phone DODGE VIPER 2015 VX / 3.G Owner's Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2015, Model line: VIPER, Model: DODGE VIPER 2015 VX / 3.GPages: 400, PDF Size: 9.59 MB
Page 384 of 400

Radiator (Coolant Pressure)................330
Carbon Monoxide Warning...................82
Car Washes.............................337
Cellular Phone...........................196
Chains, Tire.............................270
Chart, Tire Sizing.........................249
Check Engine Light (Malfunction Indicator Light) . .151
Checking Your Vehicle For Safety...............82
Checks, Safety............................82
Child Restraint............................70
Child Restraints
Booster Seats...........................75
Child Restraints.........................70
Infants And Child Restraints................73
Installing Child Restraints Using The Vehicle Seat
Belt..................................76
Older Children And Child Restraints..........73
Using The Top Tether Anchorage.............78
Clean Air Gasoline........................278
Cleaning
Wheels...............................338
Windshield Wiper Blades..................323
Climate Control..........................196
Clutch Fluid.............................335
Compact Spare Tire........................265
Contract, Service..........................373
Coolant Pressure Cap (Radiator Cap)...........330
Cooling System...........................326
Adding Coolant (Antifreeze)...............328
Coolant Capacity.......................357
Coolant Level..........................327
Disposal Of Used Coolant.................330
Drain, Flush, And Refill...................327
Inspection............................331
Points To Remember.....................331
Pressure Cap..........................330
Radiator Cap..........................330
Selection Of Coolant (Antifreeze)............328
382 INDEX
Page 399 of 400

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.