driver seat adjustment Citroen C5 2008.5 (RD/TD) / 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2008.5, Model line: C5, Model: Citroen C5 2008.5 (RD/TD) / 2.GPages: 306, PDF Size: 18.9 MB
Page 40 of 306
58
3
C O M F O R T
This function provides the driver with a back massage. It only operates when the engine is running.
Press on button A .
The warning lamp comes on and the massage function is activated for a period of 1 hour. During this time, massage is performed in cycles of 6 minutes (4 minutes of massage fol-lowed by 2 minutes break). In total, the system will perform 10 cycles.
After 1 hour, the function is deacti-vated. The warning lamp goes out.
Massage function The Welcome function The welcome function assists entry
and leaving the vehicle.
After switching off the ignition and
opening the driver’s door, the seat
moves back automatically and then
stays in this position, ready for the
n e x t e n t r y t o t h e v e h i c l e .
When switching on the ignition, the
seat moves forward to the memo-
rised driving position.
When moving the seat, take care
that no person or object hinders the
automatic movement of the seat.
This function is deactivated by de-
fault. You may activate or deactivate
this function using the "Main Menu"
on the instrument panel screen. To
do so, select "Vehicle parameters/
Comfort/Driver welcome".
Deactivation
You can deactivate the massage function at any time by pressing on button A .
Head restraint height and
angle adjustments on electric
seats
To adjust the angle of the head
restraint, push back or pull for-
ward section C of the head
restraint until you reach the
desired position.
To raise it, pull upwards.
To lower it, press on the
control D to unlock it, and simul-
taneously on the head restraint
itself.
To remove it, press on the
control D to unlock it, then pull it
upwards.
Page 41 of 306
59
3
C O M F O R T
Storing driving positions
System which takes into account the
s e t t i n g s o f t h e d r i v e r ' s s e a t , e x t e r i o r
mirrors and air conditioning. It ena-
bles you to store up to two positions
using the buttons on the side of the
driver's seat. Storing a position
Using buttons M/1/2
Switch on the ignition.
A d j u s t y o u r s e a t a n d y o u r e x t e -
rior mirrors.
Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal is heard in- dicating that the settings have
been stored.
Storing a new position cancels the
previous position.
Recalling a stored position
Ignition on or engine running
B r i e fl y p r e s s b u t t o n 1 or 2 to re-
call the corresponding position.
An audible signal is heard indicating
the end of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery. For your safety, avoid storing a
driving position while driving.
REAR HEAD RESTRAINTS
The rear head restraints can be
removed and have two positions;
- high, position for use,
- low, storage position.
To raise a head restraint, pull it
upwards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high
position, push the lug and pull it
upwards.
T o r e fi t i t , e n g a g e t h e h e a d r e s t r a i n t
rods in the holes taking care to
remain in the centreline of the seat
back.
Never drive with the head restraints
removed, they must be in place
and correctly adjusted.
Page 42 of 306
59
3
C O M F O R T
Storing driving positions
System which takes into account the
s e t t i n g s o f t h e d r i v e r ' s s e a t , e x t e r i o r
mirrors and air conditioning. It ena-
bles you to store up to two positions
using the buttons on the side of the
driver's seat. Storing a position
Using buttons M/1/2
Switch on the ignition.
A d j u s t y o u r s e a t a n d y o u r e x t e -
rior mirrors.
Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal is heard in- dicating that the settings have
been stored.
Storing a new position cancels the
previous position.
Recalling a stored position
Ignition on or engine running
B r i e fl y p r e s s b u t t o n 1 or 2 to re-
call the corresponding position.
An audible signal is heard indicating
the end of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery. For your safety, avoid storing a
driving position while driving.
REAR HEAD RESTRAINTS
The rear head restraints can be
removed and have two positions;
- high, position for use,
- low, storage position.
To raise a head restraint, pull it
upwards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high
position, push the lug and pull it
upwards.
