CITROEN DISPATCH SPACETOURER 2018 Handbook (in English)
Manufacturer: CITROEN, Model Year: 2018, Model line: DISPATCH SPACETOURER, Model: CITROEN DISPATCH SPACETOURER 2018Pages: 400, PDF Size: 16.99 MB
Page 21 of 400

19
Warning/indicator lampStateCause Action/Observations
Foot on the 
brake Fixed.
The brake pedal must be 
depressed. With an automatic or electronic gearbox, depress the 
brake pedal, engine running, before releasing the 
parking brake, to release the selector lever and come 
out of position P or N
.
If you wish to release the parking brake without 
depressing the brake pedal, this warning lamp will 
remain on.
Foot on the 
clutch Fixed.
In STOP mode of Stop & Start, 
the transition to START mode has 
been rejected because the clutch 
pedal is not fully pressed down. With a manual gearbox, you must fully depress the 
clutch pedal to allow the change to engine START 
mode.
Anti-lock 
Braking System 
(ABS) Fixed.
The anti-lock braking system has 
a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a 
CITROËN dealer or a qualified workshop without 
d e l ay.
Collision Risk 
Alert/Active 
Safety Brake Flashing.
The system is operating. The system brakes briefly so as to reduce the speed of 
collision with the vehicle ahead.
Fixed, accompanied 
by a message and an 
audible signal. The system has a fault.
Have the system checked by a CITROËN dealer or a 
qualified workshop.
Fixed, accompanied 
by a message. The system has been deactivated 
(via the menu). For more information on the Collision Risk 
Aler t /Active Safety Brake system, refer to the 
corresponding section.
1 
Instruments  
Page 22 of 400

20
Warning/indicator lampStateCause Action/Observations
Par ticle filter 
(Diesel) Fixed, accompanied 
by an audible signal 
and a message about 
the risk of particle filter 
blockage. This indicates that the particle 
filter is beginning to saturate.
Traffic conditions permitting, regenerate the filter by 
driving at a speed of at least 37
  mph (60   km/h) until 
the warning lamp goes off.
Fixed, accompanied 
by an audible signal 
and a message about 
the particle filter’s 
additive level being 
too low. This indicates that the level in the 
additive tank is low.
Quickly arrange for a top-up by a CITROËN dealer or 
by a qualified workshop.
Airbags Temporarily on. This warning lamp comes on for 
a few seconds when you turn on 
the ignition, then goes off.
This warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified 
workshop.
Fixed.One of the airbag or seat belt 
pyrotechnic pretensioner systems 
has a fault. Have it checked by a CITROËN dealer or a qualified 
workshop.
Passenger front 
airbag Fixed, in the seat belt 
and passenger front 
airbag warning lamps 
display. The control switch, located at the 
passenger end of the dashboard, 
is set to the OFF position.
The passenger front airbag is 
deactivated.
You can install a "rearward 
facing" child seat, unless there 
is a fault with the airbags (airbag 
warning lamp on). Turn the control switch to the ON position to activate 
the passenger front airbag; in this case, you must not 
install a child seat in the rear ward facing position on 
this seat. 
Instruments  
Page 23 of 400

21
Warning/indicator lampStateCause Action/Observations
Passenger 
airbag system Fixed.
The control switch, located 
at the passenger end of the 
dashboard, is at the ON position. 
The passenger front airbag is 
activated.
In this case, do not install a 
rear ward facing child seat on the 
front seat. Move the control switch to the OFF position to 
deactivate the passenger front airbag.
You can install a rear ward facing child seat, unless 
there is a fault with the airbags (airbag warning lamp 
o n).
Dynamic stability 
control (DSC/
ASR) Fixed.
The button is pressed and the 
indicator lamp comes on.
The DSC/ASR is deactivated.
DSC: dynamic stability control.
ASR: anti-slip regulation. Press the button to activate the DSC/ASR.
The DSC/ASR system is activated automatically when 
the vehicle is started.
If the system is deactivated, it is reactivated 
automatically once a speed of around 30
  mph 
(50
  km/h) is reached.
For more information on the Electronic stability 
control (ESC) and in particular, DSC/ASR, refer to the 
corresponding section.
Dynamic stability 
control (DSC/
ASR) Flashing.
The DSC/ASR regulation is 
operating. The system optimises traction and allows improved 
directional stability of the vehicle.
Fixed. Unless deactivated, the DSC/
ASR system has a fault. Have it checked by a CITROËN dealer or a qualified 
workshop.
Power steering Fixed. The power steering has a fault. Drive carefully at reduced speed.
Have it checked by a CITROËN dealer or a qualified 
workshop.
1 
Instruments  
Page 24 of 400

