ABS DODGE TRUCK 1993 Service Repair Manual

•

EMISSION
CONTROL SYSTEMS
25 - 17
COMPONENT REMOVAL/INSTALLATION

INDEI

page

Air
Filter/Filter
Housing—Diesel Engines
17

Air
Filter/Filter
Housing—Gas Engines
17

Air
Injection
Pump
17

Air
Injection
Pump Relief Valve
18
Check
Valve—Air
Injection
Tube
18

Coolant Temperature
Sensor
. 18
EGR
Tube—Gas Powered Engines
19

EGR
Valve
19

AIR FILTER/FILTER HOUSING-GAS ENGINES
REMOVAL/INSTALLATION Remove crankcase breather/filter hose at side of air
filter housing. Remove wingnut (Fig. 1) and remove
housing from engine. Check condition of gasket at
throttle body and replace as necessary. To replace air filter element only: Remove wingnut
and air filter housing cover (Fig. 1). Clean inside of
housing before replacing filter. Housing removal is not necessary for filter replacement.
^
WING NUT

COVER
:

GASKET
| I
MOUNTING

STUD

Fig.
1 Air
Filter
Housing—Gas
Powered
Engines—Typical
page

Electric
EGR Transducer (EET)
20

EVAP
Canister
20

EVAP
Canister Purge Solenoid
20

Fuel Tank
Filler
Tube
Cap . 21

Oxygen
(02)
Sensor
21
Powertrain Control Module (PCM)
21

Pressure
Relief/Rollover Valve
21
If housing-to-throttle body mounting stud is being
installed, tighten to 10 N»m (90 in. lbs.) torque. In­ stall housing to engine and tighten wingnut to 1.5
N»m (15 in. lbs.) torque.

AIR FILTER/FILTER HOUSING-DIESEL ENGINES
REMO
VAL/INSTALLA
TION Remove the hose clamp at air filter housing (Fig.

2).
Remove mounting nuts and remove air filter
housing from vehicle.
To replace air filter element only: Remove hose clamp
and hose at air filter housing inlet tube. Remove three
wingnuts and air filter housing cover (Figs. 2 and 3). Clean inside of housing before replacing filter. Housing
removal is not necessary for filter replacement.
When installing a new air filter element, push el­
ement into cover. Be sure it is pushed into tabs in
back of filter housing. Install wing nuts.
If housing had been removed, install mounting
nuts and tighten to 10 N»m (95 in. lbs.) torque.

AIR INJECTION PUMP
REMOVAL (1) Remove the relief valve hose clamp (Fig. 4) and
remove hose at relief valve.
(2) Remove relief valve from air pump (two bolts)
(Fig. 4). (3) Loosen (but do not remove at this time) the
three air pump pulley mounting bolts (number 2—figure 4).
(4) Relax the automatic belt tensioner and remove
the engine accessory drive belt. Refer to Group 7, Cooling System. See Belt Removal/Installation.
(5) Remove the three air pump pulley bolts and re­
move pulley from pump.
(6) Remove the two air pump mounting bolts
(number
1—figure
4) and remove pump from mount­
ing bracket.