ECO mode Citroen C5 2008 (RD/TD) / 2.G Owner's Manual

I
10
IN BRIEF
D A S H B O A R D
Audio
Instrument panel menuMultifunction display menu
Telephone
Cruise control and Speed limiter
42
The “SET +, PAUSE, VOL+, MUTEThe “The “” buttons are located so that you can use them without needing to take your eyes off the road.
Activation of voice recognition or reminder of navigation guidance
MODE: selection of the type of information displayed on multifunction screen.

I
14
IN BRIEF
Automatic air conditioning
Adjustment of air distribution on driver's side
Passenger's side automatic operation
Adjustment of temperature on driver's side
Adjustment of air distribution on passenger's side
Rear and external rear view mirrors demisting - deicingAir recirculation - Entry of air from outside
Front demisting - deicing
Driver's side automatic operation
Note: It is recommended to use automatic mode by pressing on the “AUTOIt is recommended to use automatic mode by pressing on the “It is recommended to use automatic mode by pressing on the “” button.
V E N T I L A T I O N
Adjustment of temperature on passenger's side
Activation/deactivation of air conditioning
Adjusting the air fl ow
97

27
II
S T E E R I N G L O C K - I G N I T I O N - S T A R T E R
NEVER REMOVE THE IGNITION KEY BEFORE THE ENGINE HAS COME TO A COMPLETE STOP.
IT IS ESSENTIAL ALWAYS TO DRIVE WITH THE ENGINE RUNNING, SO AS TO RETAIN STEERING AND BRAKING ASSISTANCE (risk of the steering lock engaging and loss of safety features).
When stationary, having removed the key, carefully turn the steering wheel if you wish to lock the steering.
S: Steering lock
To unlock the steering, gently move the steering wheel while turning the key, without exerting undue force.
When you remove the key, turn your steering wheel to lock the steering. The key can only be removed when in position S.
Economy mode
When the engine is stopped, some functions (audio system, screen wipe, electric windows, sunroof, electric seats, telephone, video, interior lighting etc.) are only electrically supplied for a maximum period of 30 minutes, to avoid discharging the battery.
Once this period is over, a message is displayed on the instrument panel screen and the active functions are placed on standby.
The electrical components relating to comfort and also the headlamps (not sidelamps or hazard warning lamps) cut out automatically. To reactivate them, it is necessary to start the engine.
M: Drive position
The steering is unlocked (by turn-ing the key in position M, if neces-sary move the steering wheel).
D: Starting
Release the key as soon as the engine starts. Never turn it while the engine is running.

100
III81a2a3a4a858684b4b4b81b1b3b3b2b2b
978
AA
A U T O M A T I C A I R C O N D I T I O N I N G
D U A L - Z O N E
1a Driver's side automatic opera-tion
1b Passenger's side automatic operation
2a Adjustment of temperature on driver's side
2b Adjustment of temperature on passenger's side
3a Adjustment of air distribution on driver's side
3b Adjustment of air distribution on passenger's side
4a Driver's side display
4b Passenger's side display
5 Adjusting the air fl ow
6 Activation/deactivation of air conditioning
7 Air recirculation – Entry of air from outside
8 Rear demisting - deicing
9 Front demisting - deicing
This is the normal oper-ating mode for the sys-tem. Depending on the level of comfort chosen, a press on this button, confi rmed by light Acoming on, allows all of the follow-ing functions to be automatically and simultaneously controlled:
Air fl ow.
Cabin temperature.
Air distribution.
Air conditioning.
Automatic air recirculation.
It is recommended to keep all the air vents open. Just by press-ing any of the buttons, except for temperature 1a and 1b, you can change to manual mode. The light A goes out.

103
III2
5
1
3
4
6
7
8
9
With the engine off, programmable heating preheats the coolant cir-cuit in order to optimise the engine operating temperature prior to starting.
The programmable heating sys-tem can be started immediately or delayed thanks to its programming function.
Digital programmer
The heating system’s programmer is located on the right-hand side of the dashboard.
1. Time or remaining functioning time.
2. Increase (time).
3. Select programme.
4. Programme number selected.
5. Immediate start-up of heating.
6. Time adjustment and reading warning lamp.
7. Reduce (time).
8. Heating mode warning lamp.
9 Programmable heating system warning lamp.
LED lit : Activated.
LED off : Deactivated.


