Battery Citroen C4 2016 2.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2016, Model line: C4, Model: Citroen C4 2016 2.GPages: 396, PDF Size: 10.22 MB
Page 68 of 396

66
C4-2_en_Chap02_ouvertures_ed02-2015
Locking the passenger doors
F Open the doors.
F O n the rear doors, check that the child lock
i
s not on.
For
more information on the child lock, refer to
t
he corresponding section.
F
R
emove the black cap, located on the edge
o
f the door, using the integral key.
F
I
nsert the integral key in the socket without
f
orcing it, then without turning it, move the
l
atch sideways towards the inside of the
d o o r.
F
R
emove the integral key and refit the cap.
F
C
lose the doors and check that the vehicle
h
as locked correctly from the outside.
Unlocking the passenger doors
F Pull the interior door opening control.
Changing the battery
Battery ref.: CR2032 / 3 volts.
B attery replacement is signalled by the display
o
f a message.
F
U
nclip the cover using a small screwdriver
a
t the cutout.
F
L
ift off the cover.
F
R
emove the flat battery from its location.
F
F
it the new battery into its location
observing
the original direction of fitment.
F
C
lip the cover onto the casing.
Access
Page 69 of 396

67
C4-2_en_Chap02_ouvertures_ed02-2015
Following disconnection of the vehicle battery, replacement of the remote control battery or
i
n the event of a remote control malfunction,
y
ou can no longer unlock, lock or locate your
v
ehicle.
Remember
to refit the mat below the armrest
a
fter removing the reinitialised electronic key.
Remote control problem /
reinitialisation
F Place the back-up key (integral with the r
emote control) in the lock to unlock your
v
ehicle. F
O pen the front armrest.
● R aise the mat by its tongue and remove it.
●
P
lace the electronic key on the back-up
re
ader.
F
S
witch on the ignition by pressing the
"ST
ART/STOP"
button.
The
electronic key is fully operational again.
If
the problem persists, contact a CITROËN
d
ealer or a qualified workshop as soon as
p
ossible.
2
Access
Page 73 of 396

71
C4-2_en_Chap02_ouvertures_ed02-2015
* Depending on the country of sale.
Alarm*
- exterior perimeter
The system checks for opening of the vehicle.
T he alarm is triggered if anyone tries to open a
d
oor, the boot, the bonnet...
- interior volumetric
The system checks for any variation in the volume in the passenger compartment.
The
alarm is triggered if anyone breaks a
w
indow, enters the passenger compartment or
m
oves inside the vehicle.
- tilt
The system checks for any change in the attitude of the vehicle.
The
alarm is triggered if the vehicle is lifted,
m
oved or knocked.
Self-protection function
The system checks for the putting out of service of its components.
The
alarm is triggered if the battery, the central
c
ontrol or the siren wiring are put out of service
o
r damaged. For
all work on the alarm system, c
ontact a CITROËN dealer or a
qualified w orkshop.
System
which
protects
and
provides
a
deterrent
against theft and break-ins. It provides the
f
ollowing
types
of
monitoring:
2
Access
Page 78 of 396

76
C4-2_en_Chap02_ouvertures_ed02-2015
Reinitialisation
After reconnecting the battery or a fault, you must be reinitialise the operation of the electric
w
indows. For each of the control switches on
t
he driver's side control panel:
F
p
ull the control until the window stops,
F
r
elease the control and pull it again until
t
he window closes fully,
F
c
ontinue to hold the control for
approximately
o
ne
se
cond
a
fter
t
he
w
indow
h
as closed,
F
p
ress the control to lower the window
automatically
to the low position,
F
w
hen the window has reached the low
position,
press the control again for
a
pproximately one second.
The safety anti-pinch function is not
operational during these operations.
Safety anti-pinch
When the window rises and meets an obstacle, i t stops and partially lowers again.
If
the window cannot be closed (for
e
xample, in the presence of ice), once
t
he window has lowered:
F
p
ress and hold the control until the
window opens fully,
F
t
hen pull the control immediately
a
nd hold it until the window closes,
F
c
ontinue to hold the control for
approximately
one second after the
w
indow has closed.
The safety anti-pinch function is not
operational during these operations.
Access
Page 82 of 396

80
C4-2_en_Chap02_ouvertures_ed02-2015
Tailgate release
Unlocking
F Fold back the rear seats to gain access to t
he lock from inside the boot.
F
I
nsert a small screwdriver into hole A of the
lock
to unlock the tailgate.
F
M
ove the latch to the left.
Locking after closing
If the fault persists after closing again, the boot will remain locked.
System
allowing
the
mechanical
unlocking
o
f the boot in the event of a battery or central
locking
system
malfunction.
Access
Page 100 of 396

98
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
9. "REST" function: ventilation with the engine off
Even with the engine is off, you c
an operate the ventilation for a
few minutes.
8. Air intake / Air recirculation
F Press this button for recirculation of the interior
air.
The indicator lamp in the
b
utton comes on.
Air
recirculation enables the passenger
c
ompartment to be isolated from exterior
o
dours
and
smoke.
F
A
s soon as possible, press this button
again
to permit the intake of outside air and
p
revent
the formation of condensation. The
i
ndicator lamp in the button goes off.
Avoid
prolonged operation in interior air
r
ecirculation mode (risk of misting and
d
eterioration of air quality). For
example, while you are away from the
v
ehicle, the passengers can still enjoy some air
c
irculation without having the engine running.
This
function is available after switching on the
i
gnition, as well as after stopping the engine.
The period that the function is available
depends
on the state of charge of the battery.
You can activate the "REST" function while the
air
conditioning control screens are on.On switching on the engine
-
T he control screens come on: the function
i
s available.
-
P
ressing the REST button activates the
ventilation
for a few minutes. Activation of
t
he function is confirmed by the display of
t
wo dashes in the control screens and four
air
flow level indicator lamps.
-
T
he function can be deactivated and
reactivated
if the control screens are on.
-
T
he screens go off at the end of this
p
eriod.
Ease of use and comfort
Page 109 of 396

