run flat FIAT 500L LIVING 2019 Owner handbook (in English)

7-seater versions
With third row of rear seats folded:
place the punctured tyre in the luggage
compartment, above the backrests.
With third row of rear seats not
folded: remove the luggage-covering
curtain (which must be positioned
in front of second row of seats) then
place the punctured tyre in the luggage
compartment, positioning it as shown
in fig. 118 (wheel hub facing the inside
of the passenger compartment in
order to prevent the wheel from falling
when closing the tailgate).
REFITTING THE
STANDARD WHEEL
Versions with steel wheels
make sure the contact surfaces
between standard wheel and hub are
clean and free from impurities so that
the fixing stud bolts will not come
loose;
fit the standard wheel inserting the 5
stud bolts into the holes;
press-fit the wheel cap, aligning the
special splining (on the cap) with the
inflation valve;
using the spanner provided, tighten
the fixing stud bolts;
lower the car and remove the jack;
using the spanner provided, fully
tighten the stud bolts in the sequence
shown previously.
Versions with alloy rims
insert the wheel on the hub and
using the spanner provided tighten the
stud bolts;
lower the car and remove the jack;
using the spanner provided, fully
tighten the 5 stud bolts in the sequence
shown;
reinstall the hub cap, taking care to
position the three plastic pins in the
dedicated seats on the wheel. Slightly
press the cap to prevent any damage
to the plastic pins.
IMPORTANT If it is not fitted correctly,
the hub cap may detach when the
vehicle is running.
At the end of the operation
Proceed as follows:
stow the space-saver wheel in the
compartment provided in the boot;
place the jack and the other tools in
their container;
arrange the container and tools on
the space-saver wheel;
correctly reposition the boot mat.
WARNING
115)It is extremely dangerous to attempt
to change a wheel on the side of the
vehicle next to the driving lane: make sure
that the vehicle is at a sufficient distance
from the road, to avoid being run over.
117F0Y0361C118F0Y0368C
126
IN AN EMERGENCY

JUMP STARTING
If the battery is flat, a jump starting can
be performed using the battery and
the cables of another car, or using an
auxiliary battery. In all cases, the battery
used must have a capacity equal to or
a little higher than the flat one.
IMPORTANT NOTES
When a booster battery is used, comply
with the utilisation and precaution
instructions specified by the producer.
Do not use the booster battery or
any other source of external supply with
a voltage above 12 V: the battery, the
starter, the alternator and the electrical
system of the vehicle could be
damaged.
Do not attempt jump starting if the
battery is frozen. The battery could
break and explode!
JUMP STARTING
136) 137) 138) 139)56) 57)
IMPORTANT The positive terminal (+) of
the battery is shielded by a protective
cover. Lift the cover to access the
positive terminal.
Proceed as follows:
engage the handbrake, move the
Dualogic gear lever to N (Neutral) or, for
versions with manual gearbox, to
neutral and bring the ignition key to
STOP.
switch off all the other electrical
devices in the car;
if another vehicle is ready for jump
starting, park the vehicle within the
reach of the cables to be used for
starting, operate the handbrake and
make sure that the ignition is
deactivated.
IMPORTANT Avoid contact between
the two vehicles since this could cause
a connection to earth and may result
in serious injury to any people nearby.
IMPORTANT Do not directly connect
the negative terminals of the two
batteries: sparks could ignite explosive
gas released from the battery. If the
auxiliary battery is installed on another
car, prevent accidental contact
between metallic parts of the two cars.
JUMP STARTING
IMPORTANT If the procedure below is
carried out incorrectly, it can cause
severe injury to people or damage the
recharging system of one or both
vehicles. Carefully follow the
instructions given below.Cable connection
Proceed as follows to carry out a jump
starting:
connect one end of the cable used
for positive (+) to the positive terminal
(+) of the car with flat battery;
connect the other end of the cable
used for positive (+) to the positive
terminal (+) of the auxiliary battery;
connect one end of the cable used
for negative (–) to the negative terminal
(–) of the auxiliary battery;
connect the other end of the cable
used for negative (–) to an engine earth
(the visible metal part of the car engine
with flat battery) far from the battery
and the fuel injection system;
start the vehicle engine with the
auxiliary battery, let it run for a few
minutes at idling. Start the engine of the
vehicle with flat battery.
Cable disconnection
Once the engine has been started,
remove the cables proceeding as
follows:
disconnect the end of the cable
used for negative (–) from the engine
earth of the car with flat battery;
144
IN AN EMERGENCY

-Size child restraint systems........89
..................171
Ignition device.......................14
Important information and
recommendations...............233
Interior lights........................27
ISOFIX child restraint system
(installation).......................87
iTPMS..............................75
Jack..............................123
Jump starting......................144
Key with remote control.............12
Keys................................12
Lane Change.......................26
Lifting the car
Luggage compartment..............37
Luggage compartment fusebox.....141
Main beam headlights
(activation)........................26
Main beam headlights
(bulb replacement)...............133
Manual climate control system.......22
Manual transmission...............105
Mechanical key......................12
Mode Selector (device).............111
Mopar Connect....................231
Nozzles (windscreen / rear
window washer).................166
Number plate lights (bulb
replacement)....................137
Occupant protection systems.......78
Official type approvals..............232
Parking sensors...................114
Passenger front airbag...............96
Performance (top speed)...........183
Periodic checks
(scheduled servicing).............149
Pre-tensioners......................80
Prescriptions for handling the car
at the end of its life..............199
Rain sensor........................29
Rear Backup camera...............116
Rear seats..........................16
Rear view mirrors....................19
Rear window wiper / washer.........29
Rear window wiper blade
(replacement)....................166
Refuelling..........................193
Refuelling the vehicle...............118
Rims and tyres provided............175
Safe Lock (device)..................13
SBR (Seat Belt Reminder)............80
Scheduled Servicing...............149
Seat belts...........................78
Seats...............................15
Service schedule...................150
Setup menu.........................44
Side bag...........................99
Side bags...........................99Side direction indicators
(bulb replacement)...............134
Side lights / dipped beam
headlights (activation).............25
Side lights/daytime running lights
(DRL) (bulb replacement).........134
Snow chains.......................175
Speed Limiter......................110
Start&Stop (system)................108
Starting the engine.................103
Steering lock........................14
Steering wheel......................19
Supplementary Restraint System
(SRS) - Airbag....................95
Third brake light
(light replacement)...............137
Third-row rear seats.................16
Tips, controls and general
information......................201
Towing the vehicle..................146
Towing trailers.....................117
Traction + system..................112
Trip Computer.......................45
Tyre inflation pressure..............178
Uconnect™ 5" LIVE...............203
Uconnect™ 7" HD LIVE /
Uconnect™ 7" HD Nav LIVE.....215
Use of the Owner Handbook..........4
Warning lights and messages.......46
Weights...........................186
INDEX
I
Identification data
........................167