P R O G R A M M A B L E H E A T I N G
( D E P E N D I N G O N C O U N T R Y )
Immediate start-up
Press button 5.
The screen displays a default duration of 60 minutes, you are advised to adjust this to a duration of 30 minutes maximum (see section “ adjusting the operating duration ”). The warning lamp 8 lights up and remains lit for the whole duration of the system’s operation. The duration of the system’s operation disappears after 10 seconds.
Stopping the heating
Press button 5.
The warning lamp 8 and the screen go out.
With the engine idle or the vehicle stationary, it is nor-mal to hear a high-pitched whistling noise and to notice some smoke / emis-sions.

104
III
3
2
6
7
2
3A7
Delayed start-up
Note : Before programming the delayed start-up of the heating, you must ensure that the clock is set to the correct time.
P R O G R A M M A B L E H E A T I N G
Programming the start-up time
Start-up may be programmed between 1 minute and 24 hours in advance.
You can store up to 3 different start-up times, but programme only 1 delayed start-up time.
Factory settings A :
Time 1 : 06:00.
Time 2 : 16:00.
Time 3 : 22:00.
Note : The factory settings are replaced once you adjust them. The programmed times are stored until they are re-programmed.



Press button 3 then buttons 2 or 7 in the next 10 seconds, until the desired start-up time is displayed.
Note : In the event of a battery failure, the factory settings are restored.
Note : if you wish to recall the other stored times, press several times on button 3 in the next 10 seconds until the desired programme number is displayed.
Cancelling the programmed time
To cancel the programmed start-up time, press briefl y on button 3.
Setting the time
Hold button 3 down and press but-ton 2 or button 7. Release button 3, the time is displayed and symbol 6fl ashes.
Use the two adjustment buttons 2(to go forward) or 7 (to go back) until the correct time is displayed.
Holding these buttons down will make the numbers displayed scroll more quickly.
Reading the time
Press button 2 or button 7 to dis-play the time.
When the heating mode is acti-vated, the remaining operating time is displayed in place of the time.

105
III
34
2
3
8
76
Selection and activation of a programmed time
Press button 3 until the programme number corresponding to the required programmed time is dis-played. The chosen pre-selected time is automatically activated after 10 seconds if no other but-tons have been pressed.
To confi rm that the mode is acti-vated, symbols 4 and 8 fl ash until the heating starts up.
When the heating starts up, the warning lamp 9 lights up on the dashboard and the programmer screen.
P R O G R A M M A B L E H E A T I N G
Adjusting the operating durationPress button 3 and hold it down. Press button 2 or 7 at the same time. Release button 3. The time and symbol 6 are displayed.Press again on button 3 and hold it down. Press button 2 or 7 at the same time. Release button 3. The operating duration and symbol 8 is displayed.Adjust the operating duration with button 2 or 7.
Note : The operating duration is memorised when the time indicated disappears or by pressing button 3.
Adjusting the remaining operating duration
When heating mode is activated, the remaining operating time can be modifi ed within the range of 10 to 60 minutes using buttons 2 or 7.
Note :The pre-selected start-up time can be modifi ed or cancelled by following the instructions previ-ously given above.
In the event of a battery discon-nection, the programmer must be re-set (hours, minutes etc.)


Always switch off the additional heating when filling up with fuel, to prevent any risk of fi re or explosion.
To avoid any risk of intoxica-tion or asphyxiation, the addi-tional heating must not be used, even for short periods, in an enclosed area such as a garage or workshop not equipped with a system for the extraction of exhaust gases.
Do not park the vehicle over infl ammable materials (e.g. dry grass, dead leaves or paper) as this could present a fi re risk.
The programmable heating sys-tem is supplied by the vehicle’s fuel tank. Before use, ensure that the remaining fuel level is suffi cient. If you are using the reserve fuel tank, we strongly advise you not to use the pro-grammable heating system.

