ignition Citroen C3 RHD 2013 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2013, Model line: C3 RHD, Model: Citroen C3 RHD 2013 2.GPages: 288, PDF Size: 11.69 MB
Page 10 of 288

Familiarisation
8
1. Audio equipment steering mountedcontrols. 2.
Steering lock and ignition. 3.
Wipers / screenwash / trip computer control stalk. 4.
Instrument panel. 5.
Scented air freshener.
6.Driver's airbag.
H
orn.
7. Gear lever.8.Parking brake.9.
Central armrest with storage.10.Door mirror controls.Electric window controls.Rear doors and electric windows deactivation control.11.
Storage compartment. 12.Electric child lock button or alarm button.
Electronic stability programme button (ESP/ASR).
Stop & Star t switch.
13.Side adjustable air vent. 14 .Front door window demisting/defrosting
vent. 15. Speaker (tweeter). 16.
Windscreen demisting/defrosting vent.
Instruments and controls
Page 17 of 288

.Familiarisation
15
Instrument panel
A.With the ignition on, the fuel gauge bars for
the fuel remaining should come on. B.With the engine running, the associatedlow level warning lamp should go off.C.With the ignition on, the oil level indicator should display "OIL OK"
for a few seconds.
If the levels are not correct, top up the level
whi
ch is low.
Warning lamps
1.With the ignition on, the orange and red
warn
ing lamps come on. 2. With the engine running, these warning lamps should go off.
If a warning lamp remains on, refer to the pageconcerned.
Switch panel
Lighting of the indicator lamp indicates the status of the corresponding function.A.Activation of the electric child lock.
or
Deactivation of the interior volumetric alarm.
Monitoring
23
25, 307
2
107
B
. Deactivation of the ESP/ASR system.
111
C. Deactivation of the Stop & Start system.
128
Page 21 of 288

.Familiarisation
19
Stop & Start
Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
-with a manual gearbox; at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral and you release the clutch pedal.
-
with a 5 or 6 speed electronic gearbox
: at speeds below 5 mph (8 km/h), when you press the brake pedal or when you put thegear lever into position N.
In certain circumstances, STOP may not be
available; the "ECO"
warning lamp flashes for
a few seconds, then goes off.
Going into engine START mode
The "ECO"
warning lamp goes off
and the engine restarts:
-with a manual gearbox : when youdepress the clutch pedal.
-with a 5 or 6 speed electronic gearbox:
●
gear lever in position A
or M, when you
release the brake pedal,
●
or gear lever in position N
and brake pedal
released, when you select position A or AM ,
●
or when you engage reverse.
In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.
Deactivation / Reactivation
You can deactivate the system at any time bypressing the "ECO OFF"
button; the warninglamp in the button comes on.
Driving safely
127
128
128
, 129
The system is reactivated automatically every time the engine is star ted withwith the key.
Before refuelling or doing anything under the bonnet, you must switch off the ignition with the key.
Page 25 of 288

1
Monitoring
23
Panel grouping together the vehicle operation indication dials and warning lamps.
Instrument panels with manual gearbox
5.Display management button.Servicing information.
Adjust the time and choose units.
R
eset the service indicator.6.Instrument panel lighting button.Adjusts the brightness of the lighting of the
instruments and controls.
1.Rev counter. Indicates the speed of rotation of the engine (x 1 000 rpm). 2.Vehicle speed. Indicates the current speed of the moving
vehicle (mph or km/h). 3. Fuel level. Indicates the quantity of fuel remaining in
the tank. 4.Screen.
A.Ambient temperature. (°Celsius or °Fahrenheit)B.Gear efficiency indicator.C.Time.D.Engine oil level indicator. Appears a few seconds after switching on
the ignition, then disappears. E.Trip computer.F.Ser vice indicator. (miles or km) then, Total mileage. These two functions are displayed successively when switching on
the i
gnition.
Screen
For more information, refer to thesection on the button or function and its associated display.
Dials
Page 26 of 288

Monitoring
24
Instrument panels for electronic or automatic gearboxes
Panel grouping together the vehicle operation indication dials and warning lamps. Depending on the version, the instrument panel may have permanent
back-lighting.
1.Rev counter.Indicates the speed of rotation of the
engine (x 1 000 rpm).2.Vehicle speed.Indicates the current speed of the moving
vehicle (mph or km/h).3.Fuel level.Indicates the quantity of fuel remaining in
the tank. 4.Screen.5.Display management button.
Alternates display between range and trip mileage recorder.
Servicing information.
Resets the selected function to zero (trip
distance recorder or ser vice indicator
).
6.Instrument panel lighting button. Adjusts the brightness of the lighting of the
instruments and controls.
ScreenDials
For more information, refer to thesection on the button or function and its associated display.A
.Speed limiter (mph or km/h) or Cruise control.B.Gear efficiency indicator.C.Electronicorautomatic gearboxinformation.D.Range (miles or km) or Trip mileage recorder.E.
Ser vice indicator
r (miles or km), then Total mileage recorder. These two functions are displayedsuccessively when switching on the ignition
F.Engine oil level indicator. Appears a few seconds after switching on
the ignition, then disappears.
Page 27 of 288

