suspension DODGE VIPER 2010 ZB II / 2.G Owners Manual

Change Clutch Fluid
Clutch fluid will tend to absorb moisture from the
atmosphere over time. If the fluid becomes contaminated
with water, clutch performance will deteriorate. There-
fore, the clutch fluid must be changed at the intervals
specified in “Maintenance Schedule.” Refer to “Mainte-
nance Schedule” for further information. See your autho-
rized dealer for service.
Rear Axle
Axle Lubricant Level Check
Check the exterior of the axle for evidence of gear oil
leakage every 12 months or 6,000 miles (10 000 km). This
check should be made with the vehicle level and sup-
ported by the suspension, with the vehicle on the ground
or raised on an axle and wheel type hoist. The axle
lubricant level should be between the bottom of the filler
plug and a point approximately 3/8 in (9.5 mm) below
the filler plug. If adding axle lubricant, use only themanufacturer’s recommended axle lubricant. Refer to
“Fluids, Lubricants, and Genuine Parts” in “Maintaining
Your Vehicle” for further information.
NOTE:
The Limited Slip Differential requires that a
friction control additive be added when draining and
refilling the axle lubricant.
Change Axle Lubricant
Refer to “Maintenance Schedule” for the proper mainte-
nance intervals. Change the lubricant immediately if
contaminated with water. See your authorized dealer for
service.
Appearance Care and Protection from Corrosion
Protection of Body and Paint from Corrosion
Vehicle body care requirements vary according to geo-
graphic locations and usage. Chemicals that make roads
7
MAINTAINING YOUR VEHICLE 237

At Each Stop for Fuel
•Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once a Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery, and clean and tighten the terminals
as required.
•Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering, and transmission,
and add as needed.
•Check all lights and all other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the exhaust system.
NOTE: Also, inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
•Inspect the brake hoses.
•Inspect the suspension components.
•Lubricate door hinges and check springs.
•Check the engine coolant level, hoses, and clamps.
•Check power steering fluid level.
8
M A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S266 MAINTENANCE SCHEDULES

Miles3,000 6,000 9,000 12,000 15,000 18,000
(Kilometers) (5 000) (10 000) (15 000) (20 000) (25 000) (30 000)
Change engine oil and engine oil filter, if not
replaced at 3 months. XXXXX X
Rotate the tires.\b\b XX X
Inspect and replace the air cleaner filter, if
necessary. X
Inspect the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball
joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S268 MAINTENANCE SCHEDULES

Miles21,000 24,000 27,000 30,000 33,000 36,000
(Kilometers) (35 000) (40 000) (45 000) (50 000) (55 000) (60 000)
Change engine oil and engine oil filter, if not
replaced at 3 months. XXXXX X
Rotate the tires.\b\b XX X
Inspect and replace the air cleaner filter, if
necessary. X
Inspect and replace the PCV valve, if neces-
sary. X
Change the transmission fluid. X
Inspect the transmission fluid. X
Inspect the brake linings. XX
Change the rear axle fluid. XX
Change the brake and clutch fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball
joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 269

Miles39,000 42,000 45,000 48,000 51,000 54,000
(Kilometers) (65 000) (70 000) (75 000) (80 000) (85 000) (90 000)
Change engine oil and engine oil filter, if not
replaced at 3 months. XXXXX X
Rotate the tires.\b\b XX X
Inspect and replace the engine air cleaner fil-
ter, if necessary. X
Inspect and replace the auto tension drive
belt, if necessary. X
Change the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake and clutch fluid. X
Lubricate the front and rear suspension ball
joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S270 MAINTENANCE SCHEDULES

Miles57,000 60,000 63,000 66,000 69,000 72,000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Change the transmission fluid. X
Inspect the brake linings. XX
Change the rear axle fluid. XX
Change the brake fluid. X
Change the brake and clutch fluid. X
Lubricate the front and rear suspension ball
joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S272 MAINTENANCE SCHEDULES

Miles75,000 78,000 81,000 84,000 87,000 90,000
(Kilometers) (125 000) (130 000) (135 000) (140 000) (145 000) (150 000)
Change engine oil and engine oil filter, if not
replaced at 3 months. XXXXX X
Rotate the tires.\b\b XX X
Inspect and replace the air cleaner filter, if
necessary. XX
Inspect and replace the PCV valve, if neces-
sary. X
Inspect and replace the auto tension drive
belt, if necessary.‡ XX
Inspect the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball
joints. XX
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 273

Miles93,000 96,000 99,000 102,000 105,000 108,000
(Kilometers) (155 000) (160 000) (165 000) (170 000) (175 000) (180 000)
Inspect the transmission fluid. X
Inspect the brake linings. XX
Change the rear axle fluid. XX
Change the brake and clutch fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball
joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 275

Miles111,000 114,000 117,000 120,000
(Kilometers) (185 000) (190 000) (195 000) (200 000)
Change the rear axle fluid. X
Change the brake and clutch fluid. X
Lubricate the front and rear suspension ball joints. X
‡ This maintenance is not required if previously replaced.
\b\b Although not required, the manufacturer recom-
mends reprogramming TPMS after rotating tires so sys-
tem can relearn tire pressure sensor location. Refer to
“Tire Pressure Monitor System (TPMS)” in “Starting and
Operating” for further information. Inspection and service should also be performed anytime
a malfunction is observed or suspected. Retain all
receipts.
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 277

MAINTENANCE SCHEDULE A
Miles6,000 12,000 18,000 24,000 30,000
(Kilometers) (10 000) (20 000) (30 000) (40 000) (50 000)
[Months] [6] [12] [18] [24] [30]
Change engine oil and engine oil filter. XX X X X
Rotate the tires.\b\b X XXXX
Inspect and replace the engine air cleaner filter, if
necessary. X
Inspect the transmission fluid. XX
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball joints. X
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S278 MAINTENANCE SCHEDULES