T o r e fi t i t , e n g a g e t h e h e a d r e s t r a i n t
rods in the holes taking care to
remain in the centreline of the seat
back.
Never drive with the head restraints
removed, they must be in place
and correctly adjusted.
Page 46 of 306
63
3
C O M F O R T
As a safety precaution, it is impera-
tive that these operations are carried
out while the vehicle is stationary.
STEERING WHEEL ADJUSTMENT
The height and depth of the steer-
ing wheel can be adjusted to adapt
the driving position to the size of the
driver.
Adjustment
First, adjust the driver's seat to
the most suitable position.
When stationary, pull the con-
trol A to unlock the steering
wheel.
Adjust the height and depth.
Push the control to lock the
steering wheel.
A f t e r l o c k i n g , i f y o u p r e s s fi r m l y o n
the steering wheel, a slight click may
be heard.
Page 87 of 306
96
6
L A Y O U T
MATS
Removing
Slide the seat back as far as pos-
sible,
u n c l i p t h e fi x i n g s ,
r e m o v e t h e fi x i n g s , t h e n t h e m a t .
R e fi t t i n g
Position the mat correctly,
c l i p t h e fi x i n g s ,
check that the mat is held is
place correctly. To avoid any interference with the
pedals:
- only use mats which are suit-
a b l e f o r t h e fi x i n g s a l r e a d y
present in the vehicle. The use
o f t h e s e fi x i n g s i s e s s e n t i a l ,
- n e v e r fi t m o r e t h a n 1 m a t .
The use of a mat not approved by
CITROËN may obstruct access to
the pedals and hinder the cruise
control/speed limiter function.
Floor mats approved by CITROËN
a r e fi t t e d w i t h a 3 r d fi x i n g l o c a t e d i n
the pedal area to avoid any risk of
interference with the pedals.
FRONT ARMREST
Comfort and storage system for the
driver and front passenger. Adjustment
To optimise your driving position:
lift the control A ,
push the armrest forwards.
The armrest returns to its initial posi-
tion when you push it rearwards.
Lift the armrest to access the cup
holder.
Equipment available for the driver
and front passenger.
Cup-holder
Page 90 of 306
96
6
L A Y O U T
MATS
Removing
Slide the seat back as far as pos-
sible,
u n c l i p t h e fi x i n g s ,
r e m o v e t h e fi x i n g s , t h e n t h e m a t .
R e fi t t i n g
Position the mat correctly,
c l i p t h e fi x i n g s ,
check that the mat is held is
place correctly. To avoid any interference with the
pedals:
- only use mats which are suit-
a b l e f o r t h e fi x i n g s a l r e a d y
present in the vehicle. The use
o f t h e s e fi x i n g s i s e s s e n t i a l ,
- n e v e r fi t m o r e t h a n 1 m a t .
The use of a mat not approved by
CITROËN may obstruct access to
the pedals and hinder the cruise
control/speed limiter function.
Floor mats approved by CITROËN
a r e fi t t e d w i t h a 3 r d fi x i n g l o c a t e d i n
the pedal area to avoid any risk of
interference with the pedals.
FRONT ARMREST
Comfort and storage system for the
driver and front passenger. Adjustment
To optimise your driving position:
lift the control A ,
push the armrest forwards.
The armrest returns to its initial posi-
tion when you push it rearwards.
Lift the armrest to access the cup
holder.
Equipment available for the driver
and front passenger.
Cup-holder
Page 91 of 306
96
6
L A Y O U T
MATS
Removing
Slide the seat back as far as pos-
sible,
u n c l i p t h e fi x i n g s ,
r e m o v e t h e fi x i n g s , t h e n t h e m a t .