1
Monitoring
25
Visual indicators informing the driver that a system is in operation (operation or deactivation indicator lamps) or of the occurrence of a fault (warning lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehicle's ignition is switched on.
When the engine is star ted, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Operation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.
Associated warnings
The illumination of cer tain warning lamps may
be accompanied by an audible signal and a
message in the multifunction screen.The warning lamps may come on continuously (fixed) or flash.
Warning lampis onCauseAction / Observations
Left-hand direction indicator flashing with buzzer.The lighting stalk is pushed down.
Right-handdirection indicatorr
flashing with buzzer. The lighting stalk is pushed up.
Sidelamps
fixed. The lighting stalk is in the
"Sidelamps" position.
Hazard warning lamps flashing with audiblesignal.The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction indicators and
their associated indicator lamps flash simultaneously.
Certain warning lamps may come on
in one of two different modes. Only by relating the type of illumination to the operating status of the vehicle can itbe ascertained whether the situation isnormal or whether a fault has occurred.
Indicator and warning lamps
Page 28 of 288

Monitoring
26
Front foglampsfixed.The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.
Rear foglampsfixed.The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.
Diesel engine pre-heatingfixed.The ignition switch is at the
2nd position (ignition on).Wait until the warning lamp goes off before star ting.
The period of illumination of the warning lamp is
determined by the climatic conditions (up to about
thirty seconds in extreme climatic conditions).
If the engine does not star t, switch the ignition off and
then on, wait until the warning lamp goes off again,
then star t the engine.
Parking brakefixed.The parking brake is applied or not properly released.Release the parking brake to switch off the warninglamp, keeping your foot on the brake pedal.Observe the safety recommendations.
For fur ther information on the parking brake, refer to
the "Parking brake" section.
Warning lampis onCauseAction / Observations
Dipped beamheadlampsfixed.The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam headlampsfixed.The lighting stalk is pulled towardsyou. Pull the stalk to return to dipped beam headlamps.
Page 32 of 288

Monitoring
30
reading the associated message in the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified workshop.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the following warning lamps indicates a fault whichrequires action on the par t of the driver.
Warning lampis onCauseAction / Observations
STOPfixed, alone or
associated withanother warning lamp,accompanied by anaudible signal anda message on the screen. Illumination of the warnin
g lamp is
associated with a serious braking system or engine coolant temperature problem. Stop as soon as it is safe to do so as the en
gine may
cut out when driving.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Servicetemporarily. Minor problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown in
the screen, such as, for example:
- the engine oil level,
- the screenwash level,
- the remote control batter
y,
- saturation of the par ticle emission filter on Diesel
vehicles
(see the "Checks - Particle emissions
filter" section).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed.Major problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown
in the screen and contact a CITROËN dealer or a
qualified workshop.
Page 34 of 288

Monitoring
32
Warning lampis onCauseAction / Observations
Maximum coolant temperaturefixed red. The temperature of the coolingsystem is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact a CITROËN dealer or qualified workshop.
Engine oil
pressure
fixed. There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
dealer or a qualified workshop.
Battery chargefixed.The battery charging circuit has a fault (dir ty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a
qualified workshop.
Low fuel levelfixed.When it first comes on there remainsapproximately 5 litres offuelin thetank.You must refuel as soon as possible to avoid runnin
gout of fuel.
This warning lamp will come on every time the ignition
is switched on
, until a sufficient addition of fuel is made.
Fuel tank capacity: approximately 50 litres (petrol),
46 litres (Diesel) or 37 litres (LPG); depending on
version: approximately 30 litres (petrol or Diesel).
Never continue to drive until you run out of fuel as
this could damage the emission control and injectionsystems.
Page 35 of 288

1
Monitoring
33
Airbags
temporarily. This lamp comes on for a fewseconds when you turn on the
ignition, then goes off. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.
fix
ed. One of the airbag or seat belt pretensioner systems has a fault. Have it checked by a CITROËN dealer or a qualified
workshop.
Seat belt not fastened / unfastened
fixed then flashingaccompanied by an
increasing audiblesignal.The driver and
/or the front passenger has not fastened or has unfastenedtheir seat belt.
Pull the strap then inser t the tongue in the buckle.
Warning lampis onCauseAction / Observations
Door(s) open
fixed if the speed is
below 6 mph (10 km/h). A door or the boot is still open. Close the door or boot.
fixed and accompaniedby an audible signalif the speed is above6 mph (10 km/h).