143
IV
F R E Q U E N T L Y - A S K E D Q U E S T I O N S
QUESTIONANSWERSOLUTION
Traffi c Announcements (TA) is displayed. I do not receive any traffi c informa-tion or public announce-ments.
The particular radio station is not in the regional traffi c information network.Change to a radio station that does broadcast traffi c information.
The reception quality of the radio station being lis-tened to gradually deterio-rates.
The vehicle is too distant from the transmit-ter, or no transmitter is present in the geo-graphical area you are passing through.
Activate the RDS function to allow the system to check whether a more pow-erful transmitter is to be found in the geographical area.
The environment (hills, high buildings, tun-nels, underground car parks, etc.) is blocking reception, even in RDS mode.
This phenomenon is normal and does not imply anything wrong with the radio.
The aerial is absent or has been damaged (for example after going through a car wash or in an underground car park).
Have the aerial checked by a CITROËN dealer.
Cutting out of sound for 1 to 2 seconds in radio mode.
The RDS system during this brief sound cut-off is searching for a better frequency that might offer improved reception of the station.
Deactivate the RDS function if the phe-nomenon occurs too frequently and always on the same journey.
When the engine is not running, the radio stops after a few minutes.
When the engine is switched off, the work-ing time for the radio depends on the battery charge. The interruption is normal: the radio goes into economy mode, cutting off in order to save the vehicle’s battery.
You have to start the engine so as to increase the battery charge.
The message “the audio system is overheating” appears on the screen.
In order to protect the audio equipment in excessive ambient temperatures, the radio goes into an automatic thermic protection mode which results in a reduction in sound volume or stopping of the CD player.
Switch off the audio system for a few minutes in order to allow the system to cool down.

353535
IV
THE PROGRAMME TYPE MODE “PTY”
Cer t ain st ations allow you to choose to listen to a par ticular t ype of programme selected from the available list, for example as below:Information.Current affairs.Info-Services.Sport.Education.Fiction.Culture.Sciences.Entertainment.Pop music.Rock music.Folk music.Light classical.Classical music.Other music.Weather.Economy.Children.Social affairs.Religion.Line open.Travel.Leisure.Jazz.Country.Folk singing.Golden oldies.Traditional.Documentary.

555555
IX
F R E Q U E N T LY - A S K E D Q U E S T I O N S
QUESTIONSANSWERSSOLUTIONS
The rec eption qualit y of the radio station being listened to gradually deteriorates.
The vehicle is too distant from the transmitter, or no transmitter is present in the geographical area you are passing th rough.
Activate the RDS function to allow the system to chec k whether a more power ful transmitter is to be found in the geographical area.
The environment (hills, high buildings, tunnels, underground car parks, etc.) is blocking reception, even in RDS mode.This phenomenon is normal and does not imply anythi ng wrong with the radio.
The aerial is absent or has been damaged (for example after going through a car wash or in an underground car park).Have the aerial checked by a CITROËN dealer.
When the engine is not running, the radio stops after a few minutes.
When the engine is switched off, the working time fo r the radio depends on the batter y charge. The interruption is nor mal: the radio goes into economy mode, cutting off in order to save the vehicle’s batter y.
You have to star t the engine so as to increase the bat-ter y charge.
T h e m e s s a g e “ t h e a u d i o s y s t e m i s o v e r h e a t i n g ” a p p e a r s o n t h e screen.
In order to protect the audio equipment in excessiv e ambient temperatures, the radio goes into an automatic thermic protection mode which results in a reduction in sound volume or stopping of the CD player.
Switch off the audio system for a few minutes in order to allow the system to cool down.
Why is one not informed in real time of a hold-up on the route even though the option for guidance by “traffi c info” is activated ?
When you star t up, the system takes a few minutes to c apture the traf fi c information via RDS-TMC.Wait for the traf fi c information to be safely received (pictogrammes displayed on the map) and make sure that you use the major ar terial roads to have “inform ed” navigation.
Only the major ar terial roads (motor ways and some d ual car-riageways) are featured in RDS-TMC traf fi c information).
It may happen that a hold-up is not repor ted by the tr af fi c info provider.
Why is a diversion not suggested when I have selected traf fi c info ?
Do not confuse the “traf fi c info” guidance option which can sug-gest a diversion (the “diver t” button appears in the w indow) with the menus “Display of traf fi c messages” or “Reading of traf fi c messages” which af fect only the display without recalculating the itinerar y (no “diver t” button in the window).
To have “informed” navigation with the detour proposi-tion, it is essential to activate the guidance option with “traf fi c info”.