oil filter FIAT BARCHETTA 2003 1.G Owners Manual

114
(*) Or every 3 years for heavy duty uses (cold-hot climates, long idling urban use, use on roads that are specially dusty or covered with sand and/or salt)
Or every 5 years independently from mileage.
Thousands of km
çç
çç ç ç
çççç ççççç
çç
ç
çç ç ç
çç ç ç
çç
çççç ççççç
çççç ççççç
ççç
çççç ççççç
çççç ççççç
20 40 60 80 100 120 140 160 180
Check evaporation system
Replace air cleaner cartridge
Top up fluid level (engine coolant, brakes, windscreen washer,
battery, etc.)
Check timing belt conditions
Replace timing belt (*)
Replace spark plugs
Check engine control systems (via diagnostic socket)
Check gearbox/differential oil level
Change engine oil
Replace engine oil filter
Change brake fluid (or every two years)
Replace pollen filter (or every year)
Top: check opening/closing operation and lubricate joints,
visually inspect seals, check adherence of windows with top
seal and adjust, if required

115
ANNUAL
INSPECTION
SCHEDULE
The following annual inspection
schedule is required for cars travelling
less than 20,000 km a year (e.g. ap-
proximately 10,000 km). The schedule
includes the following operations:
– Check tyre condition and wear and
adjust pressure, if required (including
spare-saver spare wheel).
– Check operation of lights (head-
lights, direction indicators, hazard
lights, boot light, passenger compart-
ment ceiling light, glove compartment
light, instrument panel lights, etc.).
– Check windscreen wiper/washer
and adjust nozzles.
– Check position wear of windscreen
window wiper blades.
ADDITIONAL
OPERATIONS
Every 1,000 kmor before long
trips, check and top up as necessary:
– coolant level
– brake fluid level
– power steering fluid level
– electrolyte level
– windscreen washer liquid level
– tyre condition and pressure.
We advise you to use FL Selenia
products, which have been designed
and produced expressly for the Fiat
vehicles (see the table “Capacities” giv-
en in the “Technical specifications”
section).
Every 3,000 km check and top up
as necessary: engine oil level. – Check rear brake pad conditions
and wear.
– Inspect conditions of. engine, gear-
box, transmission, piping (exhaust - fu-
el feed - brakes), rubber parts (boots
- sleeves - bushings - etc.), brake and
fuel line hoses.
– Check battery charge status.
– Check conditions of various con-
trol belts.
– Check and top up fluid levels (en-
gine coolant, brakes, windscreen
washer, battery, etc.).
– Change engine oil.
– Replace engine oil filter.
– Replace pollen filter (where fitted).

116
This check should be carried out
more frequently if the vehicle is main-
ly used for short trips, or if it is fitted
with accessories that permanently ab-
sorb electricity even with the ignition
key removed, especially in the case of
after market accessories.
You should check the battery fluid
(electrolyte) level more frequently
than shown in the Service Schedule if
the car is used in hot climates or par-
ticularly demanding conditions. IMPORTANT - Engine oil
Change the engine oil more fre-
quently than specified in the Service
Schedule if the vehicle is mainly used
under one of the following particular-
ly severe conditions:
– towing a trailer or caravan
– on dirt roads
– short, repetitive trips (less than 7
or 8 kilometres) in outside tempera-
tures below zero.
– engines that are frequently left to
idle or drive slowly over long dis-
tances.
IMPORTANT - Air cleaner
If you drive your car on dirt roads
change the air cleaner more frequently
than specified in the Service Schedule.If you are in doubt about how often
the engine oil or the air cleaner should
be changed in relation to how you use
the car, contact a Fiat Dealership.
IMPORTANT - Pollen filter
If the car is often used in dusty or ex-
tremely polluted environments, you
should change the filter element more
frequently. It should be changed espe-
cially if the amount of air introduced
into the passenger compartment is re-
duced.
IMPORTANT - Battery
You should check the status of the
battery charge preferably at the be-
ginning of the cold season to avoid the
possibility of the electrolyte freezing.Maintenance of your car
should be entrusted to a
Fiat Dealership. For in-
terventions of routine mainte-
nance and small repairs you wish
to carry out yourself, make sure
you always have the proper
equipment, genuine Fiat spare
parts and fluids available. Do not,
carry out these operations if you
have no experience.

