bulb DODGE CALIBER 2011 1.G User Guide

▫Exhaust System ..................... 407
▫ Cooling System ..................... 409
▫ Brake System ....................... 415
▫ Automatic Transmission (CVT) –
If Equipped ........................ 417
▫ Manual Transmission – If Equipped ....... 418
▫ Appearance Care And Protection From
Corrosion .......................... 419
 Fuses .............................. 424
▫ Integrated Power Module .............. 424
 Vehicle Storage ....................... 428
 Replacement Bulbs .................... 429 
Bulb Replacement ..................... 429
▫ Front Headlamps, Parking, And Turn Signal
Lamps ............................ 429
▫ Fog Lamps ......................... 430
▫ Rear Tail, Turn Signal, And Backup Lamps . . 431
▫ License Lamps ...................... 433
▫ Center High-Mounted Stoplamp ......... 434
 Fluid Capacities ...................... 435
 Fluids, Lubricants, And Genuine Parts ....... 436
▫ Engine ............................ 436
▫ Chassis ........................... 437
392 MAINTAINING YOUR VEHICLE

persists, the message will appear the next time the
vehicle is started. This might indicate a damaged cap. If
the problem is detected twice in a row, the system will
turn on the MIL. Resolving the problem will turn the MIL
light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing. Normally, the OBD II system will be ready. The OBD II
system may
notbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:
1. Turn the ignition switch to the ON position, but do not
crank or start the engine.
2. If you crank or start the engine, you will have to start
this test over.
3. As soon as you turn the ignition switch to the ON
position, you will see the MIL symbol come on as part of
a normal bulb check.
396 MAINTAINING YOUR VEHICLE

REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
LIGHT BULBS – Interior Bulb Number
Front Header Lamp...................... T578
Center Dome Lamp ...................... T578
Rear Cargo/Flashlight ................. 8–A35LF
LIGHTS BULBS – Exterior Bulb Number
Low Beam/High Beam Headlamp ............ H13
Front Park/Turn Signal/Side Marker Lamp . . . 3157AK
Front Fog Lamp ...................... PSX24W
Center High-Mounted Stop Lamp
(CHMSL) ...................... LED Assembly
Rear Tail/Stop Lamp ..................... 3157
Rear Turn Signal Lamp .................3757AK
Backup Lamp ...................... 921 W16W
License Lamp .......................... W5W
BULB REPLACEMENT
Front Headlamps, Parking, and Turn Signal
Lamps
NOTE:The headlamp bulb can be accessed from under
the hood without the removal of the inner fender well. It
will be necessary to remove the inner fender well to
service the park/turn signal bulb that is located toward
the outboard side of the head lamp unit.
1. Disconnect and isolate the negative battery cable.
2. Working in the appropriate wheel well, loosen the
front of the splash shield, but do not fully remove it.
7
MAINTAINING YOUR VEHICLE 429

3. Looking up through the front wheel well, locate the
bulb which needs replacing. The headlamp bulb is the
inboard bulb and the park/turn signal bulb is the out-
board bulb.
4. Disconnect the bulb electrical connector.
5. Grasp the bulb, twist 1/4 turn counterclockwise and
pull straight out of front lamp unit.
Fog Lamps
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.1. Disconnect and isolate the negative battery cable.
2. Remove the front wheel and tire on the same side of
the vehicle as the fog lamp being serviced. Refer to
“Jacking and Tire Changing” in “What To Do In Emer-
gencies” for further information.
3. Remove the three screws that secure the outboard side
of the front wheel house splash shield to the front fascia.
4. Remove the push pin fastener that secures the inboard
side of the splash shield to the front end sheet metal.
5. Remove the two push pin fasteners that secure the
forward edge of the splash shield to the front fascia
closure panel.
430 MAINTAINING YOUR VEHICLE

