oil filter DODGE VIPER 2008 ZB II / 2.G Owners Manual

MAINTAINING YOUR VEHICLE
CONTENTS
m8.4L Engine Compartment................194
mOnboard Diagnostic System (OBD II).........195
mEmissions Inspection And Maintenance
Programs............................196
mReplacement Parts......................197
mDealer Service.........................198
mMaintenance Procedures..................198
NEngine Oil..........................198
NEngine Oil Filter......................201NDrive Belts Ð Check Condition And Tension . . 202
NSpark Plugs.........................203
NEngine Air Cleaner Filter................203
NFuel Filter..........................204
NCatalytic Converter....................204
NIgnition Wiring System And Ignition
Timing.............................205
NCrankcase Emission Control System........206
NMaintenance-Free Battery................206
7

The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to the ªEngine Com-
partmentº illustration in this section.
Materials Added to Engine Oil
The manufacture strongly recommends against the addi-
tion of any additives (other than leak detection dyes) tothe engine oil. Engine oil is an engineered product and its
performance may be impaired by supplemental addi-
tives.
Disposing of Used Engine Oil and Oil Filters
Care should be taken in disposing of used engine oil and
oil filters from your vehicle. Used oil and oil filters,
indiscriminately discarded, can present a problem to the
environment. Contact your dealer, service station, or
governmental agency for advice on how and where used
oil and oil filters can be safely discarded in your area.
Engine Oil Filter
The engine oil filter should be replaced with a new filter
at every engine oil change.
Engine Oil Filter Selection
This manufacturer's engines have a full-flow type oil
filter. Use a filter of this type for replacement. The quality
of replacement filters varies considerably. Only high
MAINTAINING YOUR VEHICLE 201
7

quality filters should be used to assure most efficient
service. MopartEngine Oil Filters are a high quality oil
filter and are recommended.
Drive Belts Ð Check Condition and Tension
Belt tension is controlled by means of an automatic
tensioner. Therefore, no belt tension adjustments are
required. However, belt and belt tensioner condition
should be inspected at the specified intervals and re-
placed if required. Improper belt tension can cause belt
slippage and failure. Low generator belt tension can
cause battery failure.
At the intervals indicated on the ªMaintenance Sched-
ules,º inspect belt and belt tensioner condition. Inspect
belts for evidence of cuts, cracks, glazing, or frayed cords
and replaced if there is indication of damage, which could
result in belt failure. Also, check belt routing to make sure
there is no interference between the belts and other engine
components. See your authorized dealer for service.8.4L ACCESSORY BELT ROUTING
1 Ð Alternator
2 Ð Tensioner
3 Ð Water Pump
4 Ð Power Steering Pump
5 Ð A/C Compressor
6Ð Routing for Non-A/C Applications 202 MAINTAINING YOUR VEHICLE

HEADLIGHT AIMING
The headlights on your new vehicle were aimed at the
factory under a no load setting. A great increase in weight
will change the aiming of the headlights. Therefore, it
may be necessary to readjust the headlights if you
typically carry an excessive amount of weight in the rear
compartment or generally suspect misalignment. In ei-
ther case, see your authorized dealer if the headlights
require adjustment.
FLUIDS AND CAPACITIES
U.S. Metric
Fuel (approximate)
8.4 Liter Engine 16 gal-
lons60.6 li-
ters
Engine Oil-With Filter
8.4 Liter Engine (SAE 0W-40) 10 qts. 9.5 Li-
ters
Cooling System *
8.4 Liter Engine* (Mopart
Antifreeze/Coolant 5 Year/
102,000 Mile Formula) or
equivalent.16 qts. 15 Liters
* Includes heater and coolant recovery bottle filled to
MAX level.
MAINTAINING YOUR VEHICLE 251
7

FLUIDS, LUBRICANTS, AND GENUINE PARTS
Engine
Component Fluids, Lubricants, and Genuine Parts
Engine Coolant MopartAntifreeze/Coolant 5 Year/102,000 Mile Formula HOAT (Hybrid Or-
ganic Additive Technology) or equivalent.
Engine Oil For best performance and maximum protection under all types of operating
conditions, the manufacturer only recommends full synthetic engine oils that
meet the American Petroleum Institute (API) categories of SM or SM/CF, and
meet the requirements of DaimlerChrysler Material Standard MS-10725. The
manufacturer recommends the use of a full synthetic engine oil, such as Mobil
1tSAE 0W-40 or equivalent. For additional information, refer to the ªEngine
Oil Selectionº and ªEngine Oil Viscosity (SAE Grade)º in the ªMaintenance
Proceduresº section of this manual.
Engine Oil Filter MopartEngine Oil Filter or equivalent.
Spark Plugs RE10PMC5 (Gap.050)
Fuel Selection Premium Unleaded 91 Octane Only or higher
252 MAINTAINING YOUR VEHICLE

At Each Stop for Fuel
²Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
²Check the windshield washer solvent and add if
required.
Once a Month
²Check tire pressure and look for unusual wear or
damage.
²Inspect the battery, and clean and tighten the terminals
as required.
²Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering, and transmission,
and add as needed.
²Check all lights and all other electrical items for correct
operation.
At Each Oil Change
²Change the engine oil filter.
²Inspect the exhaust system.
NOTE:Also, inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
²Inspect the brake hoses.
²Inspect the suspension components.
²Lubricate door hinges and check springs.
²Check the engine coolant level, hoses, and clamps.
²Check power steering fluid level.
258 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 3,000 6,000 9,000 12,000 15,000 18,000
(Kilometers) (5 000) (10 000) (15 000) (20 000) (25 000) (30 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXX X
Rotate the tires.LLXX X
Inspect and replace theair cleaner filterif
necessary.X
Inspect the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball
joints.X
260 SCHEDULE ªBº
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 21,000 24,000 27,000 30,000 33,000 36,000
(Kilometers) (35 000) (40 000) (45 000) (50 000) (55 000) (60 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXX X
Rotate the tires.LLXX X
Inspect and replace theair cleaner filterif
necessary.X
Inspect and replace thePCV valveif neces-
sary.X
Change the transmission fluid. X
Inspect the transmission fluid.X
Inspect the brake linings. X X
Change the rear axle fluid. X X
Change the brake and clutch fluid. X
Change the brake fluid.X
Lubricate the front and rear suspension ball
joints.X
SCHEDULE ªBº 261
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 39,000 42,000 45,000 48,000 51,000 54,000
(Kilometers) (65 000) (70 000) (75 000) (80 000) (85 000) (90 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXX X
Rotate the tires.LLXX X
Inspect and replace theengine air cleaner fil-
terif necessary.X
Inspect and replace the Auto Tension Drive
Belt if necessary.X
Change the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake and clutch fluid. X
Lubricate the front and rear suspension ball
joints.X
262 SCHEDULE ªBº
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 57,000 60,000 63,000 66,000 69,000 72,000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Changeengine oilandengine oil filter,if not re-
placed at 3 months.XXXXXX
Rotate the tires.LL
XXX
Inspect and replace theair cleaner filterif necessary.
X
Inspect and replace thePCV valveif necessary.
X
Flush and replace engine coolant at 60 months, if
not done at 102,000 miles.X
Inspect and replace the Auto Tension Drive Belt if
necessary. ³X
Inspect the transmission fluid.
X
Change the transmission fluid.X
Inspect the brake linings. X X
Change the rear axle fluid. X X
Change the brake fluid. X
Change the brake and clutch fluid.X
Lubricate the front and rear suspension ball joints. X
SCHEDULE ªBº 263
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S