107
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
Panoramic sunroof
Electric blind
Opening
Turn the dial to the left (four possible settings).
Closing
Return the dial to the initial position.
Safety anti-pinch
If the blind encounters an obstacle during c
losing, it stops and partially opens again.
If
the blind fails to close at a second attempt,
i
t may be necessary to force the closing of the
b
lind using the reinitialisation procedure.
The blind is controlled electrically by a rotary
dial.
Reinitialising the system
Following reconnection of the battery, or in the e
vent of a malfunction in its operation, it may
b
e necessary to reinitialise the system:
F
t
urn the dial to the fully closed position,
F
t
hen immediately press the dial, closing
s
tarts after about 10 seconds,
F
m
aintain pressure on the dial until the blind
h
as fully closed.
The anti-pinch function is inoperative
during these operations.
If
the
position
of
the
blind
does
not
agree
with
t
he position indicated by the dial, press the dial
to
open
the
blind
to
this
position. In
the event of contact during operation
o
f the blind, you must reverse its
m
ovement. To do this, turn the dial.
When the driver operates the dial, they
must
ensure that nothing prevents the
b
lind from closing correctly.
The
driver must ensure that the
p
assengers use the blind correctly.
Be
aware of children during operation
o
f the blind.
Your
vehicle
is
fitted
with
a
tinted
glass
panoramic
sunroof
which
increases
the
light
and
visibility
in
the
p
assenger
compartment.
Its
electric
blind
helps
control
the
temperature
in
the
passenger
compartment.
3
Ease of use and comfort
Page 122 of 396

120
C4-2_en_Chap03_ergonomie-et-confort_ed02-2015
F To connect a 12 V accessory (max power: 1
20 W), remove the cap and connect an
a
ppropriate
a
daptor.
F
T
urn the key to the ignition on position.
12 V accessory socket
This is a removable lamp, fitted in the boot wall, which can be used to light the boot or as
a
torch.
For
information on the boot lamp, refer to the
c
orresponding
s
ection.
To r c h
Operation
This torch operates with NiMH type
rechargeable batteries.
It
has a battery life of approximately 45 minutes
a
nd charges while you are driving.
Observe
the polarities when fitting the
r
echargeable
b
atteries.
Never
r
eplace
t
he
r
echargeable
b
atteries
w
ith normal disposable batteries.
Ease of use and comfort
Page 129 of 396

127
C4-2_en_Chap04_eclairage-et-visibilite_ed02-2015
In good or rainy weather, by both day and night, the front foglamps and the
r
ear foglamps are prohibited. In these
s
ituations, the power of their beams
m
ay dazzle other drivers. They should
o
nly be used in fog or falling snow.
In these weather conditions, you should
switch
on the foglamps and dipped
b
eam headlamps manually, as the
s
unshine sensor may detect sufficient
l
ight.
Do
not forget to switch off the front and
r
ear foglamps when they are no longer
n
ecessary.Switching off the lighting when
switching off the ignition
When the ignition is switched off, all of the lamps switch off immediately, except for t
he dipped beam headlamps if automatic
g
uide-me-home lighting is activated.
Switching on the lighting
when switching on the
ignition
To reactivate the lighting control stalk, turn the ring A to position "0" - lighting
o
ff, then to the position of your choice.
When
the driver's door is opened, a
t
emporary audible signal warns you that
t
he vehicle's lighting is on.
They
switch off automatically after a
p
eriod which depends on the state of
charge
of the battery (entry to energy
ec
onomy
mo
de).
4
Lighting and visibility
Page 170 of 396

168
C4-2_en_Chap06_conduite_ed02-2015
It has 3 positions:
- position 1 (Stop):
insert and removing
t
he key,
-
position 2 (Ignition on) :
steering column
u
nlocked, ignition on, Diesel preheating,
e
ngine
r
unning,
-
position 3 (Starting) .
Ignition on position
It allows the use of the vehicle's electric e
quipment or portable devices to be charged.
Once
the state of charge of the battery drops
t
o the reserve level, the system switches to
e
nergy economy mode: the power supply is
c
ut off automatically to preserve the remaining
b
attery charge.
Starting / Switching off the engine with the key
Ignition switch
Avoid attaching heavy objects to the key or the remote control, which would
w
eigh down on its blade in the ignition
s
witch and could cause a malfunction.
It
could adversely affect the deployment
o
f the front airbag.
Switching
off the engine leads to a loss
o
f braking assistance.
Anti-theft protection
Electronic engine immobiliser
Keep safely, away from your vehicle, the label attached to the keys given to
y
ou on acquisition of the vehicle.
The
keys contain an electronic chip which has
a
special code. When the ignition is switched
o
n,
this code must be recognised for engine
s
tarting to be authorised.
This
electronic engine immobiliser locks the
e
ngine management system a few minutes
a
fter
the ignition is switched off and prevents
s
tarting of the engine by anyone who does not
h
ave
the key.
In the event of a fault, you are
informed by illumination of this
w
arning lamp, an audible signal
a
nd/or the display of a message,
d
epending
o
n
v
ersion.
In
this
case, your vehicle will not start; contact
a
CITROËN dealer as soon as possible.
Driving