22
Warning/indicator lampStateCause Action/Observations
AdBlue
®
(BlueHDi Diesel) Fixed, on switching 
on the ignition, 
accompanied by an 
audible signal and a 
message indicating 
the remaining driving 
range. The remaining driving range is 
between 375
  miles (600   km) and 
1,500   miles (2,400   km).Have the AdBlue
® tank topped up as soon as possible: 
go to a CITROËN dealer or a qualified workshop, or 
carry out this operation yourself.
Flashing, associated 
with the SERVICE 
warning lamp, 
accompanied by an 
audible signal and a 
message indicating 
the remaining driving 
range. The remaining driving range 
is between 0
 
and 375
 
miles 
(6 0 0
 
k m). You must top up the
 AdBlue
® tank to avoid a 
breakdown : go to a CITROËN dealer or a qualified 
workshop, or carry out this operation yourself.
Flashing, 
accompanied by an 
audible signal and a 
message indicating 
that starting is 
prevented. The AdBlue
® tank is empty: the 
starting inhibition system required 
by legislation prevents starting of 
the engine. To be able to start the engine, you must top up the
 
AdBlue® tank: go to a CITROËN dealer or a qualified 
workshop, or carry out this operation yourself.
It is essential  to add at least 4
  litres of AdBlue
® to the 
fluid tank. 
Instruments  
Page 25 of 400

23
Warning/indicator lampStateCause Action/Observations
SCR emissions 
control system
(BlueHDi Diesel) Fixed, on switching 
on the ignition, 
associated with the 
Service and engine 
diagnostic warning 
lamps, accompanied 
by an audible signal 
and a message. A fault with the SCR emissions 
control system has been 
detected.
This alert disappears once the exhaust emissions 
return to normal levels.
Flashing, on switching 
on the ignition, 
associated with 
the Ser vice and 
engine diagnostic 
warning lamps, 
accompanied by an 
audible signal and a 
message indicating 
the remaining driving 
range. After confirmation of the fault with 
the emissions control system, 
you can continue driving for up to 
685
  miles (1,100   km) before the 
engine starting inhibition system 
is triggered. Contact a CITROËN dealer or a qualified workshop 
without delay
, to avoid a breakdown .
Flashing, on switching 
on the ignition, 
associated with the 
Service and engine 
diagnostic warning 
lamps, accompanied 
by an audible signal 
and a message. You have exceeded the 
authorised driving limit following 
confirmation of a fault with the 
emissions control system: the 
engine starting inhibition system 
prevents starting of the engine.
To be able to restart the engine, you must
 call on a 
CITROËN dealer or a qualified workshop.
1 
Instruments  
Page 26 of 400

24
Warning/indicator lampStateCause Action/Observations
Service Temporarily on, 
accompanied by the 
display of a message. One or more minor faults for 
which there is no specific warning 
lamp have been detected. Identify the cause of the fault using the message 
displayed in the instrument panel.
You can deal with some problems yourself, such as a 
door open or the start of saturation of the particle filter 
(as soon as the traffic conditions allow, regenerate the 
filter by driving at a speed of at least 37
  mph (60   km/h), 
until the warning lamp goes off).
For any other problems, such as a fault with the tyre 
under-inflation detection system, contact a CITROËN 
dealer or a qualified workshop.
Fixed, accompanied 
by the display of a 
message. One or more major faults for 
which there is no specific warning 
lamp have been detected. Identify the cause of the fault using the message 
displayed in the instrument panel; you must then 
contact a CITROËN dealer or a qualified workshop.
Fixed, associated with 
the flashing and then 
fixed display of the 
service spanner. The servicing interval has been 
exceeded.
Only on BlueHDi Diesel versions.
Your vehicle must be ser viced as soon as possible.
Rear foglamps Fixed. The rear foglamps have been 
switched on using the ring on the 
lighting control stalk. Turn the ring on the lighting control stalk rear wards to 
switch off the rear foglamps. 
Instruments  
Page 27 of 400