R e fi t t i n g
Position the mat correctly,
c l i p t h e fi x i n g s ,
check that the mat is held is
place correctly. To avoid any interference with the
pedals:
- only use mats which are suit-
a b l e f o r t h e fi x i n g s a l r e a d y
present in the vehicle. The use
o f t h e s e fi x i n g s i s e s s e n t i a l ,
- n e v e r fi t m o r e t h a n 1 m a t .
The use of a mat not approved by
CITROËN may obstruct access to
the pedals and hinder the cruise
control/speed limiter function.
Floor mats approved by CITROËN
a r e fi t t e d w i t h a 3 r d fi x i n g l o c a t e d i n
the pedal area to avoid any risk of
interference with the pedals.
FRONT ARMREST
Comfort and storage system for the
driver and front passenger. Adjustment
To optimise your driving position:
lift the control A ,
push the armrest forwards.
The armrest returns to its initial posi-
tion when you push it rearwards.
Lift the armrest to access the cup
holder.
Equipment available for the driver
and front passenger.
Cup-holder
Page 182 of 306
179
11
P R A C T I C A L I N F O R M A T I O N
FUSEBOX A Table of fuses
Fuse N° Rating
Function
G29 - -
G30 5 A Heated rear view mirrors
G31 5 A Rain and brightness sensor
G32 5 A Seat belt not fastened warning lamps
G33 5 A Electrochrome rear view mirrors
G34 20 A Sunroof (saloon)
G35 5 A Passenger door lighting - passenger rear view mirror adjustment
G36 30 A Electric tailgate (tourer)
G37 20 A Heated front seats
G38 30 A Driver’s electric seat
G39 30 A P a s s e n g e r ’ s e l e c t r i c s e a t - H I F I a m p l i fi e r
G40 3 A Trailer relay unit supply
FUSEBOX B
Fuse N° Rating
Function
G36
15 A 6 s p e e d a u t o m a t i c g e a r b o x
5 A 4 s p e e d a u t o m a t i c g e a r b o x
G37 10 A Daytime-running lamps - Diagnostic socket
G38 3 A ESP
G39 10 A Hydraulic suspension
G40 3 A STOP switch
Page 183 of 306
180
11
P R A C T I C A L I N F O R M A T I O N
FUSEBOX C
Fuse N° Rating
Function
F1 15 A Rear screen wipe (Tourer)
F2 30 A Locking and deadlocking relay
F3 5 A Airbags
F4 10 A A u t o m a t i c g e a r b o x - a d d i t i o n a l h e a t e r u n i t ( D i e s e l ) - e l e c t r o c h r o m e r e a r v i e w m i r r o r s
F5 30 A Front window - sun roof - passenger door lighting - passeng er rear view mirror adjustment
F6 30 A Rear window
F7 5 A V a n i t y m i r r o r l i g h t i n g - G l o v e b o x l i g h t i n g - i n t e r i o r l a m p s - t o r c h ( t o u r e r )
F8 20 A R a d i o - C D c h a n g e r - C o n t r o l s a t t h e s t e e r i n g w h e e l - D i s p l a
y - D e fl a t i o n d e t e c t i o n - E l e c t r i c
boot ECU
F9 30 A Cigar-lighter - front 12 V socket
F10 15 A Alarm - Controls on the steering wheel, signalling and scre en wipe controls
F11 15 A Low current ignition switch
F12 15 A Driver’s electric seat - instrument panel - seat belt not fasten
ed warning lamps -air
conditioning controls
F13 5 A Engine relay unit - Hydraulic suspension pump cut-off relay - a irbag ECU supply
F14 15 A Rain and brightness sensor - parking assistance - passenger’s electri
c seat - trailer relay
u n i t - H I F I a m p l i fi e r E C U - H a n d s - f r e e k i t - L a n e D e p a r t u r e W a r n i n g S y s t e m
F15 30 A Locking and deadlocking relay
F17 40 A H e a t e d r e a r s c r e e n - e x t e r i o r h e a t e d r e a r v i e w m i r r o r s
FSH SHUNT PARK SHUNT