wheel bolts DAEWOO MATIZ 2003 Service Service Manual

DOORS 9P–23
DAEWOO M-150 BL2
D19C614A
Installation Procedure
Notice: Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use the correct
fastener to prevent premature corrosion.
1. Connect the body–to–tailgate rubber grommet.
2. With the aid of another technician, lightly secure the
tailgate with the bolts.
3. Adjust the tailgate for proper fit.
4. Install the tailgate strut. Refer to “Tailgate Strut” in this
section.
5. Connect the tailgate electrical connector.
6. Install the luggage compartment wheelhouse trim pan-
el. Refer to Section 9G, Interior Trim.
7. Connect the negative battery cable.
D209B113
TAILGATE LOCK CYLINDER
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the tailgate.
3. Remove the rear window wiper motor assembly. Re-
fer to Section 9D, Wipers/Washer Systems.
4. Remove the tailgate lock cylinder.

Disconnect the tailgate lock rod (1).

Remove the nuts from the tailgate lock cylinder (2).

Remove the tailgate lock cylinder (3).
D209B114
Installation Procedure
1. Install the tailgate lock cylinder.
2. Install the rear window wiper motor assembly. Refer
to Section 9D, Wipers/Washer Systems.
3. Connect the negative battery cable.
D109C615
DOOR HINGE
Removal Procedure
1. With the aid of another technician, remove the door
hinge.

Remove the hinge–to–body bolts (1).

Remove the hinge–to–door bolts (2).

Remove the door hinge (3).

BODY FRONT END 9R–11
DAEWOO M-150 BL2
D19C544A
11. Remove the bolts along the top of the fender.
a. Bolt.
12. Remove the fender.
b. Fender.
D19C527A
Installation Procedure
1. Install the fender.
Notice: Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use the correct
fasteners to prevent premature corrosion.
2. Install the bolts along the top of the fender.
D19C545A
3. Install the front bumper spacer.
4. Install the cowl vent grille.
5. Raise and suitably support the vehicle.
6. Install the bolts under the fender.
7. Install the screws on the side of the front bumper
fascia.
8. Open the front door Install the bolt on the A–pillar.
9. Install the bolt at the base of the fender.
10. Install the wheelhouse splash shield with the
screws.
11. Lower the vehicle.

9T–4 REMOTE KEYLESS ENTRY AND ANTI-THEFT SYSTEM
DAEWOO M-150 BL2
REPAIR INSTRUCTIONS
ON-VEHICLE SERVICE
D19C501A
SIREN
Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
3. Remove the front wheels.
4. Remove the front wheel house splash shield.

Remove the clip and bolts.
a. Bolts and clips.

Remove the wheel house splash shield.
b. Splash shield.

D209B106
5 Remove the siren.

Remove the screws (1).

Disconnect the electrical connector (2).
D209B107
Installation Procedure
1. Install the siren with the screws.
2. Connect the electrical connector.
3. Install the front wheel house splash shield with the
clips and the bolts.
4. Install the front wheels.
5. Lower the vehicle.
6. Connect the negative battery cable.