fuse DODGE VIPER 2015 VX / 3.G User Guide

Cavity Relay Cartridge
Fuse
Mini-Fuse Description
48 — — 10 Amp Red SCCM
49 — — 25 Amp
Clear
Amplifier
50 HC Micro — — Rad Fan
51 HC Micro — — Rad Fan Relay SER/PAR
52 HC Micro — — Starter Relay
53 HC Micro — — Rear Window Defroster Relay
54 HC Relay — — Rad Fan Relay High
55 HC Micro — — Wiper ON/OFF
56 HC Micro — — Wiper LO/HI
57 G8VA — — Horn Relay
58 G8VA — — A/C Clutch Relay
59 HC Micro — — HVAC Blower
60 HC Micro — — Fuel Pump
7
MAINTAINING YOUR VEHICLE 349

Cavity Relay Cartridge
Fuse
Mini-Fuse Description
61 G8VA — — Run Relay #1
62 G8VA — — Run Relay #2
63HC Micro ——ASD #1
64HC Micro ——ASD #2
65G8VA ——Run Accy #1, Pop Up, Driver Door Window Switch
NOTE:A 15 Amp fuse for the radio system is located
in-line at the battery positive terminal.CAUTION!
•When installing the power distribution center
cover, it is important to ensure the cover is properly
positioned and fully latched. Failure to do so may
allow water to get into the power distribution
center and possibly result in an electrical system
failure.
(Continued)
350 MAINTAINING YOUR VEHICLE

CAUTION!(Continued)
•When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
VEHICLE STORAGE
We recommend that you follow these guidelines for
storing your vehicle for extended periods.
•Fill the fuel tank. This will prevent water condensation
inside the tank. If you plan to store your vehicle more
than two months, add an anti-oxidant fuel stabilizer to
the fuel tank.
•Change the oil to remove any corrosive combustion
related acids in the crankcase.
•Check that the radiator coolant level of protection is to
at least -20°F (-29°C).
•Make sure that all tires are inflated to the optimum
pressure.
•Wash and wax the vehicle to protect the finish.
•Store the vehicle in a dry, well-ventilated location.
•Move the wiper blades away from the windshield.
•Block the wheels. Do not apply the parking brake.
•Cut blocks of plywood about the same size of the tires.
Cover each block with indoor/outdoor carpeting and
place them between the tires and concrete. This will
prevent tire flat spotting.
•For long-term storage, remove the tires and put the
vehicle up on blocks. Stack the tires on plywood and
cover with a tarp to prevent flat spotting.
7
MAINTAINING YOUR VEHICLE 351

Fluid Capacities..........................357
Fluid Leaks..............................85
Fluid Level Checks
Brake................................333
Capacities............................357
Clutch Fluid...........................335
Cooling System.........................327
Engine Oil............................315
Manual Transmission....................335
Power Steering.........................236
Fluids, Lubricants And Genuine Parts...........358
Four-Way Hazard Flasher...................290
Freeing A Stuck Vehicle.....................307
Fuel...................................277
Additives.............................280
Clean Air.............................278
Ethanol..............................278
Filler Door (Gas Cap)....................149
Gasoline..............................277
Gauge...............................149
Materials Added........................280
Methanol.............................278
Octane Rating..........................277
Requirements..........................277
Tank Capacity..........................357
Fuses..................................342
Garage Door Opener (HomeLink®)............120
Gasoline, Clean Air........................278
Gasoline (Fuel)...........................277
Gasoline, Reformulated.....................278
Gauges
Fuel.................................149
Speedometer..........................144
Tachometer............................148
General Information.......................196
Glass Cleaning...........................339
10
INDEX 385

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.