25
Warning/indicator lampStateCause Action/Observations
Automatic 
wiping Fixed.
The wiper control stalk has been 
pushed down.
Automatic front wiping is 
activated. To deactivate automatic wiping, push the wiper control 
stalk down again or put the wiper control stalk in 
another position.
Automatic 
headlamp 
dipping Fixed.
The lighting control stalk is in the 
"AUTO " position, and the function 
has been activated.
The main beam headlamps come 
on if the exterior lighting and 
driving conditions permit. The camera, located at the top of the windscreen, 
manages the operation of main beam, depending on 
the exterior lighting and driving conditions.
For more information on Automatic headlamp 
dipping
, refer to the corresponding section.
Stop & Star t Fixed. When the vehicle stops (red 
lights, traffic jams, etc.) the Stop 
& Start system has put the engine 
into STOP mode. The warning lamp goes off and the engine restarts 
automatically in START mode, as soon as you want to 
move off.
Flashes for a few 
seconds, then goes 
of f. STOP mode is temporarily 
unavailable.
or
START mode is triggered 
automatically. For more information on Stop & Star t
, refer to the 
corresponding section.
Blind spot 
monitoring Fixed.
The blind spot monitoring system 
has been activated. For more information on the Blind spot monitoring 
system, refer to the corresponding section.
1 
Instruments  
Page 28 of 400

26
Warning/indicator lampStateCause Action/Observations
Lane depar ture 
warning system Fixed.
The lane departure warning 
system has been activated. The lane departure warning system is activated.
For more information on the Lane depar ture warning 
system, refer to the corresponding section.
Front foglamps Fixed. The front foglamps are switched 
on using the ring on the lighting 
control stalk. Turn the ring on the lighting control stalk rear ward 
once to switch off the front foglamps.
Sidelamps Fixed. The lighting control stalk is in the 
"Sidelamps" position.
Left-hand 
direction 
indicator Flashing with audible 
signal.
The lighting control stalk has 
been moved down.
Right-hand 
direction 
indicator Flashing with audible 
signal.
The lighting control stalk has 
been moved up.
Dipped beam 
headlamps Fixed.
The lighting control stalk is in 
the "Dipped beam headlamps" 
position.
Main beam 
headlamps Fixed.
The lighting control stalk has 
been pulled towards you. Pull the control stalk to return to dipped beam 
headlamps.
For more information on the Lighting control stalk , refer to the " Visibility" section. 
Instruments  
Page 29 of 400

27
Indicators
Service indicator
Warning/indicator lampStateCause Actions/Observations
Service spanner Fixed, temporary when 
the ignition is switched 
on. There are between 620
  miles 
(1,000
  km) and 1,860   miles 
(3,000
  km) before the next 
service is due. The ser vice indicator is displayed for a few seconds on 
the instrument panel. Depending on version:
-
 
t
 he distance recorder display line indicates the 
distance remaining (in kilometres or miles) before 
the next ser vice is due.
-
 
a
 n alert indicates the distance remaining  
(in kilometres or miles) as well as the period before 
the next ser vice is due.
The ser vice spanner goes off after a few seconds.
The alert may be triggered close to the due date.
Fixed, when the 
ignition is switched on. Less than 620
  miles (1,000   km) 
remain before the next ser vice 
is due. The ser vice indicator is displayed for a few seconds on 
the instrument panel. Depending on version:
-
 
t
 he distance recorder display line indicates the 
distance remaining before the next ser vice is due.
-
 
a
 n alert message indicates the distance remaining 
as well as the period before the next ser vice is due.
The ser vice spanner remains on to indicate that the 
ser vice is required very soon.
The alert may be triggered close to the due date.
1 
Instruments  
Page 30 of 400

28
Warning/indicator lampStateCause Actions/Observations
Service spanner Flashing then fixed, 
when the ignition is 
switched on. The servicing interval has been 
exceeded.
The ser vice indicator is displayed for a few seconds on 
the instrument panel. Depending on version:
-
 
t
 he total distance recorder display line indicates the 
distance travelled since the due date was reached. 
Value preceded by the "-" sign.
-
 
a
 n alert message indicates that the due date has 
passed.
The ser vice spanner remains on until the ser vice has 
been performed.
The alert is triggered when the due date has passed.
+ Flashing then fixed, 
when the ignition 
is switched on, 
associated with the 
Service warning lamp.The servicing interval has been 
exceeded for Diesel BlueHDi 
versions.
The ser vice indicator is displayed for a few seconds on 
the instrument panel. Depending on version:
-
 
t
 he total distance recorder display line indicates the 
distance travelled since the due date was reached. 
Value preceded by the "-" sign.
-
 
a
 n alert message indicates that the due date has 
passed.
The ser vice spanner remains on until the ser vice has 
been performed.
The alert is triggered when the due date has passed.
The distance indicated (in kilometres or miles) is calculated according to the mileage covered and the time elapsed since the last ser vice. 
Instruments