119
Used engine oil and re-
placed oil filters contain
substances that can harm
the environment. We recom-
mend you have the car seen to at
a Fiat Dealership for the oil and
filter change. It is suitably
equipped for disposing of used oil
and filters in an environmentally-
friendly way that complies with
the law.ENGINE COOLANT SYSTEM
fig. 3If there is not enough coolant, pour
a 50-50 mixture of distilled water and
a PARAFLU
11liquid of FL Selenia
slowly through the filler hole in the
reservoir.
A 50-50 mixture of PARAFLU
11
and distilled water gives freeze pro-
tection to –35° C. Do not add oil with dif-
ferent specifications from
the oil already in the en-
gine.
IMPORTANT After adding or
changing the oil, let the engine turn
over for a few seconds and wait a few
minutes after turning it off before you
check the level.
fig. 3
P5S00613m
The coolant level must be checked
while the engine is cold and must not
be below the MINmark on the reser-
voir.
Do not take the cap of the
reservoir off when the en-
gine is very hot as you run the risk
of scalding yourself.
WARNING
The cooling system is under
pressure. When changing
the cap, use only genuine spare
parts to avoid damaging the sys-
tem.
WARNING

138
FUEL SUPPLY/IGNITION
Integrated electronic injection and ig-
nition system: a single electronic con-
trol unit controls both functions. It
processes both the time the injection
lasts (for fuel metering) and the igni-
tion’s advance angle.
Type: Sequential in phase Multipoint
Air cleaner: dry-type with paper fil-
ter element; thermostatically con-
trolled intake.
Petrol pump: in-tank.
Injection pressure: 3 bar
Method of measuring the amount of
aspirated air by directly measuring the
maximum rate of flow with a hot wire
air flow meter.
“Closed loop” petrol metering (in-
formation about combustion provid-
ed by the Lambda sensor).Firing order: 1-3-4-2
Spark plugs:
– Champion RC10YCC
– NGK BKR6EZLUBRICATION
Forced-fed with gear pump with
pressure relief valve incorporated.
Oil purification by means of full-flow-
cartridge filter.
COOLING
Cooling system with radiator, cen-
trifugal pump and expansion tank.
“Controlled” by-pass type thermo-
stat on the secondary circuit for the
recirculation of water from the engine
to the radiator.
Electric fan for radiator cooling with
thermostatically-controlled on/off
switch on the radiator.
Modifications or repairs to
the fuel feed system that
are not carried out properly or do
not take the system’s technical
specifications into account can
cause malfunctions with the risk of
fire.
WARNING

160
Engine coolant level................... 119
Engine coolant temperature
gauge ......................................... 29
Engine oil
– checking the level ............... 118
– engine oil consumption ..... 118
– specifications........................ 145
EOBD system ............................ 62
Evaporation system ................... 66
Fiat CODE system .................. 11
First aid kit .................................. 110
Front fog lights
– bulb replacement ............... 94
– controls................................. 41
Fuel
– consumption ........................ 147
– fuel cut-off switch ............... 41
– level gauge ............................ 29
– filler cap ................................ 65
Full-beam headlights
– bulb replacement ............... 94
– flashing................................... 39
– controls................................. 38
Fuses ............................................. 98
Gearbox
– using the gearbox ............... 71
Getting to know your car.6
Glove compartment light ......... 98
Glove compartment .................. 42
Handbrake......................... 70-139
Hard top .............................. 49-155
Hazard lights ............................... 40
Head restraints........................... 19
Headlights
– beam slant ............................ 55
– front fog light slant ............. 55
Heating and ventilation............. 34
Hood .................................... 46-133
Identification data .................... 136
If an accident occurs ................. 109
In an emergency.................. 83
Instrument panel ........................ 8
Instruments ................................ 28
Jack ............................................. 88
Jacking the car ............................ 106
Keys ........................................... 11
Kilometre counter..................... 28
Lambda sensor ......................... 66
Lubricants .................................... 145
Mileometer ............................. 28
Number plate lights................ 97
Oddment compartment ........ 42
Paintwork ................................. 137
Parking lights (PARK)................ 17
Parking .......................................... 70
Performance................................ 140
Plates
– identification data ............... 136
– paint identification .............. 137
Pollen filter ................................. 123
Power steering fluid level ........ 120
Pretensioners.............................. 27
Radio transmitters .............. 82
Radio-frequency remote
controls ................................ 15