brakes DODGE CALIBER 2006 1.G User Guide

Towing Requirements
To promote proper break-in of your new vehicle driv-
etrain components the following guidelines are recom-
mended:
CAUTION!
²Avoid towing a trailer for the first 500 miles (805
km) of vehicle operation. Doing so may damage
your vehicle.
²During the first 500 miles (805 km) of trailer
towing, limit your speed to 50 mph (80 km/h).
Perform the maintenance listed in Section 8 of this
manual. When towing a trailer, never exceed the GAWR,
or GCWR, ratings.
WARNING!
Improper towing can lead to an injury accident.
Follow these guidelines to make your trailer towing
as safe as possible:
Make certain that the load is secured in the trailer
and will not shift during travel. When trailering
cargo that is not fully secured, dynamic load shifts
can occur that may be difficult for the driver to
control. You could lose control of your vehicle and
have an accident.
²When hauling cargo or towing a trailer, do not over-
load your vehicle or trailer. Overloading can cause a
loss of control, poor performance or damage to brakes,
axle, engine, transmission, steering, suspension, chas-
sis structure or tires.
²Safety chains must always be used between your
vehicle and trailer. Always connect the chains to the
frame or hook retainers of the vehicle hitch. Cross the
chains under the trailer tongue and allow enough
slack for turning corners.
222 STARTING AND OPERATING

Towing Requirements Ð Trailer Brakes
þ
Donotinterconnect the hydraulic brake system or
vacuum system of your vehicle with that of the trailer.
This could cause inadequate braking and possible
personal injury.
þAn electronically actuated trailer brake controller is
required when towing a trailer with electronically
actuated brakes. When towing a trailer equipped with
a hydraulic surge actuated brake system, an electronic
brake controller is not required.
þTrailer brakes are recommended for trailers over 1,000
lbs (450 kg) and required for trailers in excess of 2,000
lbs (907 kg).
CAUTION!
If the trailer weighs more than 1,000 lbs (450 kg)
loaded, it should have its own brakes and they
should be of adequate capacity. Failure to do this
could lead to accelerated brake lining wear, higher
brake pedal effort, and longer stopping distances.
WARNING!
Do not connect trailer brakes to your vehicle's hy-
draulic brake lines. It can overload your brake sys-
tem and cause it to fail. You might not have brakes
when you need them and could have an accident.
Towing any trailer will increase your stopping dis-
tance. When towing you should allow for additional
space between your vehicle and the vehicle in front
of you. Failure to do so could result in an accident.
Towing Requirements Ð Trailer Lights & Wiring
Whenever you pull a trailer, regardless of the trailer size,
stop lights and turn signals on the trailer are required for
motoring safety.
The Trailer Tow Package may includea4and7pin
wiring harness. Use a factory approved trailer harness
and connector.
NOTE:Do not cut or splice wiring into the vehicles
wiring harness.
224 STARTING AND OPERATING

WARNING!
Riding the brakes can lead to brake failure and
possibly an accident. Driving with your foot resting
or riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You wouldn't have your full
braking capacity in an emergency.
Brake And Power Steering System Hoses
When servicing the vehicle for scheduled maintenance,
inspect the surface of the hoses and nylon tubing for
evidence of heat and mechanical damage. Hard and
brittle rubber, cracking, tears, cuts, abrasions, and exces-
sive swelling suggest deterioration of the rubber. Particu-
lar attention should be made to examining those hose
surfaces nearest to high heat sources, such as the exhaust
manifold.
Inspect all hose clamps and couplings to make sure they
are secure and no leaks are present.
Insure nylon tubing in these areas has not melted or
collapsed.
NOTE:Often, fluids such as oil, power steering fluid,
and brake fluid are used during assembly plant opera-
tions to ease the assembly of hoses to couplings. There-
fore, oil wetness at the hose-coupling area is not neces-
sarily an indication of leakage. Actual dripping of hot
fluid when systems are under pressure (during vehicle
operation) should be noted before a hose is replaced
based on leakage.
NOTE:Inspection of brake hoses should be done
whenever the brake system is serviced and at every
engine oil change.
WARNING!
Worn brake hoses can burst and cause brake failure.
You could have an accident. If you see any signs of
cracking, scuffing, or worn spots, have the brake
hoses replaced immediately.
MAINTAINING YOUR VEHICLE 261
7

Brake Fluid........................... 280
Brake, Parking......................... 183
Brake System.......................185,260
Anti-Lock (ABS)....................86,186
Hoses.............................. 261
Master Cylinder...................... 262
Parking............................ 183
Warning Light....................... 117
Brakes............................185,260
Brake/Transmission Interlock.............. 177
Break-In Recommendations, New Vehicle...... 59
Bulb Replacement...................272,273
Bulbs, Light........................... 272
Calibration, Compass.................... 127
Capacities, Antifreeze (Engine Coolant)...... 278
Capacities, Fluid....................... 278
Caps, Filler
Fuel............................... 214
Oil (Engine)......................241,247
Car Washes........................... 266
Carbon Monoxide Warning............... 213
Cargo Area Cover....................... 98Cargo Area Features..................... 96
Cargo Compartment
Light............................... 96
Luggage Carrier...................... 102
Cargo Light............................ 96
Cargo Load Floor....................... 99
Cargo Tie-Downs........................ 99
Carrier, Luggage....................... 102
Catalytic Converter..................... 249
Caution, Exhaust Gas..................... 60
CD (Compact Disc) Player..........129,136,147
CD (Compact Disc) Player Maintenance...... 163
Cellular Phone......................... 163
Center High Mounted Stop Light........... 277
Chains, Tire........................... 209
Changing A Flat Tire.................... 230
Chart, Tire Sizing....................... 191
Check Engine Light (Malfunction Indicator
Light)............................... 243
Child Restraint......................... 52
Child Restraint Tether Anchors............. 56
Child Restraint with Automatic Belts......... 55
Child Safety Locks....................... 18
INDEX 309
10

Lumbar Support........................ 71
Maintenance Free Battery................. 251
Maintenance, General.................... 245
Maintenance Procedures.................. 245
Maintenance Schedule................... 282
Schedule ªAº........................ 294
Schedule ªBº........................ 285
Malfunction Indicator Light
(Check Engine)...................... 114,243
Manual, Service........................ 303
Manual Transaxle.................174,180,264
Downshifting........................ 182
Fluid Level Check..................264,265
Frequency of Fluid Change...........264,265
Lubricant Selection.................264,265
Map/Reading Lights..................... 77
Master Cylinder (Brakes)................. 262
Mirrors............................... 66
Electric Powered....................... 67
Outside............................. 66
Rearview............................ 66
Vanity.............................. 69Modifications/Alterations, Vehicle............ 6
Monitor, Tire Pressure System............. 206
Mopar Parts........................244,302
Multi-Function Control Lever............... 77
New Vehicle Break-In Period............... 59
Occupant Classification System (OCS)........ 43
Occupant Restraints (Sedan)................ 29
Octane Rating, Gasoline (Fuel)............. 211
Odometer............................. 114
Trip ............................. 114,115
Oil, Engine......................245,248,278
Capacity............................ 278
Change Interval...................... 246
Checking........................245,248
Disposal............................ 248
Filter.............................. 248
Materials Added to.................... 248
Recommendation..................247,278
Synthetic........................... 247
Viscosity............................ 247
Oil Pressure Light...................... 112
INDEX 315
10