HEATING AND VENTILATION SYSTEM 7A–29
DAEWOO M-150 BL2
SPECIFICATIONS
GENERAL SPECIFICATIONS
Application Unit Description
Maximum Heating Capacity cal/h 7,300
1 st Ω 2.25 – 2.75
2 nd Ω 1.08 – 1.32
Blower Motor Resistance 3 rd Ω 0.36 – 0.44
4 th Ω –
FASTENER TIGHTENING SPECIFICATIONS
Application Nm Lb-Ft Lb-In
Heater Module Nuts3 – 5–27 – 44
Blower Module Nuts3 – 5–27 – 44
7B–18 MANUAL CONTROL HEATING, VENTILATION, AND AIR CONDITIONING SYSTEM
DAEWOO M-150 BL2
D108B501
A/C PUSH KNOB
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Remove the instrument cluster housing trim panel.
Refer to Section 9E, Instrumentation/Driver Informa-
tion.
2. Remove the A/C push knob.
Disconnect the temperature control cable from the
heater module (1).
Disconnect the mode control cable from the heater
module (2).
D108B502
Remove the control assembly retaining screws (3).
Pull out the control assembly.
Remove the A/C push knob by pushing the knob
lock (4).
Disconnect the A/C push knob electrical connector
(5).
D108A506
Installation Procedure
1. Install the A/C push knob to the control assembly.
2. Connect the A/C push knob electrical connector.
3. Install the control assembly with the screws.
4. Connect the mode control cable to the heater mod-
ule.
5. Connect the temperature control cable to the heater
module.
6. Install the instrument cluster housing trim panel. Re-
fer to Section 9E, Instrumentation / Driver Informa-
tion.
D18B503A
RECEIVER DRYER AND DUAL CUT
SWITCH
Removal Procedure
1. Recover the refrigerant. Refer to “Discharging, Add-
ing Oil, Evaculating, and Charging Procedures for
A/C System” in this section.
2. Remove the front bumper fascia. Refer to Section
9O, Bumpers and Fascias.
3. Remove the receiver dryer.
Disconnect the dual cut switch connector (1).
Remove the receiver dryer flange nuts (2).
Remove the bracket bolt (3).
Discard the O–ring (4).