6. Fold the front of the splash shield rearward far enough
to access the back of the front fascia.
7. From behind the front fascia disconnect the engine
compartment wire harness connector from the front fog
lamp bulb connector receptacle.
8. Firmly grasp the bulb by the two latch features and
squeeze them together to unlock the bulb from the back
of the front fog lamp housing.
9. Pull the bulb straight out from the keyed opening in
the housing.Rear Tail, Turn Signal, and Backup Lamps
1. Remove the two push-pins from the tail lamp housing.
7
MAINTAINING YOUR VEHICLE 431

2. Grasp the tail lamp and pull firmly to disengage the
lamp from the aperture panel.
NOTE:It is not necessary to completely remove the tail
lamp unit. Once loosened from the quarter panel, there
should be enough room to service any of the bulbs.
3. Disconnect the electrical connector from the bulb. 4. Twist and remove socket from the lamp.
432 MAINTAINING YOUR VEHICLE

5. Remove the bulb from the socket and replace.License Lamps
1. Using a trim stick or equivalent, gently pry on the side
of the license plate lamp to release it from the liftgate.
7
MAINTAINING YOUR VEHICLE 433

2. Rotate the socket 1/4 turn counterclockwise and re-
move from the lamp.
3. Pull the bulb from the socket.
Center High-Mounted Stoplamp
The lamp is an LED assembly. See your authorized dealer
for replacement.
434 MAINTAINING YOUR VEHICLE

Selection Of Lubricant................. 417
Special Additives ..................... 418
Automatic Transmission ................... 298
Gear Ranges ........................ 300
Autostick ............................. 302
B-Pillar Location ........................ 326
Battery ............................... 403
Keyless Transmitter Replacement (RKE) ..... 23
Belts, Seat .............................. 86
Beverage Cooler ........................ 182
Body Mechanism Lubrication ............... 405
Brake Assist System ...................... 314
Brake Fluid ............................ 437
Brake System ........................ 31 1,415
Anti-Lock (ABS) .................. 312,314
Master Cylinder ..................... 415
Parking ........................... 308 Warning Light
....................... 194
Brake, Parking .......................... 308
Brake/Transmission Interlock ............... 300
Brakes ............................. 31 1,415
Break-In Recommendations, New Vehicle ........ 84
Bulb Replacement ....................... 429
Bulbs, Light .......................... 88,429
Capacities, Antifreeze (Engine Coolant) ........ 435
Capacities, Fluid ........................ 435
Caps, Filler Fuel .............................. 354
Oil (Engine) ..................... 394,401
Power Steering ...................... 308
Car Washes ............................ 420
Carbon Monoxide Warning ...............85,353
Cargo Area Cover ....................... 176
Cargo Area Features ...................... 175
10
INDEX 467

Leaks, Fluid............................ 88
Life of Tires ............................ 337
Liftgate (Sedan) .......................... 35
Liftgate Window Wiper/Washer ............. 180
Light Bulbs .......................... 88,429
Lights .............................. 88,146
Airbag ...................... 67,73,86,193
Alarm ............................ 200
Anti-Lock .......................... 203
Back-Up ........................... 431
Brake Assist Warning .................. 319
Brake Warning ...................... 194
Bulb Replacement .................... 429
Cargo ............................. 175
Center Mounted Stop .................. 434
Dimmer Switch, Headlight .............. 146
Electronic Stability Program (ESP) Indicator . . 319
Engine Temperature Warning ............ 193
Exterior ............................ 88 Fog .........................
148,200,430
Headlight Switch ..................... 146
Headlights ......................... 146
High Beam Indicator .................. 204
Instrument Cluster ................... 146
License ............................ 433
Lights On Reminder .................. 147
Low Fuel .......................... 192
Malfunction Indicator (Check Engine) ...... 202
Map Reading ....................... 150
Oil Pressure ........................ 193
Seat Belt Reminder ................... 193
Security Alarm (Theft Alarm) ..........18,200
Service Engine Soon
(Malfunction Indicator) ................ 202
Theft Alarm (Security Alarm) ............ 200
Tire Pressure Monitoring (TPMS) ......... 201
Traction Control ..................... 319
Turn Signal ................. 88,146,148,431
474 INDEX