home
li
ghting
The temporary illumination of the dipped beam
headlamps after the vehicle's ignition has been switched off makes the driver's exit easier when
the light is poor.

Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk.)
A further "headlamp flash" switches thefunction off.


Switching off
The manual guide-me-home lighting switches
off automatically after a set time.
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.



Lighting on audible warning

When the ignition is switched off, allof the lamps switch off automatically, unless guide-me-home lighting isactivated.

If the lighting is switched on manually after switching off the ignition, there is an audible signal when a front door is opened to warn the driver that theyhave forgotten to switch off the vehicle'slighting, with the ignition off.